scispace - formally typeset
Open AccessJournal ArticleDOI

Appearance of Ferromagnetic Property for Si Nanopolycrystalline Body and Vanishing of Electrical Resistances at Local High Frequencies

Taku Saiki, +2 more
- 25 Nov 2018 - 
- Vol. 2018, pp 1-12
Reads0
Chats0
TLDR
In this article, the reduction in the skin effect for the sintered Si nanopolycrystalline body as an electricity conductor at a high frequency due to its nanostructure was studied.
Abstract
Reduction in the skin effect for the sintered Si nanopolycrystalline body as an electricity conductor at a high frequency due to its nanostructure was studied. Singular disappearance of electrical resistances near a local high magnetic harmonic frequency of a few MHz was observed. This phenomenon has not been observed for conventional ferromagnetic metals. The measured electrical resistances changed to almost 0 mΩ at room temperature. At the same time, negative resistance of the sintered Si nanopolycrystalline body was observed. It will be applicable to electronic transmittance lines or semiconductors. Numerical calculation was also performed on the electrical resistance with frequency dependency while considering the electric field and magnetic field in the sintered Si nanopolycrystalline body. The experimental and calculated results are compared. The calculation could explain the variation of the relative permittivity of the Si nanopolycrystalline body and the phenomenon for the theoretical disappearance of the resistivity at the MHz frequency. Reduced Si nanoparticles from SiO2 powder were synthesized by laser ablation in liquid. A Si nanopolycrystalline body made of the reduced Si nanoparticles was fabricated. It was found by measuring the magnetization property of the body of the sintered Si nanopolycrystalline body which is ferromagnetic. Dangling bonds (unpaired electrons) have long been known to occur due to defects in Si crystals. Perfect Si without defective crystals has no dangling bonds. However, Si nanoparticles have many dangling bonds. High-density dangling bonds cause the sintered Si nanopolycrystalline body to have ferromagnetism. In this study, the density of the unpaired electrons in the sintered Si nanopolycrystalline body was observed using ESR. It has been clarified that the Si nanopowder and the sintered Si nanopolycrystalline body have numerous dangling bonds. Both densities of the dangling bonds were evaluated.

read more

Citations
More filters
Journal ArticleDOI

Axial-Flux Generator Using a Sintered Iron Nano-Polycrystalline Body

TL;DR: In this paper, the magnetization property of the core inductor at the direct current was investigated and it was shown that Fe nanoparticles were produced from iron oxide particles by high voltage pulse or laser ablation in liquids.
References
More filters
Journal ArticleDOI

Silicon quantum wire array fabrication by electrochemical and chemical dissolution of wafers

TL;DR: In this paper, free standing Si quantum wires can be fabricated without the use of epitaxial deposition or lithography using electrochemical and chemical dissolution steps to define networks of isolated wires out of bulk wafers.
Journal ArticleDOI

Size effect on the melting temperature of gold particles

TL;DR: In this article, the melting points of small gold particles have been measured using a scanning electron-diffraction technique and the experimental results are quantitatively in good agreement with two phenomenological models.
Journal ArticleDOI

Electrooptical effects in silicon

TL;DR: In this article, a numerical Kramers-Kronig analysis is used to predict the refractive index perturbations produced in crystalline silicon by applied electric fields or by charge carriers.
Journal ArticleDOI

Physicochemical properties of small metal particles in solution: "microelectrode" reactions, chemisorption, composite metal particles, and the atom-to-metal transition

TL;DR: In this paper, the effects of surface modification on colloidal metal particles in aqueous solution were investigated. And the resulting changes in the chemical, photochemical, and optical properties were discussed.
Related Papers (5)