Effects of eddy currents in transformer windings
01 Aug 1966-Vol. 113, Iss: 8, pp 1387-1394
TL;DR: In this article, the effect of eddy currents on transformer windings is considered and a method is derived for calculating the variation of winding resistance and leakage inductance with frequency for transformers with single-layer, multilayer and sectionalised windings.
Abstract: The effects of eddy currents in transformer windings are considered, and a method is derived for calculating the variation of winding resistance and leakage inductance with frequency for transformers with single-layer, multilayer and sectionalised windings. The method consists in dividing the winding into portions, calculating the d.c. resistances and d.c. leakage inductances of each of these portions, and then multiplying the d.c. values by appropriate factors to obtain the corresponding a.c. values. These a.c. values are then referred to, say, the primary winding and summed to give the total winding resistance and leakage inductance of the transformer. Formulas are derived and quoted for calculating the d.c. resistances and leakage inductances of the winding portions. Theoretical expressions are derived for the variation with frequency etc. of the factors by which the d.c. values must be multiplied to obtain the corresponding a.c. values. These expressions are presented in the form of graphs, permitting the factors to be read as required.
Citations
More filters
TL;DR: In this paper , an accurate quasi-analytical approximation of frequency-dependent ac resistance of single rectangular conductors is presented, which can be used in applications where an accurate ac resistance is required, such as white box modeling of power transformers and interpreting its frequency response analysis (FRA), and calculating the resistance of electric machine winding, busbars, and printed circuit board traces.
Abstract: : This paper presents an accurate quasi-analytical approximation of frequency-dependent ac resistance of single rectangular conductors. In this work, first, a two-dimensional analytical ac resistance of rectangular conductors is derived. Unlike circular conductors, where current density distributes evenly in each layer of the conductor’s cross-section, the edge effect is involved for rectangular conductors. Due to the edge effect, one cannot define an accurate boundary condition for solving the two-dimensional partial differential equation of magnetic field or current density of rectangular conductors. Hence, the calculated two-dimensional analytical current density result is not accurate and is modified and fitted on FEM simulation, taking the conductor’s thickness into account using the least-square problem to improve its accuracy. Unlike numerical approaches, the proposed method yields an easy-to-use formula applicable to industrial applications in different fields. Contrary to the one-dimensional approach, which is only valid for very thin rectangular conductors, this method takes edge effect into account and can be used for any thickness (from square to very thin rectangular conductors). The proposed method can be used in applications where an accurate ac resistance of rectangular conductors over a wide frequency range is required, such as white-box modeling of power transformers and interpreting its frequency response analysis (FRA), and calculating the resistance of electric machine winding, busbars, and printed circuit board traces.
2 citations
2 citations
Dissertation•
29 Aug 2018
2 citations
04 Oct 1998
TL;DR: In this paper, the authors describe methods, enabling improvement of the accuracy for the calculation of core losses, winding losses, and temperature rise of switch mode magnetics, enabling improved accuracy in calculating core losses.
Abstract: This paper describes methods, enabling improvement of the accuracy for the calculation of core losses, winding losses and temperature rise of switch mode magnetics.
2 citations
References
More filters
TL;DR: In this article, a multilayer winding carrying an alternating current, such as the windings illustrated in figures 1, 2, and 3, each layer of copper lies in the alternating magnetic field set up by the current in all the other layers.
Abstract: IN any multilayer winding carrying an alternating current, such as the windings illustrated in figures 1, 2, and 3, each layer of copper lies in the alternating magnetic field set up by the current in all the other layers. Eddy currents are set up in each layer in a direction to partly neutralize the magnetic intensities in the interior of the copper wire in each layer. As a result of the eddy-current losses in the copper, the effective resistance of the winding to the alternating current it carries may be many times its resistance to continuous currents.
103 citations
TL;DR: In this article, the authors discuss the more important causes of eddy currents in heavy conductors carrying alternating currents and surrounded on three sides by iron, and propose a method to identify the most important causes.
Abstract: The object of the present paper is the discussion of the more important causes of eddy currents in heavy conductors carrying alternating currents and surrounded on three sides by iron.
93 citations
64 citations
TL;DR: In this article, it is shown that a considerable proportion of the effective resistance of inductive coils when used at radio frequencies is caused by the eddy-currents set up in the wires of the coils by the alternating magnetic field in which they are situated, and that in extreme cases the alternating current resistance may amount to more than one hundred times the direct current resistance.
Abstract: It is well-known that a considerable proportion of the effective resistance of inductive coils when used at radio frequencies is caused by the eddy-currents set up in the wires of the coils by the alternating magnetic field in which they are situated, and that in extreme cases the alternating current resistance may amount to more than one hundred times the direct current resistance. It is therefore important to have reliable formulae for the eddy-current resistance of such coils in order to determine the conditions which will reduce the eddy-current losses to a minimum. The simplest case, that of a long straight cylindrical wire under the action of its own current, has been treated by Kelvin, Rayleigh, Heaviside, and others. The general effect is known as the “skin effect,” because the current tends to concentrate more and more upon the skin of the conductor as the frequency increases.
49 citations
TL;DR: In this article, the authors show how hyperbolic functions of complex angles may be applied to the solution of the problem of heat losses in rectangular conductors that are embedded in open slots.
Abstract: The principal object of this paper is to show how hyperbolic functions of complex angles may be applied to the solution of the problem of heat losses in rectangular conductors that are embedded in open slots. A certain knowledge of the functions themselves is presupposed. Inasmuch, however, as they are handled like trigometric functions of real angles?except in regard to the plus and minus signs?it is a simple matter to acquire the requisite technical skill to use them. The hyperbolic function of a complex angle, consisting as it does of a real and an imaginary part, may represent a vector?the real part being the component of the vector along the horizontal, and the imaginary part, component along the vertical. Thus, for example, A sinh (x + j x) represents a vector just as A e j ? A/?, A (cos ? + j sin ?) represent vectors. Considerable experience has shown that the vector method for handling a-c. problems is much superior to the original method in which simple trigonometric functions were used. With this lesson before us, it should require but little contact with the problem at hand to demonstrate the superiority of the vector method, even though it employs the possibly unfamiliar hyperbolic quantities. These hyperbolic vectors have been used for a number of years in the analysis of problems involving a-c. circuits, which have distributed inductance and capacitance, and have proved their usefulness.
27 citations