University of Oviedo

About: University of Oviedo is a education organization based out in Oviedo, Spain. It is known for research contribution in the topics: Population & Large Hadron Collider. The organization has 13423 authors who have published 31649 publications receiving 844799 citations. The organization is also known as: Universidá d'Uviéu & Universidad de Oviedo.

Removal of copper and cadmium ions from diluted aqueous solutions by low cost and waste material adsorbents

Abstract: The sorption of copper and cadmium ions using activated carbon,kaolin, bentonite, diatomite and waste materials such as compost,cellulose pulp waste and anaerobic sludge as sorbents is reported. Equilibrium isotherms were obtained for the adsorption of these metals in single and binary solutions. Bentonite presented the highest adsorption capacities for both copper and cadmium. A competitive uptake was observed when both metals are present; copper being preferentially adsorbed by all materials with theexception of anaerobic sludge. Equilibrium data were fitted toLangmuir and Freundlich models, with satisfactory results for most of the adsorbent-metal systems studied.Of all the adsorbents studied, bentonite and compost presentedthe highest removal efficiencies, reaching 99% for copper whencadmium is also present, for initial solution concentrations ofup to 100 mg L-1. Anaerobic sludge has a greater preferencefor cadmium, even in the presence of copper, with removal efficiencies of 98% for similar concentrations to those mentioned above.

The effect of renewable energy on employment. The case of Asturias (Spain)

Abstract: Several changes are taking place in the energy sector as a result of the development of renewable energies and the implementation of new clean technologies. The use of renewable energies offers the opportunity to diminish energy dependence, reduce the emission of CO2 and create new employment. The involvement of local agents is highly important for the future development in this field, especially in regions whose industrial mix was based on traditional energy sources. Since this is the case in the region of Asturias (Spain), in this article we focus on the expectations of employment generated by renewable energies in Asturias during the period 2006–2010. More specifically we propose ratios of job per unit of installed energy power based on the available regional information in order to forecast energy employment in Asturias. With this aim three alternative scenarios are considered according to a range of possible future renewable energy pathways, leading to baseline, optimistic and pessimistic forecasts. Once these forecasts are computed we also analyse the emergent professional profiles and required skills related to the new jobs generated in the installation, operation and maintenance of the different renewable energy systems.

Inverter nonlinearity effects in high frequency signal injection-based, sensorless control methods

Abstract: An analysis of pulsewidth-modulation inverter nonlinearities influencing high-frequency carrier-signal voltage injection for saliency-tracking-based rotor/flux position estimation is presented in this paper. Distortion of the injected carrier voltage caused by the nonlinear behavior of the inverter has been reported to cause errors in the estimated rotor/flux position. Though a number of techniques have been developed to compensate for inverter nonlinearities, they have not been proven to be effective when a high-frequency low-magnitude voltage needs to be generated. Both the origins of the distortion as well as the requirements for compensation methods to be effective when producing such high-frequency voltages will be established in this paper.

Measurements of differential jet cross sections in proton-proton collisions at √s=7 TeV with the CMS detector

Abstract: Measurements of inclusive jet and dijet production cross sections are presented. Data from LHC proton-proton collisions at √s=7 TeV, corresponding to 5.0 fb-1 of integrated luminosity, have been collected with the CMS detector. Jets are reconstructed up to rapidity 2.5, transverse momentum 2 TeV, and dijet invariant mass 5 TeV, using the anti-kT clustering algorithm with distance parameter R=0.7. The measured cross sections are corrected for detector effects and compared to perturbative QCD predictions at next-to-leading order, using five sets of parton distribution functions.

Siesta: Recent developments and applications

Abstract: A review of the present status, recent enhancements, and applicability of the Siesta program is presented. Since its debut in the mid-1990s, Siesta’s flexibility, efficiency, and free distribution have given advanced materials simulation capabilities to many groups worldwide. The core methodological scheme of Siesta combines finite-support pseudo-atomic orbitals as basis sets, norm-conserving pseudopotentials, and a real-space grid for the representation of charge density and potentials and the computation of their associated matrix elements. Here, we describe the more recent implementations on top of that core scheme, which include full spin–orbit interaction, non-repeated and multiple-contact ballistic electron transport, density functional theory (DFT)+U and hybrid functionals, time-dependent DFT, novel reduced-scaling solvers, density-functional perturbation theory, efficient van der Waals non-local density functionals, and enhanced molecular-dynamics options. In addition, a substantial effort has been made in enhancing interoperability and interfacing with other codes and utilities, such as wannier90 and the second-principles modeling it can be used for, an AiiDA plugin for workflow automatization, interface to Lua for steering Siesta runs, and various post-processing utilities. Siesta has also been engaged in the Electronic Structure Library effort from its inception, which has allowed the sharing of various low-level libraries, as well as data standards and support for them, particularly the PSeudopotential Markup Language definition and library for transferable pseudopotentials, and the interface to the ELectronic Structure Infrastructure library of solvers. Code sharing is made easier by the new open-source licensing model of the program. This review also presents examples of application of the capabilities of the code, as well as a view of on-going and future developments.