Jordan University of Science and Technology

About: Jordan University of Science and Technology is a education organization based out in Irbid, Irbid, Jordan. It is known for research contribution in the topics: Population & Medicine. The organization has 7582 authors who have published 13166 publications receiving 298158 citations. The organization is also known as: JUST.

Growth of mycorrhizal tomato and mineral acquisition under salt stress.

Abstract: High salt levels in soil and water can limit agricultural production and land development in arid and semiarid regions. Arbuscular mycorrhizal fungi (AMF) have been shown to decrease plant yield losses in saline soils. The objective of this study was to examine the growth and mineral acquisition responses of greenhouse-grown tomato to colonization by the AMF Glomus mosseae [(Nicol. And Gerd.) Gerd. and Trappe] under varied levels of salt. NaCl was added to soil in the irrigation water to give an ECe of 1.4 (control), 4.7 (medium) and 7.4 dS m–1 (high salt stress). Plants were grown in a sterilized, low P (silty clay) soil-sand mix. Mycorrhizal colonization was higher in the control than in saline soil conditions. Shoot and root dry matter yields and leaf area were higher in mycorrhizal than in nonmycorrhizal plants. Total accumulation of P, Zn, Cu, and Fe was higher in mycorrhizal than in nonmycorrhizal plants under both control and medium salt stress conditions. Shoot Na concentrations were lower in mycorrhizal than in nonmycorrhizal plants grown under saline soil conditions. The improved growth and nutrient acquisition in tomato demonstrate the potential of AMF colonization for protecting plants against salt stress in arid and semiarid areas.

Waste to energy potential: A case study of Saudi Arabia

Abstract: This paper reviews the global status of waste to energy (WTE) technologies as a mean for renewable energy production and municipal solid waste (MSW) disposal method. A case study of the Kingdom of Saudi Arabia (KSA) under this concept was developed. The WTE opportunities in the KSA is undertaken in the context of two scenarios: (1) incineration and (2) refuse derived fuel (RDF) along with biomethanation from 2012 to 2035. Biomethanation technology can proved to be the most suitable WTE technology for KSA due to (a) availability of high food waste volume (37% of total MSW) that can be used as a feedstock, (b) higher efficiency (25–30%) and (c) lowest annual capital ($0.1–0.14/ton) and operational cost. However, the need for large space for continuous operation might increase operational cost. The RDF has an advantage over incineration due to (a) less annual capital ($7.5–11.3/ton) and (b) operational cost ($0.3–0.55/ton), but the high labor skills requirements will most probably be a limitation, if appropriate training and related infrastructure are not scheduled to be included as a prerequisite. The incineration technology also proves to be an efficient solution with a relatively higher efficiency (25%) and lower operational cost ($1.5–2.5/ton). However, the need for treatment of air and waterborne pollutants and ash within the incineration facility can be the limiting factors for the development of this technology in KSA. In 2012, the power generation potential for KSA was estimated at 671 MW and 319.4 MW from incineration and RDF with biomethanation scenarios respectively, which was forecasted to reach upto 1447 MW and 699.76 MW for both scenarios respectively by 2035. Therefore, WTE technologies, could make a substantial contribution to the renewable energy production in KSA as well as alleviating the cost of landfilling and its associated environmental impacts. However, the decision to select between the two scenarios requires further in-depth financial, technical and environmental analysis using life cycle assessment (LCA) tool.

Low power tissue sealing device and method

Abstract: A surgical system and associated method for sealing the passageway of a fluid-carrying vessel comprises an electrosurgical generator capable of delivering electrosurgical power, a surgical instrument connected to the electrosurgical generator and adapted to transfer electrosurgical power from the electrosurgical generator to a pair of end effectors disposed at a distal end of the instrument. The system also includes a power control circuit for controlling the delivery of energy to the vessel through the end effectors, wherein the delivery of the radio frequency energy to the vessel comprises, raising the output current to a range below 1.75 Amperes RMS and the output voltage to a range below 135 Volts RMS. Radio frequency energy is applied to the vessel for a period of time while the power is held approximately constant. The flow of radio frequency energy is terminated when the impedance of the vessel being sealed reaches a predetermined level.