York University

About: York University is a education organization based out in Toronto, Ontario, Canada. It is known for research contribution in the topics: Population & Poison control. The organization has 18899 authors who have published 43357 publications receiving 1568560 citations.

Measurement of the azimuthal anisotropy for charged particle production in √ sNN = 2.76 TeV lead-lead collisions with the ATLAS detector

Abstract: Differential measurements of charged particle azimuthal anisotropy are presented for lead-lead collisions at root sNN = 2.76 TeV with the ATLAS detector at the LHC, based on an integrated luminosity of approximately 8 mu b(-1). This anisotropy is characterized via a Fourier expansion of the distribution of charged particles in azimuthal angle relative to the reaction plane, with the coefficients v(n) denoting the magnitude of the anisotropy. Significant v(2)-v(6) values are obtained as a function of transverse momentum (0.5 = 3 are found to vary weakly with both eta and centrality, and their p(T) dependencies are found to follow an approximate scaling relation, v(n)(1/n)(p(T)) proportional to v(2)(1/2)(p(T)), except in the top 5% most central collisions. A Fourier analysis of the charged particle pair distribution in relative azimuthal angle (Delta phi = phi(a)-phi(b)) is performed to extract the coefficients v(n,n) = . For pairs of charged particles with a large pseudorapidity gap (|Delta eta = eta(a) - eta(b)| > 2) and one particle with p(T) < 3 GeV, the v(2,2)-v(6,6) values are found to factorize as v(n,n)(p(T)(a), p(T)(b)) approximate to v(n) (p(T)(a))v(n)(p(T)(b)) in central and midcentral events. Such factorization suggests that these values of v(2,2)-v(6,6) are primarily attributable to the response of the created matter to the fluctuations in the geometry of the initial state. A detailed study shows that the v(1,1)(p(T)(a), p(T)(b)) data are consistent with the combined contributions from a rapidity-even v(1) and global momentum conservation. A two-component fit is used to extract the v(1) contribution. The extracted v(1) isobserved to cross zero at pT approximate to 1.0 GeV, reaches a maximum at 4-5 GeV with a value comparable to that for v(3), and decreases at higher p(T).

Charged-particle multiplicities in pp interactions measured with the ATLAS detector at the LHC

Abstract: Measurements are presented from proton-proton collisions at centre-of-mass energies of root s = 0.9, 2.36 and 7 TeV recorded with the ATLAS detector at the LHC. Events were collected using a single-arm minimum-bias trigger. The charged-particle multiplicity, its dependence on transverse momentum and pseudorapidity and the relationship between the mean transverse momentum and charged-particle multiplicity are measured. Measurements in different regions of phase space are shown, providing diffraction-reduced measurements as well as more inclusive ones. The observed distributions are corrected to well-defined phase-space regions, using model-independent corrections. The results are compared to each other and to various Monte Carlo (MC) models, including a new AMBT1 pythia6 tune. In all the kinematic regions considered, the particle multiplicities are higher than predicted by the MC models. The central charged-particle multiplicity per event and unit of pseudorapidity, for tracks with p(T) > 100 MeV, is measured to be 3.483 +/- 0.009 (stat) +/- 0.106 (syst) at root s = 0.9 TeV and 5.630 +/- 0.003 (stat) +/- 0.169 (syst) at root s = 7 TeV.

Accuracy measures for evaluating computer pointing devices

Abstract: In view of the difficulties in evaluating computer pointing devices across different tasks within dynamic and complex systems, new performance measures are needed. This paper proposes seven new accuracy measures to elicit (sometimes subtle) differences among devices in precision pointing tasks. The measures are target re-entry, task axis crossing, movement direction change, orthogonal direction change, movement variability, movement error, and movement offset. Unlike movement time, error rate, and throughput, which are based on a single measurement per trial, the new measures capture aspects of movement behaviour during a trial. The theoretical basis and computational techniques for the measures are described, with examples given. An evaluation with four pointing devices was conducted to validate the measures. A causal relationship to pointing device efficiency (viz. throughput) was found, as was an ability to discriminate among devices in situations where differences did not otherwise appear. Implications for pointing device research are discussed.

DEA models for supply chain efficiency evaluation

Abstract: An appropriate performance measurement system is an important requirement for the effective management of a supply chain. Two hurdles are present in measuring the performance of a supply chain and its members. One is the existence of multiple measures that characterize the performance of chain members, and for which data must be acquired; the other is the existence of conflicts between the members of the chain with respect to specific measures. Conventional data envelopment analysis (DEA) cannot be employed directly to measure the performance of supply chain and its members, because of the existence of the intermediate measures connecting the supply chain members. In this paper it is shown that a supply chain can be deemed as efficient while its members may be inefficient in DEA-terms. The current study develops several DEA-based approaches for characterizing and measuring supply chain efficiency when intermediate measures are incorporated into the performance evaluation. The models are illustrated in a seller-buyer supply chain context, when the relationship between the seller and buyer is treated first as one of leader-follower, and second as one that is cooperative. In the leader-follower structure, the leader is first evaluated, and then the follower is evaluated using information related to the leader's efficiency. In the cooperative structure, the joint efficiency which is modelled as the average of the seller's and buyer's efficiency scores is maximized, and both supply chain members are evaluated simultaneously. Non-linear programming problems are developed to solve these new supply chain efficiency models. It is shown that these DEA-based non-linear programs can be treated as parametric linear programming problems, and best solutions can be obtained via a heuristic technique. The approaches are demonstrated with a numerical example.