Inorganics (Basel) 

About: Inorganics (Basel) is an academic journal published by Multidisciplinary Digital Publishing Institute. The journal publishes majorly in the area(s): Chemistry & Materials science. It has an ISSN identifier of 2304-6740. It is also open access. Over the lifetime, 552 publications have been published receiving 914 citations.

A 2D Porous Zinc-Organic Framework Platform for Loading of 5-Fluorouracil

Abstract: A hydrostable 2D Zn-based MOF, {[Zn(5-PIA)(imbm)]·2H2O}n (1) (5-H2PIA = 5-propoxy-isophthalic acid, imbm = 1,4-di(1H-imidazol-1-yl)benzene), was synthesized and structurally characterized. Complex 1 shows good water and thermal stability based on the TGA and PXRD analyses and displays a 2D framework with 1D channels of 4.8 × 13.8 and 10.0 × 8.3 Å2 along the a axis. The 5-fluorouracil (5-FU) payload in activated complex 1 (complex 1a) is 19.3 wt%, and the cumulative release value of 5-FU at 120 h was about 70.04% in PBS (pH 7.4) at 310 K. In vitro MTT assays did not reveal any cytotoxic effect of NIH-3T3 and HEK-293 cells when the concentration of 1 was below 500 μg/mL and 5 μg/mL, respectively. No morphological abnormalities were observed on zebrafish exposed to complex 1.

Single- to Triple-Wall WS2 Nanotubes Obtained by High-Power Plasma Ablation of WS2 Multiwall Nanotubes

Abstract: The synthesis of inorganic nanotubes (INT) from layered compounds of a small size (<10 nm in diameter) and number of layers (<4) is not a trivial task. Calculations based on density functional tight-binding theory (DFTB) predict that under highly exergonic conditions, the reaction could be driven into a “window” of (meta-) stability, where 1–3-layer nanotubes will be formed. Indeed, in this study, single- to triple-wall WS2 nanotubes with a diameter of 3–7 nm and a length of 20–100 nm were produced by high-power plasma irradiation of multiwall WS2 nanotubes. As target materials, plane crystals (2H), quasi spherical nanoparticles (IF) and multiwall, 20–30 layers, WS2 nanotubes were assessed. Surprisingly, only INT-WS2 treated by plasma resulted in very small, and of a few layers, “daughter” nanotubules. The daughter nanotubes occur mostly attached to the outer surface of the predecessor, i.e., the multiwall “mother” nanotubes. They appear having either a common growth axis with the multiwall nanotube or tilted by approximately 30° or 60° with respect to its axis. This suggests that the daughter nanotubes are generated by exfoliation along specific crystallographic directions. A growth mechanism for the daughter nanotubes is proposed. High resolution transmission and scanning electron microscopy (HRTEM/HRSEM) analyses revealed the distinctive nanoscale structures and helped elucidating their growth mechanism.

High-Energy-Low-Temperature Technologies for the Synthesis of Nanoparticles: Microwaves and High Pressure

Abstract: Microwave Solvothermal Synthesis (MSS) is a chemical technology, where apart from possible effects of microwaves on the chemical reaction paths, microwave heating allows the precise planning of a time-temperature schedule, as well as to achieve high super-saturation of the reagents uniformly in the reactor vessel. Thus, MSS is suitable for production of nanoparticles with small grain size distribution and a high degree of crystallinity. A further advantage of the technology is a much lower synthesis temperature than for gas phase, plasma or sol-gel technologies. New reactors have been developed to exploit these advantages of the MSS technology of nanoparticles synthesis and to scale up the production rate. Reactor design and realization has been shown to be decisive and critical for the control of the MSS technology. Examples of oxidic and phosphatic nanoparticles synthesis have been reported.

Optical Properties of Heavily Fluorinated Lanthanide Tris β-Diketonate Phosphine Oxide Adducts

Abstract: The construction of lanthanide(III) chelates that exhibit superior photophysical properties holds great importance in biological and materials science. One strategy to increase the luminescence properties of lanthanide(III) chelates is to hinder competitive non-radiative decay processes through perfluorination of the chelating ligands. Here, the synthesis of two families of heavily fluorinated lanthanide(III) β-diketonate complexes bearing monodentate perfluorinated tris phenyl phosphine oxide ligands have been prepared through a facile one pot reaction [Ln(hfac)3{(ArF)3PO}(H2O)] and [Ln(F7-acac)3{(ArF)3PO}2] (where Ln = Sm3+, Eu3+, Tb3+, Er3+ and Yb3+). Single crystal X-ray diffraction analysis in combination with photophysical studies have been performed to investigate the factors responsible for the differences in the luminescence lifetimes and intrinsic quantum yields of the complexes. Replacement of both bound H2O and C–H oscillators in the ligand backbone has a dramatic effect on the photophysical properties of the complexes, particularly for the near infra-red emitting ion Yb3+, where a five fold increase in luminescence lifetime and quantum yield is observed. The complexes [Sm(hfac)3{(ArF)3PO}(H2O)] (1), [Yb(hfac)3{(ArF)3PO}(H2O)] (5), [Sm(F7-acac)3{(ArF)3PO}2] (6) and [Yb(F7-acac)3{(ArF)3PO}2] (10) exhibit unusually long luminescence lifetimes and attractive intrinsic quantum yields of emission in fluid solution (ΦLn = 3.4% (1); 1.4% (10)) and in the solid state (ΦLn = 8.5% (1); 2.0% (5); 26% (6); 11% (10)), which are amongst the largest values for this class of compounds to date.

Nickel Oxide-Incorporated Polyaniline Nanocomposites as an Efficient Electrode Material for Supercapacitor Application

Abstract: This work reports the facile, controlled, and low-cost synthesis of a nickel oxide and polyaniline (PANI) nanocomposites-based electrode material for supercapacitor application. PANI-NiO nanocomposites with varying concentrations of NiO were synthesized via in-situ chemical oxidative polymerization of aniline. The XRD and FTIR support the interaction of PANI with NiO and the successful formation of the PANI-NiO-x nanocomposite. The SEM analysis showed that the NiO and PANI were mixed homogenously, in which the NiO nanomaterial was incorporated in porous PANI globular nanostructures. The multiple phases of the nanocomposite electrode material enhance the overall performance of the energy-storage behavior of the supercapacitor that was tested in 1 M H2SO4 using cyclic voltammetry (CV), galvanostatic charge-discharge (GCD), and electrochemical impedance spectroscopy (EIS). Among the different nanocomposites, PANI-NiO-3 exhibit the specific capacitance of a 623 F g−1 at 1 A g−1 current density. Furthermore, the PANI-NiO-3 electrode retained 89.4% of its initial capacitance after 5000 cycles of GCD at a 20 A g−1 current density, indicating its significant cyclic stability. Such results suggest that PANI-NiO nanocomposite could be proposed as an appropriate electrode material for supercapacitor applications.