To date, more than 7300 in situ stress orientations have been compiled as part of the World Stress Map project. Of these, over 4400 are considered reliable tectonic stress indicators, recording horizontal stress orientations to within <±25°. Remarkably good correlation is observed between stress orientations deduced from in situ stress measurements and geologic observations made in the upper 1–2 km, well bore breakouts extending to 4–5 km depth and earthquake focal mechanisms to depths of ∼20 km. Regionally uniform stress orientations and relative magnitudes permit definition of broad-scale regional stress patterns often extending 20–200 times the approximately 20–25 km thickness of the upper brittle lithosphere. The “first-order” midplate stress fields are believed to be largely the result of compressional forces applied at plate boundaries, primarily ridge push and continental collision. The orientation of the intraplate stress field is thus largely controlled by the geometry of the plate boundaries. There is no evidence of large lateral stress gradients (as evidenced by lateral variations in stress regime) which would be expected across large plates if simple resistive or driving basal drag tractions (parallel or antiparallel to absolute motion) controlled the intraplate stress field. Intraplate areas of active extension are generally associated with regions of high topography: western U.S. Cordillera, high Andes, Tibetan plateau, western Indian Ocean plateau. Buoyancy stresses related to crustal thickening and/or lithospheric thinning in these regions dominate the intraplate compressional stress field due to plate-driving forces. These buoyancy forces are just one of several categories of “second-order” stresses, or local perturbations, that can be identified once the first-order stress patterns are recognized. These second-order stress fields can often be associated with specific geologic or tectonic features, for example, lithospheric flexure, lateral strength contrasts, as well as the lateral density contrasts which give rise to buoyancy forces. These second-order stress patterns typically have wavelengths ranging from 5 to 10+ times the thickness of the brittle upper lithosphere. A two-dimensional analysis of the amount of rotation of regional horizontal stress orientations due to a superimposed local stress constrains the ratio of the magnitude of the horizontal regional stress differences to the local uniaxial stress. For a detectable rotation of 15°, the local horizontal uniaxial stress must be at least twice the magnitude of the regional horizontal stress differences. Examples of local rotations of SHmax orientations include a 75°–85° rotation on the northeastern Canadian continental shelf possibly related to margin-normal extension derived from sediment-loading flexural stresses, a 50°–60° rotation within the East African rift relative to western Africa due to extensional buoyancy forces caused by lithospheric thinning, and an approximately 90° rotation along the northern margin of the Paleozoic Amazonas rift in central Brazil. In this final example, this rotation is hypothesized as being due to deviatoric compression oriented normal to the rift axis resulting from local lithospheric support of a dense mass in the lower crust beneath the rift (“rift pillow”). Estimates of the magnitudes of first-order (plate boundary force-derived) regional stress differences computed from modeling the source of observed local stress rotations magnitudes can be compared with regional stress differences based on the frictional strength of the crust (i.e., “Byerlee's law”) assuming hydrostatic pore pressure. The examples given here are too few to provide a definitive evaluation of the direct applicability of Byerlee's law to the upper brittle part of the lithosphere, particularly in view of uncertainties such as pore pressure and relative magnitude of the intermediate principal stresses. Nonetheless, the observed rotations all indicate that the magnitude of the local horizontal uniaxial stresses must be 1–2.5+ times the magnitude of the regional first-order horizontal stress differences and suggest that careful evaluation of such local rotations may be a powerful technique for constraining the in situ magnitude stress differences in the upper, brittle part of the lithosphere.

/pdf/first-and-second-order-patterns-of-stress-in-the-lithosphere-595hs86ljh.pdf

First‐ and second‐order patterns of stress in the lithosphere: The World Stress Map Project

splitting observations are interpreted in terms of the strain-induced lattice preferred orientation of mantle minerals, especially olivine. We consider three hypotheses concerning the origin of the continental anlsotropy: (1) strain associated with absolute plate motion, as in the oceanic upper mantle, (2) crustal stress, and (3) the past and present internal deformation of the subcontinental upper mantle by tectonic episodes. It is found that the last hypothesis is the most successful, namely that the most recent significant episode of internal deformation appears to be the best predictor of q. For stable continental regions, this is interpreted as "fossil" anisotropy, whereas for presently active regions, such as Alaska, the anisotropy reflects present-day tectonic activity. In the stable portion of North America there is a good correlation between delay time and lithospheric thickness; this is consistent with the anisotropy being localized in the subcontinental lithosphere and suggests that intrinsic anisotropy is approximately constant. The acceptance of this hypothesis has several implications for subcontinental mantle deformation. First, it argues for coherent deformation of the continental lithosphere (crust and mantle) during orogenies. This implies that the anisotropic portion of the lithosphere was present since the deformational episode and rules out the addition of undeformed material to this layer by subsequent "underplating" or conductive growth of the thermal boundary layer. One of the most important issues in the study of orogenies is the need to reconcile the formation of thickened lithosphere with the paradoxically high mantle temperatures often associated with orogenic episodes. Most efforts to date have focussed on modes of deformation whereby the cold lithospheric mantle is removed (by convective instability or delamination) and replaced by warm asthenosphere. These models, however, are incompatible with the evidence for preserved coherent lithospheric deformation; rather, the deformed mantle appears to have been heated in place. We suggest that the elevated mantle temperatures may be due to the strain heating accompanying the deformation.

/pdf/shear-wave-splitting-and-subcontinental-mantle-deformation-3tk4a7yxgq.pdf

Shear wave splitting and subcontinental mantle deformation

The ubiquity of dykes in the Earth's crust is evidence that the transport of magma by fluid-induced fracture of the lithosphere is an important phenomenon. Magma fracture transports melt vertically from regions of production in the mantle to surface eruptions or near-surface magma chambers and then laterally from the magma chambers in dykes and sills. In order to investigate the mechanics of magma fracture, the driving and resisting pressures in a propagating dyke are estimated and the dominant physical balances between these pressures are described. It is shown that the transport of magma in feeder dykes is characterized by a local balance between buoyancy forces and viscous pressure drop, that elastic forces play a secondary role except near the dyke tip and that the influence of the fracture resistance of crustal rocks on dyke propagation is negligible. The local nature of the force balance implies that the local density difference controls the height of magma ascent rather than the total hydrostatic head and hence that magma is emplaced at its level of neutral buoyancy (LNB) in the crust. There is a small overshoot beyond this level which is calculated to be typically a few kilometres. Magma accumulating at the LNB will be intruded in lateral dykes and sills which are directed along the LNB by buoyancy forces since the magma is in gravitational equilibrium at this level. Laboratory analogue experiments demonstrate the physical principle of buoyancy-controlled propagation to and along the LNB. The equations governing the dynamics of magma fracture are solved for the cases of lithospheric ascent and of lateral intrusion. Volatiles are predicted to be exsolved from the melt at the tips of extending fractures due to the generation of low pressures by viscous flow into the tip. Chilling of magma at the edges of a dyke inhibits cross-stream propagation and concentrates the downstream flow into a wider dyke. The family of theoretical solutions in different geometries provides simple models which describe the relation between the elastic and fluid-mechanical phenomena and from which the lengths, widths and rates of propagation can be calculated. The predicted dimensions are in broad agreement with geological observations.

Fluid‐mechanical models of crack propagation and their application to magma transport in dykes

Reservoir Geomechanics: Frontmatter

Global crustal stress pattern based on the World Stress Map database release 2008

Regional patterns of present-day tectonic stress can be used to evaluate the forces acting on the lithosphere and to investigate intraplate seismicity. Most intraplate regions are characterized by a compressional stress regime; extension is limited almost entirely to thermally uplifted regions. In several plates the maximum horizontal stress is subparallel to the direction of absolute plate motion, suggesting that the forces driving the plates also dominate the stress distribution in the plate interior.

Global patterns of tectonic stress

Objective: To compare the detection rate of advanced neoplasia and the number of people needing endoscopy in colorectal cancer screening giving at different starting age in population at high risk. Methods: Based on the screening project of early diagnosis and treatment of colorectal cancer in Jiashan county, Zhejiang province, two rounds of colorectal cancer screening were conducted between January 2007 and December 2020. After excluding participants who were not at high risk or had incomplete information, 27 130 participants and 31 205 participants were finally enrolled in round one and in round two, respectively. The spline analysis based on the generalized additive model was used to describe the trend of detection rate of advanced neoplasia with age. The detection rate and number of people needing endoscopy for the groups with starting age at 50, 45 and 40 years were calculated, and the differences in the detection rate were tested by χ2 goodness of fit test. Results: A total of 21 077 (77.69%) participants in round one and 25 249 (80.91%) participants in round two received endoscopy, in whom 1 097 (detection rate=52.05‰) and 1 151 (detection rate=45.59‰) had advanced neoplasia (cancers and advanced adenomas), respectively. The detection rate increased significantly with age, and the detection rate in round one were significantly higher than that in round two (P<0.05). The overall detection rates of advanced neoplasia for the groups with starting age at 50, 45 and 40 years were 61.11‰, 56.14‰ and 52.05‰ in round one, and 49.10‰, 46.75‰ and 45.59‰ in round two, respectively. The rates were significantly higher for the group with starting age at 50 years than that with starting age at 40 years in both round one and round two (P<0.05). The numbers of people needing endoscopy of advanced neoplasia for the groups with starting age at 50, 45 and 40 years were 17, 18, and 20 in round one, and 21, 22 and 22 in round two. Conclusions: The detection rate of advanced neoplasia increased with age. Starting screening at lower age might contribute to decreased detection rate and increased number of people needing endoscopy. However, the difference was limited.

Z. H. Xu

Papers

Global patterns of tectonic stress

[Influence of age on advanced neoplasia detection in colorectal cancer screening in population at high risk].