Zhong Du

Bio: Zhong Du is an academic researcher from North Carolina State University. The author has contributed to research in topics: Inverter & Grid-tie inverter. The author has an hindex of 15, co-authored 25 publications receiving 1513 citations. Previous affiliations of Zhong Du include Parker Hannifin & Oak Ridge National Laboratory.

Active harmonic elimination for multilevel converters

Abstract: This paper presents an active harmonic elimination method to eliminate any number of specific higher order harmonics of multilevel converters with equal or unequal dc voltages. First, resultant theory is applied to transcendental equations characterizing the harmonic content to eliminate low order harmonics and to determine switching angles for the fundamental frequency switching scheme and a unipolar switching scheme. Next, the residual higher order harmonics are computed and subtracted from the original voltage waveform to eliminate them. The simulation results show that the method can effectively eliminate the specific harmonics, and a low total harmonic distortion (THD) near sine wave is produced. An experimental 11-level H-bridge multilevel converter with a field programmable gate array controller is employed to implement the method. The experimental results show that the method does effectively eliminate any number of specific harmonics, and the output voltage waveform has low THD.

Fundamental Frequency Switching Strategies of a Seven-Level Hybrid Cascaded H-Bridge Multilevel Inverter

Abstract: This paper presents a cascaded H-bridge multilevel inverter that can be implemented using only a single dc power source and capacitors. Standard cascaded multilevel inverters require n dc sources for 2n + 1 levels. Without requiring transformers, the scheme proposed here allows the use of a single dc power source (e.g., a battery or a fuel cell stack) with the remaining n-1 dc sources being capacitors, which is referred to as hybrid cascaded H-bridge multilevel inverter (HCMLI) in this paper. It is shown that the inverter can simultaneously maintain the dc voltage level of the capacitors and choose a fundamental frequency switching pattern to produce a nearly sinusoidal output. HCMLI using only a single dc source for each phase is promising for high-power motor drive applications as it significantly decreases the number of required dc power supplies, provides high-quality output power due to its high number of output levels, and results in high conversion efficiency and low thermal stress as it uses a fundamental frequency switching scheme. This paper mainly discusses control of seven-level HCMLI with fundamental frequency switching control and how its modulation index range can be extended using triplen harmonic compensation.

DC–AC Cascaded H-Bridge Multilevel Boost Inverter With No Inductors for Electric/Hybrid Electric Vehicle Applications

Abstract: This paper presents a cascaded H-bridge multilevel boost inverter for electric vehicle (EV) and hybrid EV (HEV) applications implemented without the use of inductors. Currently available power inverter systems for HEVs use a dc-dc boost converter to boost the battery voltage for a traditional three-phase inverter. The present HEV traction drive inverters have low power density, are expensive, and have low efficiency because they need a bulky inductor. A cascaded H-bridge multilevel boost inverter design for EV and HEV applications implemented without the use of inductors is proposed in this paper. Traditionally, each H-bridge needs a dc power supply. The proposed design uses a standard three-leg inverter (one leg for each phase) and an H-bridge in series with each inverter leg which uses a capacitor as the dc power source. A fundamental switching scheme is used to do modulation control and to produce a five-level phase voltage. Experiments show that the proposed dc-ac cascaded H-bridge multilevel boost inverter can output a boosted ac voltage without the use of inductors.

A cascade multilevel inverter using a single DC source

Abstract: A method is presented showing that a cascade multilevel inverter can be implemented using only a single DC power source and capacitors. A standard cascade multilevel inverter requires n DC sources for 2n + 1 levels. Without requiring transformers, the scheme proposed here allows the use of a single DC power source (e.g., a battery or a fuel cell stack) with the remaining n-1 DC sources being capacitors. It is shown that one can simultaneously maintain the DC voltage level of the capacitors and choose a fundamental frequency switching pattern to produce a nearly sinusoidal output.

Reduced Switching-Frequency Active Harmonic Elimination for Multilevel Converters

Abstract: This paper presents a reduced switching-frequency active-harmonic-elimination method (RAHEM) to eliminate any number of specific order harmonics of multilevel converters. First, resultant theory is applied to transcendental equations to eliminate low-order harmonics and to determine switching angles for a fundamental frequency-switching scheme. Next, based on the number of harmonics to be eliminated, Newton climbing method is applied to transcendental equations to eliminate high-order harmonics and to determine switching angles for the fundamental frequency-switching scheme. Third, the magnitudes and phases of the residual lower order harmonics are computed, generated, and subtracted from the original voltage waveform to eliminate these low-order harmonics. Compared to the active-harmonic-elimination method (AHEM), which generates square waves to cancel high-order harmonics, RAHEM has lower switching frequency. The simulation results show that the method can effectively eliminate all the specific harmonics, and a low total harmonic distortion (THD) near sine wave is produced. An experimental 11-level H-bridge multilevel converter with a field-programmable gate-array controller is employed to experimentally validate the method. The experimental results show that RAHEM does effectively eliminate any number of specific harmonics, and the output voltage waveform has low switching frequency and low THD.

Recent Advances and Industrial Applications of Multilevel Converters

Abstract: Multilevel converters have been under research and development for more than three decades and have found successful industrial application. However, this is still a technology under development, and many new contributions and new commercial topologies have been reported in the last few years. The aim of this paper is to group and review these recent contributions, in order to establish the current state of the art and trends of the technology, to provide readers with a comprehensive and insightful review of where multilevel converter technology stands and is heading. This paper first presents a brief overview of well-established multilevel converters strongly oriented to their current state in industrial applications to then center the discussion on the new converters that have made their way into the industry. In addition, new promising topologies are discussed. Recent advances made in modulation and control of multilevel converters are also addressed. A great part of this paper is devoted to show nontraditional applications powered by multilevel converters and how multilevel converters are becoming an enabling technology in many industrial sectors. Finally, some future trends and challenges in the further development of this technology are discussed to motivate future contributions that address open problems and explore new possibilities.

Multilevel Voltage-Source-Converter Topologies for Industrial Medium-Voltage Drives

Abstract: This paper presents a technology review of voltage-source-converter topologies for industrial medium-voltage drives. In this highly active area, different converter topologies and circuits have found their application in the market. This paper covers the high-power voltage-source inverter and the most used multilevel-inverter topologies, including the neutral-point-clamped, cascaded H-bridge, and flying-capacitor converters. This paper presents the operating principle of each topology and a review of the most relevant modulation methods, focused mainly on those used by industry. In addition, the latest advances and future trends of the technology are discussed. It is concluded that the topology and modulation-method selection are closely related to each particular application, leaving a space on the market for all the different solutions, depending on their unique features and limitations like power or voltage level, dynamic performance, reliability, costs, and other technical specifications.

A Survey on Cascaded Multilevel Inverters

Abstract: Cascaded multilevel inverters synthesize a medium-voltage output based on a series connection of power cells which use standard low-voltage component configurations. This characteristic allows one to achieve high-quality output voltages and input currents and also outstanding availability due to their intrinsic component redundancy. Due to these features, the cascaded multilevel inverter has been recognized as an important alternative in the medium-voltage inverter market. This paper presents a survey of different topologies, control strategies and modulation techniques used by these inverters. Regenerative and advanced topologies are also discussed. Applications where the mentioned features play a key role are shown. Finally, future developments are addressed.

The age of multilevel converters arrives

Abstract: This work is devoted to review and analyze the most relevant characteristics of multilevel converters, to motivate possible solutions, and to show that we are in a decisive instant in which energy companies have to bet on these converters as a good solution compared with classic two-level converters. This article presents a brief overview of the actual applications of multilevel converters and provides an introduction of the modeling techniques and the most common modulation strategies. It also addresses the operational and technological issues.