Journal ArticleDOI
Cavitation behavior of an Al−Cu eutectic alloy during superplastic deformation
Reads0
Chats0
TLDR
In this article, the cavities were spherical in most cases, which was attributed to the diffusion-controlled cavity growth mechanism and its modification when the cavity size reaches the size of a grain.Abstract:
Cavitation behavior upon deformation of an Al−Cu eutectic alloy was studied by densitometry and quantitative microscopy. Tensile specimens were strained to different strain levels at constant strain rates and temperatures over the range of 10−5 to 10−2 s−1 and 400° to 540 °C, respectively. The cavity volume increased with increasing strain and strain rate but decreased with increasing temperature. The increase in cavity volume occurred through an increase in both the number and size of cavities. The cavities were spherical in most of the cases, which was attributed to the diffusion-controlled cavity growth mechanism and its modification when the cavity size reaches the size of a grain. The number and volume of cavities were used to evaluate the nature of the cavity nucleation rate and the level of pre-existing cavities.read more
Citations
More filters
Journal ArticleDOI
Tensile ductility of superplastic ceramics and metallic alloys
TL;DR: In this paper, the tensile ductility of superplastic ceramics and metallic alloys was investigated and the authors showed that tensile deformation is not only a function of the strain-rate-sensitivity exponent, but also a factor of the parameter ⋗e exp (Qc/RT), where Qc is the steady-state strain rate and RT is the activation energy for super-plastic flow.
Journal ArticleDOI
Cavitation during grain-boundary-sliding deformation in an AZ61 magnesium alloy
TL;DR: In this article, a relatively coarse-grained AZ61 alloy deformed under two conditions for which grain-boundary sliding (GBS) creep controlled plastic flow and which produced the same flow stress of 10MPa.
Journal ArticleDOI
The characteristics of cavitation in superplastic metals and ceramics
Yan Ma,Terence G. Langdon +1 more
TL;DR: In this article, the size, shape, and configuration of internal cavities in superplastic metals and ceramics after deformation at high temperatures were investigated using a quantitative metallographic procedure and scanning video images.
Journal ArticleDOI
Experimental Investigation of Cavitation Behavior in AZ61 Magnesium Alloy
TL;DR: In this paper, the authors investigated the rate of cavitation with superplastic strain for a super-plastic AZ61 magnesium alloy at a strain rate of 2 × 10 - 4 s - 1 and temperature of 648 K, under the conditions of which an elongation of more than 250% has been found.
Journal ArticleDOI
Grain growth behaviour of the Al-Cu eutectic alloy during superplastic deformation
TL;DR: Grain growth behavior of the Al-Cu eutectic alloy was investigated as a function of strain (e), strain rate and deformation temperature (T) over as discussed by the authors, where grain size increases with increase in strain and temperature.
Related Papers (5)
The cavitation behavior of a coarse-grained Al5052 alloy under hot uniaxial and equibiaxial tension
Kk K. Chow,Kc C. Chan +1 more
Cavitation Behavior in Superplastically Deformed Zn-22 mass%Al Alloy at Room Temperature
Tsutomu Tanaka,Kenji Higashi +1 more