Naval Surface Warfare Center

About: Naval Surface Warfare Center is a facility organization based out in Washington D.C., District of Columbia, United States. It is known for research contribution in the topics: Sonar & Radar. The organization has 2855 authors who have published 3697 publications receiving 83518 citations. The organization is also known as: NSWC.

The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis

Abstract: A new method for analysing nonlinear and non-stationary data has been developed. The key part of the method is the empirical mode decomposition method with which any complicated data set can be dec...

Refractory Diborides of Zirconium and Hafnium

Abstract: This paper reviews the crystal chemistry, synthesis, densification, microstructure, mechanical properties, and oxidation behavior of zirconium diboride (ZrB2) and hafnium diboride (HfB2) ceramics. The refractory diborides exhibit partial or complete solid solution with other transition metal diborides, which allows compositional tailoring of properties such as thermal expansion coefficient and hardness. Carbothermal reduction is the typical synthesis route, but reactive processes, solution methods, and pre-ceramic polymers can also be used. Typically, diborides are densified by hot pressing, but recently solid state and liquid phase sintering routes have been developed. Fine-grained ZrB2 and HfB2 have strengths of a few hundred MPa, which can increase to over 1 GPa with the addition of SiC. Pure diborides exhibit parabolic oxidation kinetics at temperatures below 1100°C, but B2O3 volatility leads to rapid, linear oxidation kinetics above that temperature. The addition of silica scale formers such as SiC or MoSi2 improves the oxidation behavior above 1100°C. Based on their unique combination of properties, ZrB2 and HfB2 ceramics are candidates for use in the extreme environments associated with hypersonic flight, atmospheric re-entry, and rocket propulsion.

Economic impact of biofouling on a naval surface ship

Abstract: In the present study, the overall economic impact of hull fouling on a mid-sized naval surface ship (Arleigh Burke-class destroyer DDG-51) has been analyzed. A range of costs associated with hull fouling was examined, including expenditures for fuel, hull coatings, hull coating application and removal, and hull cleaning. The results indicate that the primary cost associated with fouling is due to increased fuel consumption attributable to increased frictional drag. The costs related to hull cleaning and painting are much lower than the fuel costs. The overall cost associated with hull fouling for the Navy's present coating, cleaning, and fouling level is estimated to be $56M per year for the entire DDG-51 class or $1B over 15 years. The results of this study provide guidance as to the amount of money that can be reasonably spent for research, development, acquisition, and implementation of new technologies or management strategies to combat hull fouling.

Oxidation-based materials selection for 2000°C + hypersonic aerosurfaces: Theoretical considerations and historical experience

Abstract: Hypersonic flight involves extremely high velocities and gas temperatures with the attendant necessity for thermal protection systems (TPS). New high temperature materials are needed for these TPS systems. A systematic investigation of the thermodynamics of potential materials revealed that low oxidation rate materials, which form pure scales of SiO2, Al2O3, Cr2O3, or BeO, cannot be utilized at temperatures of 1800°C (and above) due to disruptively high vapor pressures which arise at the interface of the base material and the scale. Vapor pressure considerations provide significant insight into the relatively good oxidation resistance of ZrB2- and HfB2-based materials at 2000°C and above. These materials form multi-oxide scales composed of a refractory crystalline oxide (skeleton) and a glass component, and this compositional approach is recommended for further development. The oxidation resistance of ZrB2-SiC and other non-oxide materials is improved, to at least 1600°C, by compositional modifications which promote immiscibility in the glass component of the scale. Other candidate materials forming high temperature oxides, such as rare earth compounds, are largely unexplored for high temperature applications and may be attractive candidates for hypersonic TPS materials.

Controlling chaos in the brain

Abstract: In a spontaneously bursting neuronal network in vitro, chaos can be demonstrated by the presence of unstable fixed-point behaviour. Chaos control techniques can increase the periodicity of such neuronal population bursting behaviour. Periodic pacing is also effective in entraining such systems, although in a qualitatively different fashion. Using a strategy of anticontrol such systems can be made less periodic. These techniques may be applicable to in vivo epileptic foci.