IEEE Journal of the Electron Devices Society 

About: IEEE Journal of the Electron Devices Society is an academic journal published by Institute of Electrical and Electronics Engineers. The journal publishes majorly in the area(s): Materials science & Transistor. It has an ISSN identifier of 2168-6734. It is also open access. Over the lifetime, 1186 publications have been published receiving 14162 citations. The journal is also known as: Electron Devices Society, IEEE journal & Institute of Electrical and Electronics Engineers journal of the Electron Devices Society.

Tunnel Field-Effect Transistors: State-of-the-Art

Abstract: Progress in the development of tunnel field-effect transistors (TFETs) is reviewed by comparing experimental results and theoretical predictions against 16-nm FinFET CMOS technology. Experiments lag the projections, but sub-threshold swings less than 60 mV/decade are now reported in 14 TFETs. The lowest measured sub-threshold swings approaches 20 mV/decade, however, the measurements at these lowest values are not based on many points. The highest current at which sub-threshold swing below 60 mV/decade is observed is in the range 1–10 nA/ \({{\mu }}\) m. A common approach to TFET characterization is proposed to facilitate future comparisons.

A Review of the Pinned Photodiode for CCD and CMOS Image Sensors

Abstract: The pinned photodiode is the primary photodetector structure used in most CCD and CMOS image sensors. This paper reviews the development, physics, and technology of the pinned photodiode.

Tunnel Field-Effect Transistors: Prospects and Challenges

Abstract: The tunnel field-effect transistor (TFET) is considered a future transistor option due to its steep-slope prospects and the resulting advantages in operating at low supply voltage ( $\mathrm{V}_{\rm DD}$ ). In this paper, using atomistic quantum models that are in agreement with experimental TFET devices, we are reviewing TFETs prospects at $\mathrm{L}_{\rm G}= 13$ nm node together with the main challenges and benefits of its implementation. Significant power savings at iso-performance to CMOS are shown for GaSb/InAs TFET, but only for performance targets which use lower than conventional $\mathrm{V}_{\rm DD}$ . Also, P-TFET current-drive is between $1\times $ to $0.5\times $ of N-TFET, depending on choice of $\mathrm{I}_{\rm OFF}$ and $\mathrm{V}_{\rm DD}$ . There are many challenges to realizing TFETs in products, such as the requirement of high quality III–V materials and oxides with very thin body dimensions, and the TFET’s layout density and reliability issues due to its source/drain asymmetry. Yet, extremely parallelizable products, such as graphics cores, show the prospect of longer battery life at a cost of some chip area.

Controlling Ambipolar Current in Tunneling FETs Using Overlapping Gate-on-Drain

Abstract: In this paper, we have demonstrated that overlapping the gate on the drain can suppress the ambipolar conduction, which is an inherent property of a tunnel field effect transistor (TFET). Unlike in the conventional TFET where the gate controls the tunneling barrier width at both source-channel and channel-drain interfaces for different polarity of gate voltage, overlapping the gate on the drain limits the gate to control only the tunneling barrier width at the source-channel interface irrespective of the polarity of the gate voltage. As a result, the proposed overlapping gate-on-drain TFET exhibits suppressed ambipolar conduction even when the drain doping is as high as \(1 \times 10^{19}\) cm \(^{-3}\) .

Characterization and Compact Modeling of Nanometer CMOS Transistors at Deep-Cryogenic Temperatures

Abstract: Cryogenic characterization and modeling of two nanometer bulk CMOS technologies (0.16- $\mu \text{m}$ and 40-nm) are presented in this paper. Several devices from both technologies were extensively characterized at temperatures of 4 K and below. Based on a detailed understanding of the device physics at deep-cryogenic temperatures, a compact model based on MOS11 and PSP was developed. In addition to reproducing the device dc characteristics, the accuracy and validity of the compact models are demonstrated by comparing time- and frequency-domain simulations of complex circuits, such as a ring oscillator and a low-noise amplifier, with the measurements at 4 K.