Enhancement of Surface Plasmon Fiber Sensor Sensitivity Through the Grafting of Gold Nanoparticles
TL;DR: In this article, gold nanoparticles with sharp edges on the thin gold layer, deposited on the multimode fiber surface for improvement of the sensor functionality, were used to determine morphological and compositional changes in the gold covered fiber surface.
Abstract: The optical fibers, coated with plasmonic active metal films, represent the simple and unpretentious sensors, potentially useful for measurements of physical or chemical quantities and wide range of analytical application. All fiber-based plasmonic sensors operate on the same physical principle based on changes in the position of the plasmon absorption peak induced by a variation of surrounding medium refractive index. However, the observed spectral differences are often weak, and thus an enhancement of sensor sensitivity is strongly required. In this paper, we propose the immobilization of gold nanoparticles with sharp edges on the thin gold layer, deposited on the multimode fiber surface for improvement of the sensor functionality. The morphological and compositional changes in the gold covered fiber surface were determined by using the atomic force microscopy, scanning electron microscopy, and energy-dispersive X-ray spectroscopy methods. As a result of gold nanoparticles immobilization, the pronounced plasmon energy concentration near the fiber surface occurred, thus enhancing the response of the proposed hybrid plasmonic system to the variation of ambient refractive index. The position of plasmon absorption in the case of the created plasmonic structure was shown to be more sensitive to the changes in the surrounding medium in comparison with the standard sensors based on the bare gold layer.
Citations
More filters
TL;DR: In this article, a multilayer surface plasmons resonance (SPR) refractive index sensor using angle interrogation was investigated using a modified configuration to enhance the performance of the sensor, which achieved a sensitivity of 280 ° /RIU with four thin layers of BaTiO3 and mono layer of graphene.
54 citations
TL;DR: In this paper , a review of surface-enhanced Raman spectroscopy (SERS) substrates with a focus on advanced nanoarchitecture based on noble metals with special nanospaces (round tips, gaps, and porous spaces), including hybridization with metallic nanostructures (NSs), and the contemporary repertoire of nano-architecturing with organic molecules is presented.
Abstract: This article reviews recent fabrication methods for surface-enhanced Raman spectroscopy (SERS) substrates with a focus on advanced nanoarchitecture based on noble metals with special nanospaces (round tips, gaps, and porous spaces), nanolayered 2D materials, including hybridization with metallic nanostructures (NSs), and the contemporary repertoire of nanoarchitecturing with organic molecules. The use of SERS for multidisciplinary applications has been extensively investigated because the considerably enhanced signal intensity enables the detection of a very small number of molecules with molecular fingerprints. Nanoarchitecture strategies for the design of new NSs play a vital role in developing SERS substrates. In this review, recent achievements with respect to the special morphology of metallic NSs are discussed, and future directions are outlined for the development of available NSs with reproducible preparation and well-controlled nanoarchitecture. Nanolayered 2D materials are proposed for SERS applications as an alternative to the noble metals. The modern solutions to existing limitations for their applications are described together with the state-of-the-art in bio/environmental SERS sensing using 2D materials-based composites. To complement the existing toolbox of plasmonic inorganic NSs, hybridization with organic molecules is proposed to improve the stability of NSs and selectivity of SERS sensing by hybridizing with small or large organic molecules.
37 citations
TL;DR: Metal nano-particles-modified optical fiber LSPR sensor has high sensitivity and compact structure, which can realize the real-time monitoring of physical parameters, environmental parameters, and biochemical molecules, and its future development is predicted.
Abstract: In recent years, surface plasmon resonance devices (SPR, or named plamonics) have attracted much more attention because of their great prospects in breaking through the optical diffraction limit and developing new photons and sensing devices. At the same time, the combination of SPR and optical fiber promotes the development of the compact micro-probes with high-performance and the integration of fiber and planar waveguide. Different from the long-range SPR of planar metal nano-films, the local-SPR (LSPR) effect can be excited by incident light on the surface of nano-scaled metal particles, resulting in local enhanced light field, i.e., optical hot spot. Metal nano-particles-modified optical fiber LSPR sensor has high sensitivity and compact structure, which can realize the real-time monitoring of physical parameters, environmental parameters (temperature, humidity), and biochemical molecules (pH value, gas-liquid concentration, protein molecules, viruses). In this paper, both fabrication and application of the metal nano-particles modified optical fiber LSPR sensor probe are reviewed, and its future development is predicted.
11 citations
Cites methods from "Enhancement of Surface Plasmon Fibe..."
...403 [57] D fiber/Au NPs‐Au film 3074 nm/RIU 1....
[...]
...The multi-branched sharp edges on Au NPs have been used as the hotspots to enhance the SPR intensity effectively [57]....
[...]
TL;DR: In this paper, a single-mode fiber SPR sensor with a cone angle structure decorated with metal nanoparticles was used to realize enhanced sensitivity of refractive index sensing, which achieved a sensitivity of 5,140nm/RIU.
Abstract: This paper aims to clarify the relationship between the performance of the metal nanoparticles and the sensitivity of the fiber surface plasma resonance (SPR) sensor. It proposes modeling the sensing effects of a single-mode fiber SPR sensor with a cone angle structure decorated with metal nanoparticles. This study uses the metal nanoparticles to the realize enhanced sensitivity of refractive index sensing.,This paper opted for an exploratory study using a simulation approach of finite-difference time-domain (FDTD). Specifically, the effect of size, the material and the shape of the metal nanoparticle on sensing performance are investigated theoretically.,In conclusion, it is evident that the localized SPR (LSPR) effect weakens as the diameter of the gold nanosphere increases, the SPR effect enhances and the SPR sensitivity increases first and then decreases. The metal nanoparticle with the different materials and different shapes also have different LSPR and SPR sensitivity and wavelength length dynamic range. The investigation shows that, by changing parameters, the reflection spectra of the fiber SPR sensor exhibit an obvious transition from LSPR to SPR characteristics, and enhanced sensitivity of the refractive index is realized.,This paper fulfills an identified need to study how the sensitivity of the fiber SPR sensor can be enhanced by the metal nanoparticle. After the optimization of parameters, the sensitivity of 5,140 nm/RIU is achieved, which provides a new research direction for sensitivity enhancement of fiber SPR sensor.
7 citations
TL;DR: In this paper , a gold-film fiber-optic surface plasmon resonance (FOSPR) sensor was used for real-time measurement of oil slick thickness at two interfaces, namely, water-oil and air-oil.
Abstract: Rapid detection of marine oil spills is becoming increasingly critical in the face of frequent marine oil spills. Oil slick thickness measurement is critical in the hazard assessment of such oil leaks. As surface plasmon resonance (SPR) sensors are sensitive to slight changes in refractive index, they can monitor offshore oil spills arising from significant differences in the refractive index between oil and water. This study presents a gold-film fiber-optic surface plasmon resonance (FOSPR) sensor prepared by polydopamine accelerated wet chemical plating for rapid and real-time measurement of oil slick thickness. We examined oil thickness detection at two interfaces, namely, water-oil and air-oil. Detection sensitivity of −1.373%/mm is obtained at the water-oil interface in the thickness range of 0–5 mm; detection sensitivity of −2.742%/mm is obtained at the air-oil interface in the thickness range of 0–10 mm. Temperature and salinity present negligible effects on the oil slick thickness measurement. The fabricated FOSPR sensor has the ability to detect the presence of oil as well as quantify the oil thickness. It has favorable repeatability and reusability, demonstrating the significant potential for use in the estimation of marine oil slick thickness.
4 citations
References
More filters
TL;DR: This paper introduces the localized surface plasmon resonance (LSPR) sensor and describes how its exquisite sensitivity to size, shape and environment can be harnessed to detect molecular binding events and changes in molecular conformation.
Abstract: Recent developments have greatly improved the sensitivity of optical sensors based on metal nanoparticle arrays and single nanoparticles. We introduce the localized surface plasmon resonance (LSPR) sensor and describe how its exquisite sensitivity to size, shape and environment can be harnessed to detect molecular binding events and changes in molecular conformation. We then describe recent progress in three areas representing the most significant challenges: pushing sensitivity towards the single-molecule detection limit, combining LSPR with complementary molecular identification techniques such as surface-enhanced Raman spectroscopy, and practical development of sensors and instrumentation for routine use and high-throughput detection. This review highlights several exceptionally promising research directions and discusses how diverse applications of plasmonic nanoparticles can be integrated in the near future.
6,352 citations
TL;DR: In this article, the authors summarized the basic principles and major achievements of plasmon guiding, and details the current state-of-the-art in subwavelength PLASmonic waveguides, passive and active nanoplasmonic components for the generation, manipulation and detection of radiation, and configurations for the nanofocusing of light.
Abstract: Recent years have seen a rapid expansion of research into nanophotonics based on surface plasmon–polaritons. These electromagnetic waves propagate along metal–dielectric interfaces and can be guided by metallic nanostructures beyond the diffraction limit. This remarkable capability has unique prospects for the design of highly integrated photonic signal-processing systems, nanoresolution optical imaging techniques and sensors. This Review summarizes the basic principles and major achievements of plasmon guiding, and details the current state-of-the-art in subwavelength plasmonic waveguides, passive and active nanoplasmonic components for the generation, manipulation and detection of radiation, and configurations for the nanofocusing of light. Potential future developments and applications of nanophotonic devices and circuits are also discussed, such as in optical signals processing, nanoscale optical devices and near-field microscopy with nanoscale resolution.
3,481 citations
TL;DR: Fundamentals of SPR affinity biosensors are reviewed and recent advances in development and applications of SPR biosensor are discussed.
Abstract: Surface plasmon resonance (SPR) biosensors are optical sensors exploiting special electromagnetic waves—surface plasmon-polaritons—to probe interactions between an analyte in solution and a biomolecular recognition element immobilized on the SPR sensor surface. Major application areas include detection of biological analytes and analysis of biomolecular interactions where SPR biosensors provide benefits of label-free real-time analytical technology. This paper reviews fundamentals of SPR affinity biosensors and discusses recent advances in development and applications of SPR biosensors.
2,123 citations
TL;DR: The surface plasmon resonance (SPR) is finding new applications for molecular interaction studies with the introduction of new instruments and improved sensor chip chemistries as discussed by the authors, which can provide access to high-quality kinetic and thermodynamic data for macromolecular binding events.
576 citations
TL;DR: An overview of the technologies used to implement surface plasmon resonance (SPR) effects into fiber-optic sensors for chemical and biochemical applications and a survey of results reported over the last ten years is presented.
Abstract: This paper presents a brief overview of the technologies used to implement surface plasmon resonance (SPR) effects into fiber-optic sensors for chemical and biochemical applications and a survey of results reported over the last ten years. The performance indicators that are relevant for such systems, such as refractometric sensitivity, operating wavelength, and figure of merit (FOM), are discussed and listed in table form. A list of experimental results with reported limits of detection (LOD) for proteins, toxins, viruses, DNA, bacteria, glucose, and various chemicals is also provided for the same time period. Configurations discussed include fiber-optic analogues of the Kretschmann–Raether prism SPR platforms, made from geometry-modified multimode and single-mode optical fibers (unclad, side-polished, tapered, and U-shaped), long period fiber gratings (LPFG), tilted fiber Bragg gratings (TFBG), and specialty fibers (plastic or polymer, microstructured, and photonic crystal fibers). Configurations involving the excitation of surface plasmon polaritons (SPP) on continuous thin metal layers as well as those involving localized SPR (LSPR) phenomena in nanoparticle metal coatings of gold, silver, and other metals at visible and near-infrared wavelengths are described and compared quantitatively.
555 citations