Nokia Networks

About: Nokia Networks is a based out in . It is known for research contribution in the topics: Base station & Telecommunications link. The organization has 5394 authors who have published 7149 publications receiving 101979 citations.

A stochastic MIMO radio channel model with experimental validation

Abstract: Theoretical and experimental studies of multiple-input/multiple-output (MIMO) radio channels are presented. A simple stochastic MIMO model channel has been developed. This model uses the correlation matrices at the mobile station (MS) and base station (BS) so that results of the numerous single-input/multiple-output studies that have been published in the literature can be used as input parameters. The model is simplified to the narrowband channels. The validation of the model is based upon data collected in both picocell and microcell environments. The stochastic model has also been used to investigate the capacity of MIMO radio channels, considering two different power allocation strategies, water filling and uniform and two different antenna topologies, 4/spl times/4 and 2/spl times/4. Space diversity used at both ends of the MIMO radio link is shown to be an efficient technique in picocell environments, achieving capacities within 14 b/s/Hz and 16 b/s/Hz in 80% of the cases for a 4/spl times/4 antenna configuration implementing water filling at a SNR of 20 dB.

Millimeter Wave Beamforming for Wireless Backhaul and Access in Small Cell Networks

Abstract: Recently, there has been considerable interest in new tiered network cellular architectures, which would likely use many more cell sites than found today. Two major challenges will be i) providing backhaul to all of these cells and ii) finding efficient techniques to leverage higher frequency bands for mobile access and backhaul. This paper proposes the use of outdoor millimeter wave communications for backhaul networking between cells and mobile access within a cell. To overcome the outdoor impairments found in millimeter wave propagation, this paper studies beamforming using large arrays. However, such systems will require narrow beams, increasing sensitivity to movement caused by pole sway and other environmental concerns. To overcome this, we propose an efficient beam alignment technique using adaptive subspace sampling and hierarchical beam codebooks. A wind sway analysis is presented to establish a notion of beam coherence time. This highlights a previously unexplored tradeoff between array size and wind-induced movement. Generally, it is not possible to use larger arrays without risking a corresponding performance loss from wind-induced beam misalignment. The performance of the proposed alignment technique is analyzed and compared with other search and alignment methods. The results show significant performance improvement with reduced search time.

Heterogeneous cellular networks: From theory to practice

Abstract: The proliferation of internet-connected mobile devices will continue to drive growth in data traffic in an exponential fashion, forcing network operators to dramatically increase the capacity of their networks. To do this cost-effectively, a paradigm shift in cellular network infrastructure deployment is occurring away from traditional (expensive) high-power tower-mounted base stations and towards heterogeneous elements. Examples of heterogeneous elements include microcells, picocells, femtocells, and distributed antenna systems (remote radio heads), which are distinguished by their transmit powers/ coverage areas, physical size, backhaul, and propagation characteristics. This shift presents many opportunities for capacity improvement, and many new challenges to co-existence and network management. This article discusses new theoretical models for understanding the heterogeneous cellular networks of tomorrow, and the practical constraints and challenges that operators must tackle in order for these networks to reach their potential.

An overview of 3GPP device-to-device proximity services

Abstract: Device-to-device communication is likely to be added to LTE in 3GPP Release 12. In principle, exploiting direct communication between nearby mobile devices will improve spectrum utilization, overall throughput, and energy consumption, while enabling new peer-to-peer and location-based applications and services. D2D-enabled LTE devices can also become competitive for fallback public safety networks, which must function when cellular networks are not available or fail. Introducing D2D poses many challenges and risks to the long-standing cellular architecture, which is centered around the base station. We provide an overview of D2D standardization activities in 3GPP, identify outstanding technical challenges, draw lessons from initial evaluation studies, and summarize "best practices" in the design of a D2D-enabled air interface for LTE-based cellular networks

A segmentation-based method to retrieve stem volume estimates from 3-D tree height models produced by laser scanners

Abstract: In the boreal forest zone and in many forest areas, there exist gaps between the forest crowns. For example, in Finland, more than 30% of the first pulse data of laser scanning reflect directly from the ground without any interaction with the canopy. By increasing the number of pulses, it is possible to have samples from each individual tree and also from the gaps between the trees. Basically, this means that several laser pulses can be recorded per m/sup 2/. This allows detailed investigation of forest areas and the creation of a three-dimensional (3D) tree height model. Tree height model can be calculated from the digital terrain and crown models both obtained with the laser scanner data. By analyzing the 3D tree height model by using image vision methods, e.g., segmentation, it is possible to locate individual trees, estimate individual tree heights, crown area, and, by using that data, to derive the stem diameter, number of stems, basal area, and stem volume. The advantage of the method is the capability to measure directly physical dimensions from the trees and use that information to calculate the needed stand attributes. This paper demonstrates for the first time that it is possible to accurately estimate standwise forest attributes, especially stem volume (biomass), using high-pulse-rate laser scanners to provide data, from which individual trees can be detected and characteristics of trees such as height, location, and crown dimensions can be determined. That information can be applied to provide estimates for larger areas (stands). Using the new method, the following standard errors were demonstrated for mean height, basal area and stem volume: 1.8 m (9.9%), 2.0 m/sup 2//ha (10.2%), and 18.5 m/sup 3//ha (10.5%), respectively.