Proceedings Article•
DC microgrid based distribution power generation system
01 Jan 2004-Vol. 3, pp 1740-1745
TL;DR: In this article, an autonomous control method for a DC microgrid system having distribution power generators is described, which brings high reliability, high-flexibility and maintenance-free operation to the system.
Abstract: This paper describes an autonomous-control method for a DC microgrid system having distribution power generators. This system consists of following five generation and control units; a solar-cell generation unit, a wind-turbine generation unit, a battery energy-storage unit, a flywheel power-leveling unit, and an AC grid-connected power control unit. The proposed control method intended for suppression of circulating current detects only the DC grid voltage. Each unit could be controlled autonomously without communicating each other. This method brings high reliability, high-flexibility and maintenance-free operation to the system. Experimental results from a 10 kW-prototype system verify the validity and effectiveness of the proposed control method.
Citations
More filters
01 Nov 2009
TL;DR: The hierarchical control derived from ISA-95 and electrical dispatching standards to endow smartness and flexibility to MGs is presented and results are provided to show the feasibility of the proposed approach.
Abstract: DC and AC Microgrids are key elements to integrate renewable and distributed energy resources as well as distributed energy storage systems. In the last years, efforts toward the standardization of these Microgrids have been made. In this sense, this paper present the hierarchical control derived from ISA-95 and electrical dispatching standards to endow smartness and flexibility to microgrids. The hierarchical control proposed consist of three levels: i) the primary control is based on the droop method, including an output impedance virtual loop; ii) the secondary control allows restoring the deviations produced by the primary control; and iii) the tertiary control manage the power flow between the microgrid and the external electrical distribution system. Results from a hierarchical-controlled microgrid are provided to show the feasibility of the proposed approach.
4,145 citations
TL;DR: In this article, an overview of the state of the art in dc microgrid protection and grounding is provided, which discusses both design of practical protective devices and their integration into overall protection systems.
Abstract: DC microgrids (MGs) have been gaining a continually increasing interest over the past couple of years both in academia and industry. The advantages of dc distribution when compared to its ac counterpart are well known. The most important ones include higher reliability and efficiency, simpler control and natural interface with renewable energy sources, and electronic loads and energy storage systems. With rapid emergence of these components in modern power systems, the importance of dc in today's society is gradually being brought to a whole new level. A broad class of traditional dc distribution applications, such as traction, telecom, vehicular, and distributed power systems can be classified under dc MG framework and ongoing development, and expansion of the field is largely influenced by concepts used over there. This paper aims first to shed light on the practical design aspects of dc MG technology concerning typical power hardware topologies and their suitability for different emerging smart grid applications. Then, an overview of the state of the art in dc MG protection and grounding is provided. Owing to the fact that there is no zero-current crossing, an arc that appears upon breaking dc current cannot be extinguished naturally, making the protection of dc MGs a challenging problem. In relation with this, a comprehensive overview of protection schemes, which discusses both design of practical protective devices and their integration into overall protection systems, is provided. Closely coupled with protection, conflicting grounding objectives, e.g., minimization of stray current and common-mode voltage, are explained and several practical solutions are presented. Also, standardization efforts for dc systems are addressed. Finally, concluding remarks and important future research directions are pointed out.
964 citations
Cites background from "DC microgrid based distribution pow..."
...of 10 kW in 2004, claiming for simpler control, while superior efficiency and reliability with regard to its ac counterpart [63]....
[...]
TL;DR: In this paper, a low-voltage bipolar-type dc microgrid is proposed to supply super high quality power with three-wire dc distribution line. But, the proposed system is not suitable for large-scale systems.
Abstract: Microgrid is one of the new conceptual power systems for smooth installation of many distributed generations (DGs). While most of the microgrids adopt ac distribution as well as conventional power systems, dc microgrids are proposed and researched for the good connection with dc output type sources such as photovoltaic (PV) system, fuel cell, and secondary battery. Moreover, if loads in the system are supplied with dc power, the conversion losses from sources to loads are reduced compared with ac microgrid. As one of the dc microgrids, we propose “low-voltage bipolar-type dc microgrid,” which can supply super high quality power with three-wire dc distribution line. In this paper, one system for a residential complex is presented as an instance of the dc microgrid. In this system, each house has a cogeneration system (CGS) such as gas engine and fuel cell. The output electric power is shared among the houses, and the total power can be controlled by changing the running number of CGSs. Super capacitors are chosen as main energy storage. To confirm the fundamental characteristics and system operations, we experimented with a laboratory scale system. The results showed that the proposed system could supply high-quality power under several conditions.
880 citations
Cites background from "DC microgrid based distribution pow..."
...Therefore, dc distribution-type microgrids (dc microgrids) were also proposed and researched in order to reduce conversion losses from the sources to loads [11]– [15]....
[...]
TL;DR: This paper presents a review of issues concerning microgrid issues and provides an account of research in areas related to microgrids, including distributed generation, microgrid value propositions, applications of power electronics, economic issues, micro grid operation and control, micro grids clusters, and protection and communications issues.
Abstract: The significant benefits associated with microgrids have led to vast efforts to expand their penetration in electric power systems. Although their deployment is rapidly growing, there are still many challenges to efficiently design, control, and operate microgrids when connected to the grid, and also when in islanded mode, where extensive research activities are underway to tackle these issues. It is necessary to have an across-the-board view of the microgrid integration in power systems. This paper presents a review of issues concerning microgrids and provides an account of research in areas related to microgrids, including distributed generation, microgrid value propositions, applications of power electronics, economic issues, microgrid operation and control, microgrid clusters, and protection and communications issues.
875 citations
Cites methods from "DC microgrid based distribution pow..."
...Only locally measured data are used by DGs where no communication is needed for load sharing....
[...]
TL;DR: In this article, the authors reviewed the researches and studies on MG technology and the operation of MG and the MG in the market environment, and also described the MG's performance in the real world.
Abstract: The distributed energy resources (DER) comprise several technologies, such as diesel engines, micro turbines, fuel cells, photovoltaic, small wind turbines, etc. The coordinated operation and control of DER together with controllable loads and storage devices, such as flywheels, energy capacitors and batteries are central to the concept of MicroGrid (MG). MG can operate interconnected to the main distribution grid, or in an islanded mode. This paper reviews the researches and studies on MG technology. The operation of MG and the MG in the market environment are also described in the paper.
763 citations