Frequency domain equalization for single-carrier broadband wireless systems
TL;DR: This article surveys frequency domain equalization (FDE) applied to single-carrier (SC) modulation solutions and discusses similarities and differences of SC and OFDM systems and coexistence possibilities, and presents examples of SC-FDE performance capabilities.
Abstract: Broadband wireless access systems deployed in residential and business environments are likely to face hostile radio propagation environments, with multipath delay spread extending over tens or hundreds of bit intervals. Orthogonal frequency-division multiplex (OFDM) is a recognized multicarrier solution to combat the effects of such multipath conditions. This article surveys frequency domain equalization (FDE) applied to single-carrier (SC) modulation solutions. SC radio modems with frequency domain equalization have similar performance, efficiency, and low signal processing complexity advantages as OFDM, and in addition are less sensitive than OFDM to RF impairments such as power amplifier nonlinearities. We discuss similarities and differences of SC and OFDM systems and coexistence possibilities, and present examples of SC-FDE performance capabilities.
Citations
More filters
TL;DR: Among the possible subcarrier mapping approaches, it is found that localizedFDMA (LFDMA) with channel-dependent scheduling (CDS) results in higher throughput than interleaved FDMA (JFDMA), however, the PARR performance of IFDMA is better than that of LFDMA.
Abstract: Single carrier frequency division multiple access (SC FDMA), a modified form of orthogonal FDMA (OFDMA), is a promising technique for high data rate uplink communications in future cellular systems. SC-FDMA has similar throughput performance and essentially the same overall complexity as OFDMA. A principal advantage of SC-FDMA is the peak-to-average power ratio (PARR), which is lower than that of OFDMA. SC FDMA is currently a strong candidate for the uplink multiple access scheme in the long term evolution of cellular systems under consideration by the third generation partnership project (3GPP). In this paper, we give an overview of SC-FDMA. We also analyze the effects of subcarrier mapping on throughput and PARR. Among the possible subcarrier mapping approaches, we find that localized FDMA (LFDMA) with channel-dependent scheduling (CDS) results in higher throughput than interleaved FDMA (JFDMA). However, the PARR performance of IFDMA is better than that of LFDMA. As in other communications systems there are complex tradeoffs between design parameters and performance in an SC-FDMA system
1,328 citations
Cites background from "Frequency domain equalization for s..."
...Additional disadvantages of OFDMA compared to SCFDMA are the strong sensitivity to carrier frequency offset and strong sensitivity to nonlinear distortion in the power amplifier due to the high PAPR, both properties of the multicarrier nature of OFDMA [8], [9]....
[...]
TL;DR: This paper addresses basic OFDM and related modulations, as well as techniques to improve the performance of OFDM for wireless communications, including channel estimation and signal detection, time- and frequency-offset estimation and correction, peak-to-average power ratio reduction, and multiple-input-multiple-output (MIMO) techniques.
Abstract: Orthogonal frequency-division multiplexing (OFDM) effectively mitigates intersymbol interference (ISI) caused by the delay spread of wireless channels. Therefore, it has been used in many wireless systems and adopted by various standards. In this paper, we present a comprehensive survey on OFDM for wireless communications. We address basic OFDM and related modulations, as well as techniques to improve the performance of OFDM for wireless communications, including channel estimation and signal detection, time- and frequency-offset estimation and correction, peak-to-average power ratio reduction, and multiple-input-multiple-output (MIMO) techniques. We also describe the applications of OFDM in current systems and standards.
915 citations
Cites background from "Frequency domain equalization for s..."
...SC-FDE in [141] also has a blockwise transmission format and incorporates the CP for the same purpose....
[...]
Book•
14 Nov 2003
TL;DR: In this paper, the authors provide an in-depth insight into hybrid multiple access techniques based on multi-carrier (MC) transmission, and present numerous hybrid access and air interface architectures including OFDM/CDMA, MC-CDMA and MT-CDMAC over new techniques such as space-time coding and software radio.
Abstract: From the Publisher:
Frequency spectrum is a limited and valuable resource for wireless communications. A good example can be observed among network operators in Europe for the prices to pay for UMTS-frequency bands. Therefore, the first goal when designing future wireless communication systems (e.g. 4G - fourth generation) has to be the increase in spectral efficiency. The development in digital communications in the past years has enabled efficient modulation and coding techniques for robust and spectral efficient data, speech, audio and video transmission. These are the multi-carrier modulation (e.g. OFDM) and the spread spectrum technique (e.g. DS-CDMA), where OFDM was chosen for broadcast applications (DVB, DAB) as well as for broadband wireless indoor standards (ETSI HIPERLAN-II, IEEE-802.11) and the DS-CDMA was selected in mobile communications (IS-95, third generation mobile radio systems world wide, UMTS/IMT 2000).
Since 1993 various combinations of multi-carrier (MC) modulation and the spread spectrum (SS) technique have been introduced and the field of MC-SS communications has become an independent and important research topic with increasing activities. New application fields have been proposed such as high rate cellular mobile, high rate wireless indoor and LMDS. It has been shown that MC-SS offers the high spectral efficiency, robustness and flexibility that is required for the next generation systems. Meanwhile, different alternative hybrid schemes such as OFDM/OFDMA, MC-TDMA, etc. have been deeply analysed and adopted in different international standards (ETSI-BRAN, IEEE-802 & MMAC).
Multi-Carrier & Spread-Spectrum: Analysis of Hybrid Air Interfaces draws together all ofthe above mentioned hybrid schemes therefore providing a greatly needed resource for system engineers, telecommunication designers and researchers in order to enable them to develop, build and deploy several schemes based on MC-transmission for the next generation systems (which will be an integration of broadband multimedia services covering both 4G mobile and fixed wireless systems).
Offers a complete treatment of multi-carrier, spread-spectrum (SS) and time division multiplexing (TDM) techniquesProvides an in-depth insight into hybrid multiple access techniques based on multi-carrier (MC) transmissionPresents numerous hybrid multiple access and air interface architectures including OFDM/CDMA, MC-CDMA, MC-DS-CDMA and MT-CDMACovers new techniques such as space-time coding and software radio
Telecommunications engineers, hardware & software system designers and researchers as well as students, lecturers and technicians will all find this an invaluable addition to their bookshelf.
886 citations
TL;DR: The flexible nature of GFDM makes this waveform a suitable candidate for future 5G networks, and its main characteristics are analyzed.
Abstract: Cellular systems of the fourth generation (4G) have been optimized to provide high data rates and reliable coverage to mobile users. Cellular systems of the next generation will face more diverse application requirements: the demand for higher data rates exceeds 4G capabilities; battery-driven communication sensors need ultra-low power consumption; and control applications require very short response times. We envision a unified physical layer waveform, referred to as generalized frequency division multiplexing (GFDM), to address these requirements. In this paper, we analyze the main characteristics of the proposed waveform and highlight relevant features. After introducing the principles of GFDM, this paper contributes to the following areas: 1) the means for engineering the waveform's spectral properties; 2) analytical analysis of symbol error performance over different channel models; 3) concepts for MIMO-GFDM to achieve diversity; 4) preamble-based synchronization that preserves the excellent spectral properties of the waveform; 5) bit error rate performance for channel coded GFDM transmission using iterative receivers; 6) relevant application scenarios and suitable GFDM parameterizations; and 7) GFDM proof-of-concept and implementation aspects of the prototype using hardware platforms available today. In summary, the flexible nature of GFDM makes this waveform a suitable candidate for future 5G networks.
809 citations
TL;DR: A survey of the mmWave propagation characteristics, channel modeling, and design guidelines, such as system and antenna design considerations for mmWave, including the link budget of the network, which are essential for mm Wave communication systems design is presented.
Abstract: The millimeter wave (mmWave) frequency band spanning from 30 to 300 GHz constitutes a substantial portion of the unused frequency spectrum, which is an important resource for future wireless communication systems in order to fulfill the escalating capacity demand. Given the improvements in integrated components and enhanced power efficiency at high frequencies, wireless systems can operate in the mmWave frequency band. In this paper, we present a survey of the mmWave propagation characteristics, channel modeling, and design guidelines, such as system and antenna design considerations for mmWave, including the link budget of the network, which are essential for mmWave communication systems. We commence by introducing the main channel propagation characteristics of mmWaves followed by channel modeling and design guidelines. Then, we report on the main measurement and modeling campaigns conducted in order to understand the mmWave band’s properties and present the associated channel models. We survey the different channel models focusing on the channel models available for the 28, 38, 60, and 73 GHz frequency bands. Finally, we present the mmWave channel model and its challenges in the context of mmWave communication systems design.
512 citations
Cites background from "Frequency domain equalization for s..."
...the frequency selective channel, since SC-FDE tolerates power-efficient nonlinear amplifiers and it is also tolerant to phase noise [234]....
[...]
References
More filters
Journal Article•
1,113 citations
TL;DR: N -phase Codes are described which have an autocorrelation function with one main peak and very small side peaks and doppler shift effects appear to be similar to those of linear FM radar pulse compression.
Abstract: N -phase Codes are described which have an autocorrelation function with one main peak and very small side peaks. With N phases an N^{2} long pulse sequence is generated. Properties have been verified for N up to 8 and a rule for main peak-to-side-peak ratio is conjectured for larger N . For N greater than 5 . the ratio is substantially better than the best ratios which have been shown for binary bipolar codes. Doppler shift effects appear to be similar to those of linear FM radar pulse compression.
1,110 citations
"Frequency domain equalization for s..." refers background in this paper
...For unique word lengths P that are powers of two, such as 64 or 256, polyphase Frank-Zadoff sequences [10] or Chu sequences [11] are suitable....
[...]
TL;DR: Suboptimal strategies for combining partial transmit sequences that achieve similar performance but with reduced complexity are presented.
Abstract: Orthogonal frequency-division multiplexing (OFDM) is an attractive technique for achieving high-bit-rate wireless data transmission. However, the potentially large peak-to-average power ratio (PAP) has limited its application. Recently, two promising techniques for improving the PAP statistics of an OFDM signal have been proposed: the selective mapping and partial transmit sequence approaches. Here, we present suboptimal strategies for combining partial transmit sequences that achieve similar performance but with reduced complexity.
896 citations
TL;DR: A method of generating phase shift pulse codes of arbitrarily long length with zero periodic correlation except for the peak for zero shift is presented.
Abstract: A method of generating phase shift pulse codes of arbitrarily long length with zero periodic correlation except for the peak for zero shift is presented. The codes are of length p^2 where p is any prime number, and p different phase shifts corresponding to the p th roots of unity are necessary to generate them. Since p different phase shifts are required, these codes are not as easy to generate and process as the binary codes, but this does not seem to be a serious limitation to their usefulness. Application of these codes can be made as interpulse phase modulation for range resolution in pulse Doppler radars or for a method of synchronizing a pulse code communication system.
504 citations
431 citations