scispace - formally typeset
Journal ArticleDOI

Effects of eddy currents in transformer windings

P.L. Dowell
- Vol. 113, Iss: 8, pp 1387-1394
Reads0
Chats0
TLDR
In this article, the effect of eddy currents on transformer windings is considered and a method is derived for calculating the variation of winding resistance and leakage inductance with frequency for transformers with single-layer, multilayer and sectionalised windings.
Abstract
The effects of eddy currents in transformer windings are considered, and a method is derived for calculating the variation of winding resistance and leakage inductance with frequency for transformers with single-layer, multilayer and sectionalised windings. The method consists in dividing the winding into portions, calculating the d.c. resistances and d.c. leakage inductances of each of these portions, and then multiplying the d.c. values by appropriate factors to obtain the corresponding a.c. values. These a.c. values are then referred to, say, the primary winding and summed to give the total winding resistance and leakage inductance of the transformer. Formulas are derived and quoted for calculating the d.c. resistances and leakage inductances of the winding portions. Theoretical expressions are derived for the variation with frequency etc. of the factors by which the d.c. values must be multiplied to obtain the corresponding a.c. values. These expressions are presented in the form of graphs, permitting the factors to be read as required.

read more

Citations
More filters
Proceedings ArticleDOI

High-power compact capacitor charger

TL;DR: In this paper, the authors reported a new design for a compact high power Capacitor charger with a power output that far exceeds the peak power of previously reported designs, and evaluated parallel modular designs with separate inverters, transformers, and rectifiers.
Journal ArticleDOI

A Novel Pyramid Winding for PCB Planar Inductors With Fewer Copper Layers and Lower AC Copper Loss

TL;DR: Huang et al. as discussed by the authors improved the Ferreira's 1-D copper loss model to accommodate the core feature of PCB winding, which is variable number of turns per layer.
Dissertation

MEMS) toroidal magnetics for integrated power electronics

TL;DR: In this article, the authors present the derivation of models for stored energy, resistance and parasitic capacitance of micro-fabricated toroidal inductors developed for use in integrated power electronics.
Proceedings ArticleDOI

Reduction of winding losses for trapezoidal periodic currents

TL;DR: Based on a quasi-static magnetic field solution for a rotor winding carrying trapezoidal periodic currents, power losses analytical solution is discussed in this paper, where the winding is placed in an open rectangular slot.
References
More filters
Journal ArticleDOI

Effective resistance to alternating currents of multilayer windings

TL;DR: In this article, a multilayer winding carrying an alternating current, such as the windings illustrated in figures 1, 2, and 3, each layer of copper lies in the alternating magnetic field set up by the current in all the other layers.
Journal ArticleDOI

Eddy Currents in Large Slot-Wound Conductors

TL;DR: In this article, the authors discuss the more important causes of eddy currents in heavy conductors carrying alternating currents and surrounded on three sides by iron, and propose a method to identify the most important causes.
Journal ArticleDOI

Eddy-Current Losses in Cylindrical Conductors, with Special Applications to the Alternating Current Resistances of Short Coils

TL;DR: In this article, it is shown that a considerable proportion of the effective resistance of inductive coils when used at radio frequencies is caused by the eddy-currents set up in the wires of the coils by the alternating magnetic field in which they are situated, and that in extreme cases the alternating current resistance may amount to more than one hundred times the direct current resistance.
Journal ArticleDOI

Heat Losses in the Conductors of Alternating-Current Machines

TL;DR: In this article, the authors show how hyperbolic functions of complex angles may be applied to the solution of the problem of heat losses in rectangular conductors that are embedded in open slots.
Related Papers (5)