Catalytic activity of MOF(2Fe/Co)/carbon aerogel for improving H2O2 and OH generation in solar photo–electro–Fenton process
TL;DR: In this article, a bifunctional MOF(2Fe/Co)/CA cathode with a high surface possessing area, and good electrocatalytic and photocatalytic activity, was proposed for the solar photoelectro-Fenton (SPEF) process.
Abstract: A novel bifunctional MOF(2Fe/Co)/CA cathode with a high surface possessing area, and good electrocatalytic and photocatalytic activity, was proposed for the solar photo–electro–Fenton (SPEF) process. The optimal nFe: nCo ratio was 2:1 for successfully introducing MOF(2Fe/Co) on the surface of CA, which is due to the specific interaction affinity of FeOOH between MOF(2Fe/Co) and CA. Continuous on–site generation of H2O2 through an oxygen reduction reaction (ORR) was achieved over the CA cathode. The electron transfer number (n) of the ORR with CA was 2.5 in the selected potential range. Moreover, the addition of MOF can behave as the active sites for enhancing the ORR activity and hence can increase the yield of the H2O2. Simultaneously, the photoinduced electron (ecb−) of MOF(2Fe/Co) efficiently in–situ decomposed H2O2 to form hydroxyl radicals (OH). The observation indicated that the ecb− is an efficient and new Fenton–like catalysts that is pH–independent. Efficient photo–electro–catalytic performance was exhibited when applied to degrade Rhodamine B (RhB) and dimethyl phthalate (DMP). Almost 100% RhB removal and 85% DMP removal were reached in 45 min and 120 min, respectively. The MOF(Fe/Co)/CA presented very low iron and cobalt leaching (<0.5 ppm) even in an acidic media, and it retained an efficient degradation efficiency in the wide pH range of 3–9.
Citations
More filters
TL;DR: In this article, the fundamental principles and applications of heterogeneous electrochemical wastewater treatment based on Fenton's chemistry reaction are discussed and the required features of good heterogeneous catalysts are discussed, followed by the mechanisms of catalytic activation of H2O2 to reactive oxygen species (ROS) especially hydroxyl radical ( OH) by heterogeneous catalyst in Hetero-EF system.
Abstract: This exhaustive review focuses on the fundamental principles and applications of heterogeneous electrochemical wastewater treatment based on Fenton’s chemistry reaction. The elementary equations involved in formation of hydroxyl radical in homogeneous electro-Fenton (EF) and photo electro-Fenton (PEF) processes was presented and the advantages of using insoluble solids as heterogeneous catalyst rather than soluble iron salts (heterogeneous electro-Fenton process) (Hetero-EF) was enumerated. Some of the required features of good heterogeneous catalysts were discussed, followed by the mechanisms of catalytic activation of H2O2 to reactive oxygen species (ROS) especially hydroxyl radical ( OH) by heterogeneous catalyst in Hetero-EF system. Extensive discussion on the two configuration of Hetero-EF system vis-a-vis added solid catalysts and functionalized cathodic materials were provided along with summaries of some relevant studies that are available in literature. The solid catalysts and the functionalized cathodic materials that have been utilized in Hetero-EF wastewater treatment were grouped into different classes and brief discussion on their synthesis route were given. Besides, the use of solid catalysts and iron-functionalized cathodic materials in bioelectrochemical system (BES) especially bioelectro-Fenton technology (BEF) using microbial fuel cells (MFCs) with concurrent electricity generation for Hetero-EF treatment of biorefractory organic pollutants was discussed. In the final part, emphasis was made on the challenges and future prospects of the Hetero-EF for wastewater treatment.
574 citations
TL;DR: A review of metal-organic frameworks (MOFs) and their applications can be found in this paper, where the advantages of MOF-based hydrogels and aerogels in applications such as sensors, batteries, supercapacitors, adsorbents, catalysts etc.
381 citations
TL;DR: A heterogeneous catalyst system for enhanced meethanol productivity in methane oxidation by in situ generated hydrogen peroxide at mild temperature (70°C) and methanol selectivity reached 92%, corresponding to methanl productivity up to 91.6 millimoles per gram of AuPd per hour.
Abstract: Selective partial oxidation of methane to methanol suffers from low efficiency. Here, we report a heterogeneous catalyst system for enhanced methanol productivity in methane oxidation by in situ generated hydrogen peroxide at mild temperature (70°C). The catalyst was synthesized by fixation of AuPd alloy nanoparticles within aluminosilicate zeolite crystals, followed by modification of the external surface of the zeolite with organosilanes. The silanes appear to allow diffusion of hydrogen, oxygen, and methane to the catalyst active sites, while confining the generated peroxide there to enhance its reaction probability. At 17.3% conversion of methane, methanol selectivity reached 92%, corresponding to methanol productivity up to 91.6 millimoles per gram of AuPd per hour.
366 citations
TL;DR: The use of metal-organic frameworks (MOFs) or MOF composites as catalysts for Fenton-like catalysis has received increasing attention due to their permanent porosity and tunable open metal centers as mentioned in this paper.
364 citations
TL;DR: This review will deepen the understanding of the tacit cooperation between the in situ production and utilization of H2O2 in Fenton process, and provide the further insight into this promising process for degradation of emerging contaminants in industrial wastewater.
311 citations
References
More filters
TL;DR: This paper presents a probabilistic procedure for estimating the polymethine content of carbon dioxide using a straightforward two-step procedure, and shows good results in both the stationary and the liquid phase.
Abstract: Liming Dai,*,†,‡ Yuhua Xue,†,‡ Liangti Qu,* Hyun-Jung Choi, and Jong-Beom Baek* †Center of Advanced Science and Engineering for Carbon (Case4Carbon), Department of Macromolecular Science and Engineering, Case Western Reserve University, 10900 Euclid Avenue, Cleveland, Ohio 44106, United States Key Laboratory of Cluster Science, Ministry of Education of China, Beijing Key Laboratory of Photoelectronic/Electrophotonic Conversion Materials, Department of Chemistry, School of Science, Beijing Institute of Technology, Beijing 100081, People’s Republic of China School of Energy and Chemical Engineering/Center for Dimension-Controllable Covalent Organic Frameworks, Ulsan National Institute of Science and Technology (UNIST), 100 Banyeon, Ulsan, 689-798, South Korea
1,967 citations
TL;DR: The role of metal-organic frameworks (MOFs) in the field of catalysis is discussed, and special focus is placed on their assets and limits in light of current challenges in catalysis and green chemistry.
Abstract: The role of metal-organic frameworks (MOFs) in the field of catalysis is discussed, and special focus is placed on their assets and limits in light of current challenges in catalysis and green chemistry. Their structural and dynamic features are presented in terms of catalytic functions along with how MOFs can be designed to bridge the gap between zeolites and enzymes. The contributions of MOFs to the field of catalysis are comprehensively reviewed and a list of catalytic candidates is given. The subject is presented from a multidisciplinary point of view covering solid-state chemistry, materials science, and catalysis.
1,676 citations
TL;DR: In this paper, a review of the application of metal-organic frameworks (MOFs) in photocatalytic degradation of organic pollutants is presented, where the reported examples are collected and analyzed; and the reaction mechanism, the influence of various factors on the catalytic performance, involved challenges, and the prospect are discussed and estimated.
Abstract: Efficient removal of organic pollutants from wastewater has become a hot research topic due to its ecological and environmental importance. Traditional water treatment methods such as adsorption, coagulation, and membrane separation suffer from high operating costs, and even generate secondary pollutants. Photocatalysis on semiconductor catalysts (TiO2, ZnO, Fe2O3, CdS, GaP, and ZnS) has demonstrated efficiency in degrading a wide range of organic pollutants into biodegradable or less toxic organic compounds, as well as inorganic CO2, H2O, NO3−, PO43−, and halide ions. However, the difficult post-separation, easy agglomeration, and low solar energy conversion efficiency of these inorganic catalysts limit their large scale applications. Exploitation of new catalysts has been attracting great attention in the related research communities. In the past two decades, a class of newly-developed inorganic–organic hybrid porous materials, namely metal–organic frameworks (MOFs) has generated rapid development due to their versatile applications such as in catalysis and separation. Recent research has showed that these materials, acting as catalysts, are quite effective in the photocatalytic degradation of organic pollutants. This review highlights research progress in the application of MOFs in this area. The reported examples are collected and analyzed; and the reaction mechanism, the influence of various factors on the catalytic performance, the involved challenges, and the prospect are discussed and estimated. It is clear that MOFs have a bright future in photocatalysis for pollutant degradation.
1,338 citations
TL;DR: This review summarizes the recent literatures on the adsorptive removal of various hazardous compounds mainly from fuel, water, and air by virgin or modified MOF materials.
1,121 citations
TL;DR: The adsorptive purifications of contaminated water with MOFs are discussed, in order to understand possible applications of MOFs in clean water provision and plausible adsorption or interaction mechanisms and selective adsorptions are summarized.
1,088 citations