Island Arc 

About: Island Arc is an academic journal published by Wiley-Blackwell. The journal publishes majorly in the area(s): Subduction & Metamorphism. It has an ISSN identifier of 1038-4871. Over the lifetime, 1144 publications have been published receiving 28406 citations.

Paleogeographic maps of the Japanese Islands: Plate tectonic synthesis from 750 Ma to the present

Abstract: A series of paleogeographic maps of the Japanese Islands, from their birth at ca 750–700 Ma to the present, is newly compiled from the viewpoint of plate tectonics. This series consists of 20 maps that cover all of the major events in the geotectonic evolution of Japan. These include the birth of Japan at the rifted continental margin of the Yangtze craton (ca 750-700 Ma), the tectonic inversion of the continental margin from passive to active (ca 500 Ma), the Paleozoic accretionary growth incorporating fragments from seamounts and oceanic plateaux (ca 480-250 Ma), the collision between Sino-Korea and Yangtze (250–210 Ma), the Mesozoic to Cenozoic accretionary growth (210 Ma-present) including the formation of the Cretaceous paired metamorphic belts (90 Ma), and the Miocene back-arc opening of the Japan Sea that separated Japan as an island arc (25-15 Ma).

The seismogenic zone of subduction thrust faults

Abstract: Subduction thrust faults generate earthquakes over a limited depth range. They are aseismic in their seaward updip portions and landward downdip of a critical point. The seaward shallow aseismic zone, commonly beneath accreted sediments, may be a consequence of unconsolidated sediments, especially stable-sliding smectite clays. Such clays are dehydrated and the fault may become seismogenic where the temperature reaches 100--150°C, that is, at a 5--15 km depth. Two factors may determine the downdip seismogenic limit. For subduction of young hot oceanic lithosphere beneath large accretionary sedimentary prisms and beneath continental crust, the transition to aseismic stable sliding is temperature controlled. The maximum temperature for seismic behavior in crustal rocks is ∼ 350°C, regardless of the presence of water. In addition, great earthquake ruptures initiated at less than this temperature may propagate with decreasing slip to where the temperature is ∼ 450°C. For subduction beneath thin island arc crust and beneath continental crust in some areas, the forearc mantle is reached by the thrust shallower than the 350°C temperature. The forearc upper mantle probably is aseismic because of stable-sliding serpentinite hydrated by water from the underthrusting oceanic crust and sediments. For many subduction zones the downdip seismogenic width defined by these limits is much less than previously assumed. Within the narrowly defined seismic zone, most of the convergence may occur in earthquakes. Numerical thermal models have been employed to estimate temperatures on the subduction thrust planes of four continental subduction zones. For Cascadia and Southwest Japan where very young and hot plates are subducting, the downdip seismogenic limit on the subduction thrust is thermally controlled and is shallow. For Alaska and most of Chile, the forearc mantle is reached before the critical temperature, and mantle serpentinite provides the limit. In all four regions, the seismogenic zones so defined agree with estimates of the extent of great earthquake rupture, and with the downdip extent of the interseismic locked zone.

The Heilongjiang Group: A Jurassic accretionary complex in the Jiamusi Massif at the western Pacific margin of northeastern China

Abstract: The tectonic setting of the Eastern Asian continental margin in the Jurassic is highly controversial. In the current study, we have selected the Heilongjiang complex located at the western margin of the Jiamusi Massif in northeastern China for geochronological investigation to address this issue. Field and petrographic investigations indicate that the Heilongjiang complex is composed predominately of granitic gneiss, marble, mafic-ultramafic rocks, blueschist, greenschist, quartzite, muscovite-albite schist and two-mica schist that were tectonically interleaved, indicating they represent a melange. The marble, two-mica schist and granitic gneiss were most probably derived from the Mashan complex, a high-grade gneiss complex in the Jiamusi Massif with which the Heilongjiang Group is intimately associated. The ultramafic rocks, blueschist, greenschist and quartzite (chert) are similar to components in ophiolite. The sensitive high mass-resolution ion microprobe U-Pb zircon age of 265 ± 4 Ma for the granitic gneiss indicates that the protolith granite was emplaced coevally with Permian batholiths in the Jiamusi Massif. 40Ar/39Ar dating of biotite and phengite from the granitic gneiss and mica schist yields a late Early Jurassic metamorphic age between 184 and 174 Ma. Early components of the Jiamusi Massif, including the Mashan complex, probably formed part of an exotic block from Gondwana, affected by late Pan-African orogenesis, and collided with the Asian continental margin during the Early Jurassic. Subduction of oceanic crust between the Jiamusi block and the eastern part of the Central Asian Orogenic Belt resulted in the formation of a huge volume of Jurassic granites in the Zhangguangcai Range. Consequently, the collision of the Jiamusi Massif with the Central Asian Orogenic Belt to the west can be considered as the result of circum-Pacific accretion, unrelated to the Central Asian Orogenic Belt. The widespread development of Jurassic accretionary complexes along the Asian continental margin supports such an interpretation.

Pacific-type orogeny revisited : Miyashiro-type orogeny proposed

Abstract: The concept of Pacific-type orogeny is revised, based on an assessment of geologic data collected from the Japanese Islands during the past 25 years. The formation of a passive continental margin after the birth of the Pacific Ocean at 600 Ma was followed by the initiation of oceanic plate subduction at 450 Ma. Since then, four episodes of Pacific-type orogeny have occurred to create an orogenic belt 400 km wide that gradually grew both oceanward and downward. The orogenic belt consists mainly of an accretionary complex tectonically interlayered with thin (<2 km thick), subhorizontal, high-P/T regional metamorphic belts. Both the accretionary complex and the high-P/T rocks were intruded by granitoids ∼100 million years after the formation of the accretionary complex. The intrusion of calc-alkaline (CA) plutons was synchronous with the exhumation of high-P/T schist belts. Ages from microfossils and K-Ar analysis suggest that the orogenic climax happened at a time of mid-oceanic ridge subduction. The orogenic climax was characterized by the formation of major subhorizontal orogenic structures, the exhumation of high-P/T schist belts by wedge extrusion and subsequent domed uplift, and the intrusion-extrusion of CA magma dominantly produced by slab melting. The orogenic climax ended soon after ridge subduction, and thereafter a new Pacific-type orogeny began. A single Pacific-type orogenic cycle may correspond to the interaction of the Asian continental margin with one major Pacific oceanic plate. Ophiolites in Japan occur as accreted material and are not of island-arc but of plume origin. They presumably formed after the birth of the southern Pacific superplume at 600 Ma, and did not modify the cordilleran-type orogeny in a major way. Microplates, fore-arc slivers, intra-oceanic arc collisions and the opening of back-arc basins clearly contributed to cordilleran orogenesis. However, they were of secondary importance and served only to modify pre-existing major orogenic components. The most important cause of cordilleran-type orogeny is the subduction of a mid-oceanic ridge, by which the volume of continental crust increases through the transfer of granitic melt from the subducting oceanic crust to an orogenic welt. Accretionary complexes are composed mainly of recycled granitic sediments with minor amounts of oceanic material, which indicate that the accretion of oceanic material, including huge oceanic plateaus, was not significant for orogenic growth. Instead, the formation and intrusion of granitoids are the keys to continental growth, which is the most important process in Pacific-type orogeny. Collision-type orogeny does not increase the volume of continental crust. The name ‘Miyashiro-type orogeny’ is proposed for this revised concept of Pacific-type or cordilleran-type orogeny, in order to commemorate Professor A. Miyashiro's many contributions to a better understanding of orogenesis.

Anatomy and genesis of a subduction‐related orogen: A new view of geotectonic subdivision and evolution of the Japanese Islands

Abstract: The Japanese Islands represent a segment of a 450 million year old subduction-related orogen developed along the western Pacific convergent margin. The geotectonic subdivision of the Japanese Islands is newly revised on the basis of recent progress in the 1980s utilizing microfossil and chronometric mapping methods for ancient accretionary complexes and their high-P/T metamorphic equivalents. This new subdivision is based on accretion tectonics, and it contrasts strikingly with previous schemes based on 'geosyncline' tectonics, continent-continent collision-related tectonics, or terrane tectonics. Most of the geotectonic units in Japan are composed of Late Paleozoic to Cenozoic accretionary complexes and their high-PIT metamorphic equivalents, except for two units representing fragments of Precambrian cratons, which were detached from mainland Asia in the Tertiary. These ancient accretionary complexes are identified using the method of oceanic plate stratigraphy. The Japanese Islands are comprised of 12 geotectonic units, all noted in southwest Japan, five of which have along-arc equivalents in the Ryukyus. Northeast Japan has nine of these 12 geotectonic units, and East Hokkaido has three of these units. Recent field observations have shown that most of the primary geotectonic boundaries are demarcated by low-angle faults, and sometimes modified by second- ary vertical normal and/or strike-slip faults. On the basis of these new observations, the tectonic evolution of the Japanese Islands is summarized in the following stages: (i) birth at a rifted Yangtze continental margin at ca 750-700 Ma; (ii) tectonic inversion from passive margin to active margin around 500 Ma; (iii) successive oceanic subduction beginning at 450 Ma and continuing to the present time; and (iv) isolation from mainland Asia by back-arc spreading at ca 20 Ma. In addition, a continent-continent collision occurred between the Yangtze and Sino- Korean cratons at 250 Ma during stage three. Five characteristic features of the 450 Ma subduction-related orogen are newly recognized here: (i) step-wise (not steady-state) growth of ancient accretionary complexes; (ii) subhorizontal piled nappe structure; (iii) tectonically downward-younging polarity; (iv) intermittent exhumation of high-P/T metamorphosed accre- tionary complex; and (v) microplate-induced modification. These features suggest that the subduction-related orogenic growth in Japan resulted from highly episodic processes. The episodic exhumation of high-P/T units and the formation of associated granitic batholith (i.e. formation of paired metamorphic belts) occurred approximately every 100 million years, and the timing of such orogenic culmination apparently coincides with episodic ridge subduction beneath Asia.