Sao Paulo State University

About: Sao Paulo State University is a education organization based out in São Paulo, Brazil. It is known for research contribution in the topics: Population & Large Hadron Collider. The organization has 55715 authors who have published 100436 publications receiving 1375332 citations.

Combination of Searches for Higgs Boson Pair Production in Proton-Proton Collisions at √s = 13 TeV

Abstract: This Letter describes a search for Higgs boson pair production using the combined results from four final states: bbγγ, bbττ, bbbb, and bbVV, where V represents a W or Z boson. The search is performed using data collected in 2016 by the CMS experiment from LHC proton-proton collisions at s=13 TeV, corresponding to an integrated luminosity of 35.9 fb-1. Limits are set on the Higgs boson pair production cross section. A 95% confidence level observed (expected) upper limit on the nonresonant production cross section is set at 22.2 (12.8) times the standard model value. A search for narrow resonances decaying to Higgs boson pairs is also performed in the mass range 250–3000 GeV. No evidence for a signal is observed, and upper limits are set on the resonance production cross section.

Bond strength of a resin cement to high-alumina and zirconia-reinforced ceramics: The effect of surface conditioning

Abstract: Purpose: The aim of this study was to evaluate the effect of two surface conditioning methods on the microtensile bond strength of a resin cement to three high-strength core ceramics: high alumina-based (In-Ceram Alumina, Procera AllCeram) and zirconia-reinforced alumina-based (in-Ceram Zirconia) ceramics. Materials and Methods: Ten blocks (5 x 6 x 8 mm) of In-Ceram Alumina (AL), In-Ceram Zirconia (ZR), and Procera (PR) ceramics were fabricated according to each manufacturer's instructions and duplicated in composite. The specimens were assigned to one of the two following treatment conditions: (1) airborne particle abrasion with 110-mu m Al(2)O(3) particles + silanization, (2) silica coating with 30 lam SiO(x) particles (CoJet, 3M ESPE) + silanization. Each ceramic block was duplicated in composite resin (W3D-Master, Wilcos, Petropolis, RJ, Brazil) using a mold made out of silicon impression material. Composite resin layers were incrementally condensed into the mold to fill up the mold and each layer was light polymerized for 40 s. The composite blocks were bonded to the surface-conditioned ceramic blocks using a resin cement system (Panavia F, Kuraray, Okayama, Japan). One composite resin block was fabricated for each ceramic block. The ceramic-composite was stored at 37 degrees C in distilled water for 7 days prior to bond tests. The blocks were cut under water cooling to produce bar specimens (n = 30) with a bonding area of approximately 0.6 mm(2). The bond strength tests were performed in a universal testing machine (crosshead speed: 1 mm/min). Bond strength values were statistically analyzed using two-way ANOVA and Tukey's test ( Results: Silica coating with silanization increased the bond strength significantly for all three high-strength ceramics (18.5 to 31.2 MPa) compared to that of airborne particle abrasion with 110-mu m Al(2)O(3) (12.7-17.3 MPa) (ANOVA, p <0.05). PR exhibited the lowest bond strengths after both Al(2)O(3) and silica coating (12.7 and 18.5 MPa, respectively). Conclusion: Conditioning the high-strength ceramic surfaces with silica coating and silanization provided higher bond strengths of the resin cement than with airborne particle abrasion with 110- mu m Al(2)O(3) and silanization.

Perioperative cardiac arrest: a study of 53 718 anaesthetics over 9 yr from a Brazilian teaching hospital

Abstract: Background Little information exists regarding factors influencing perioperative cardiac arrests and their outcome. This survey evaluated the incidence, causes and outcome of perioperative cardiac arrests in a Brazilian tertiary general teaching hospital between April 1996 and March 2005. Methods The incidence of cardiac arrest during anaesthesia was prospectively identified from an anaesthesia database. There were 53 718 anaesthetics during the study period. Data collected included patient characteristics, surgical procedures (elective, urgent or emergency), ASA physical status classification, anaesthesia provider information, type of surgery, surgical areas and outcome. All cardiac arrests were retrospectively reviewed and grouped by cause of arrest and death into one of four groups: totally anaesthesia related, partially anaesthesia related, totally surgery related or totally patient disease or condition related. Results One hundred and eighty-six cardiac arrests (34.6:10 000) and 118 deaths (21.97:10 000) were found. Major risk factors for cardiac arrest were neonates, children under 1 yr and the elderly (P Conclusions Perioperative cardiac arrests were relatively higher in neonates, infants, the elderly and in males with severe underlying disease and under emergency surgery. All anaesthesia-related cardiac arrests were related to airway management and medication administration which is important for prevention strategies.