Showing papers in "Journal of Asian Ceramic Societies in 2016"
TL;DR: Indium tin oxide (ITO) thin films have been prepared by jet nebulizer spray pyrolysis technique for different Sn concentrations on glass substrates as mentioned in this paper, which reveal that all the films are polycrystalline of cubic structure with preferentially oriented along (222) plane.
194 citations
TL;DR: The effect of nano-clay platelets (Cloisite 30B) on the mechanical and thermal properties of fly ash geopolymer nano-composites has been investigated in this paper.
129 citations
TL;DR: In this article, a thin film was deposited onto the glass substrate by simple and economic SILAR method and its structural, morphological, optical and electrical properti cities were analyzed.
108 citations
TL;DR: In this article, a method to synthesize silica nanoparticles from bentonite clay was reported, where a series of thermal and acid treatment processes were performed on the clay to lower the alumina and increase the silica content.
90 citations
TL;DR: In this paper, the synthesis of HA powder using dicalcium phosphate dehydrate (CaHPO 4 ·2H 2 O, DCPD) via ball milling and subsequent heat treatment was demonstrated.
82 citations
TL;DR: Friction stir processing (FSP) was applied to produce aluminum matrix composites (AMCs) in this article, where aluminum alloy AA6082 was used as the matrix material and various ceramic particles, such as SiC, Al2O3, TiC, B...
74 citations
TL;DR: In this article, the applicability of rice husk ash (RHA), as silica (SiO 2 ) source, in refractory and porous materials with potential structural, insulating and/or filtering applications was carried out by characterizing the ceramic behavior of stoichiometric mixtures of calcined alumina (Al 2 O 3 ) and RHA.
69 citations
TL;DR: In this article, the effect of precursor concentration (mc) on the structural, optical, morphological and electrical conductivity properties of In2S3 thin films grown on amorphous glass substrates by nebulized spray pyrolysis (NSP) technique was investigated.
65 citations
TL;DR: In this article, the description and characterization of magnesite (MgCO3) and dolomite (mg,Ca(CO3)) and their contribution in industrial ceramics-refractories have been reviewed.
60 citations
TL;DR: Transparent conducting Tin doped Cadmium oxide thin films were prepared by sol-gel spin coating method with different Sn concentrations as discussed by the authors, and X-ray diffraction analysis revealed the polycrystalline natur...
58 citations
TL;DR: In this article, low cost ceramic supports were prepared from kaolin via phase inversion technique with two kaolin particle sizes, which are 0.04-0.05μm, respectively and exhibited ideal porosity (27.7%), great mechanical strength (98.9MPa) and excellent gas permeation.
TL;DR: In this article, friction stir processing (FSP) has been used as a potential method to produce aluminum matrix composites (AMCs) without the drawbacks of liquid metallurgy methods.
TL;DR: A near MPB composition of 0.64PMN-0.36PT ceramic has been synthesized by solid-state reaction technique using columbite precursor as discussed by the authors, which resulted in a single perovskite phase with te...
TL;DR: In this paper, mesoporous NiO nanosheets were prepared by a facile sol-gel process using Aerosol-OT, Bis(2-ethyl hexyl) sulfosuccinate sodium salt (AOT) as anionic surfactant.
TL;DR: In this paper, the influence of CeO2, Nd2O3, SmO3 and GdO3 on various properties of the melt-quench route derived from SiO2 glass have been investigated.
TL;DR: LiNiPO 4 and Co-doped LiNi0.5 Co 0.5 PO 4 are synthesized by solid-state reaction method under air atmosphere and all the X-ray diffraction peaks of both the compounds are indexed and it is found that the samples are well crystallized in orthorhombic olivine structure belonging to the space group Pnma as discussed by the authors.
TL;DR: Clay-alumina compositions of 0, 20, 40 and 55 weight percent (wt%) clay and rest alumina were maintained in porous support preparation by extrusion followed by sintering at 1300°C for 2.5h to obt...
TL;DR: In this paper, the results showed that by increasing the TiO 2 content, glass transition temperature (T g ), both the crystallization peak temperature ( T p I and T p II ) and activation energy ( E ) increased.
TL;DR: In this article, the substrate temperature influenced change in the structural, optical, morphological, and electrical conductivity properties of CdIn2S4 thin films deposited on amorphous glass substrates by nebulized spray pyrolysis (NSP) technique.
TL;DR: In this article, the dielectric properties of chalcogenide glassy alloys have been studied using impedance spectroscopic technique in the frequency range 42 Hz to 5 MHz at room temperature.
TL;DR: ZrO2 nanopowders were synthesized by low temperature solution combustion method using two different fuels namely glycine and oxalyldihydrazide (ODH) as discussed by the authors.
TL;DR: In this paper, a solution combustion method was used to synthesize SrTiO 3 nanoparticles and the removal of malachite green (MG) azo dye from the aqueous solution.
TL;DR: In this paper, the maximum energy conversion density of 305 kJ/m3 per cycle was obtained for BCT-BZT-Fe (0.5% Fe content) when the cycle was operated between 30 and 110 °C and an electric field of 0-3 MV/m.
TL;DR: In this article, the loading of silver sulfadiazine into ordered mesoporous silica material by post-impregnation method and its effect on the in vitro release kinetics and antimicrobial property of the drug were investigated.
TL;DR: In this paper, Electrochromic tungsten trioxide (WO3) thin films are attracted renewed attention as transmittance-controllable windows for use in automobile, aircraft, and building applications.
TL;DR: In this article, the effects of the change of temperature, soaking time and clay addition on some physical ceramic properties (shrinkage, water absorption and compressive strength) were assessed.
TL;DR: In this article, the thermal fatigue behavior of ZrB2-SiC coated C/SiC composites was studied and the composition of the coating lay out was described.
TL;DR: In this article, the MgAl 2 O 4 nanocrystalline powder was synthesized using naturally available egg white and inexpensive metal nitrate salts, and the calcination temperature of as-synthesized powder was set at 600°C.
TL;DR: PdO/CeO2/ZrO2-NiO/γ-Al2O3 catalysts were prepared for the combustion of methane at moderate temperatures as mentioned in this paper.
TL;DR: In this article, spherical nanoparticles of the BaTiO3polyvinylpyrrolidone (BT-PVP) composite were synthesized through surface modification of the oxide BT by the polymer PVP, using TiCl4, BaCl2, and BaCl3.