High Performance Silicon Nanowire Field Effect Transistors
TL;DR: In this article, the influence of source-drain contact thermal annealing and surface passivation on key transistor properties was examined, and it was shown that thermal annaling and passivation of oxide defects using chemical modification can increase the average transconductance from 45 to 800 nS and average mobility from 30 to 560 cm 2 /V
Abstract: Silicon nanowires can be prepared with single-crystal structures, diameters as small as several nanometers and controllable hole and electron doping, and thus represent powerful building blocks for nanoelectronics devices such as field effect transistors. To explore the potential limits of silicon nanowire transistors, we have examined the influence of source-drain contact thermal annealing and surface passivation on key transistor properties. Thermal annealing and passivation of oxide defects using chemical modification were found to increase the average transconductance from 45 to 800 nS and average mobility from 30 to 560 cm 2 /V‚s with peak values of 2000 nS and 1350 cm 2 /V‚s, respectively. The comparison of these results and other key parameters with state-of-the-art planar silicon devices shows substantial advantages for silicon nanowires. The uses of nanowires as building blocks for future nanoelectronics are discussed.
Citations
More filters
TL;DR: Highly sensitive, label-free, multiplexed electrical detection of cancer markers using silicon-nanowire field-effect devices in which distinct nanowires and surface receptors are incorporated into arrays opens up substantial possibilities for diagnosis and treatment of cancer and other complex diseases.
Abstract: We describe highly sensitive, label-free, multiplexed electrical detection of cancer markers using silicon-nanowire field-effect devices in which distinct nanowires and surface receptors are incorporated into arrays. Protein markers were routinely detected at femtomolar concentrations with high selectivity, and simultaneous incorporation of control nanowires enabled discrimination against false positives. Nanowire arrays allowed highly selective and sensitive multiplexed detection of prostate specific antigen (PSA), PSA-a1-antichymotrypsin, carcinoembryonic antigen and mucin-1, including detection to at least 0.9 pg/ml in undiluted serum samples. In addition, nucleic acid receptors enabled real-time assays of the binding, activity and small-molecule inhibition of telomerase using unamplified extracts from as few as ten tumor cells. The capability for multiplexed real-time monitoring of protein markers and telomerase activity with high sensitivity and selectivity in clinically relevant samples opens up substantial possibilities for diagnosis and treatment of cancer and other complex diseases.
2,396 citations
TL;DR: This work aims to provide a comprehensive overview of electrospun nanofibers, including the principle, methods, materials, and applications, and highlights the most relevant and recent advances related to the applications by focusing on the most representative examples.
Abstract: Electrospinning is a versatile and viable technique for generating ultrathin fibers. Remarkable progress has been made with regard to the development of electrospinning methods and engineering of electrospun nanofibers to suit or enable various applications. We aim to provide a comprehensive overview of electrospinning, including the principle, methods, materials, and applications. We begin with a brief introduction to the early history of electrospinning, followed by discussion of its principle and typical apparatus. We then discuss its renaissance over the past two decades as a powerful technology for the production of nanofibers with diversified compositions, structures, and properties. Afterward, we discuss the applications of electrospun nanofibers, including their use as "smart" mats, filtration membranes, catalytic supports, energy harvesting/conversion/storage components, and photonic and electronic devices, as well as biomedical scaffolds. We highlight the most relevant and recent advances related to the applications of electrospun nanofibers by focusing on the most representative examples. We also offer perspectives on the challenges, opportunities, and new directions for future development. At the end, we discuss approaches to the scale-up production of electrospun nanofibers and briefly discuss various types of commercial products based on electrospun nanofibers that have found widespread use in our everyday life.
2,289 citations
TL;DR: A new type of transistor in which there are no junctions and no doping concentration gradients is proposed and demonstrated, which has near-ideal subthreshold slope, extremely low leakage currents, and less degradation of mobility with gate voltage and temperature than classical transistors.
Abstract: All existing transistors are based on the use of semiconductor junctions formed by introducing dopant atoms into the semiconductor material. As the distance between junctions in modern devices drops below 10 nm, extraordinarily high doping concentration gradients become necessary. Because of the laws of diffusion and the statistical nature of the distribution of the doping atoms, such junctions represent an increasingly difficult challenge for the semiconductor industry. Here, we propose and demonstrate a new type of transistor in which there are no junctions and no doping concentration gradients. These devices have full CMOS functionality and are made using silicon nanowires. They have near-ideal subthreshold slope, extremely low leakage currents, and less degradation of mobility with gate voltage and temperature than classical transistors.
2,090 citations
TL;DR: In this paper, the authors investigated the transport properties of 50-nm-high 1D nanochannels on a chip and showed that they can be used for the separation and preconcentration of proteins.
Abstract: This thesis explores transport phenomena in nanochannels on a chip. Fundamental nanofluidic ionic studies form the basis for novel separation and preconcentration applications for proteomic purposes. The measurements were performed with 50-nm-high 1D nanochannels, which are easily accessible from both sides by two microchannels. Nanometer characteristic apertures were manufactured in the bonded structure of Pyrex-amorphous silicon – Pyrex, in which the thickness of the amorphous silicon layer serves as a spacer to define the height of the nanochannels. The geometry of the nanometer-sized apertures is well defined, which simplifies the modeling of the transport across them. Compared to biological pores, the present nanochannels in Pyrex offer increased stability. Fundamental characteristics of nanometer-sized apertures were obtained by impedance spectroscopy measurements of the nanochannel at different ionic strengths and pH values. A conductance plateau (on a log-log scale) was modeled and measured, establishing due to the dominance of the surface charge density in the nanochannels, which induces an excess of mobile counterions to maintain electroneutrality. The nanochannel conductance can be regulated at low ionic strengths by pH adjustment, and by an external voltage applied on the chip to change the zeta potential. This field-effect allows the regulation of ionic flow which can be exploited for the fabrication of nanofluidic devices. Fluorescence measurements confirm that 50-nm-high nanochannels show an exclusion of co-ions and an enrichment of counterions at low ionic strengths. This permselectivity is related to the increasing thickness of the electrical double layer (EDL) with decreasing salt concentrations, which results in an EDL overlap in an aperture if the height of the nanochannel and the thickness of the EDL are comparable in size. The diffusive transport of charged species and therefore the exclusion-enrichment effect was described with a simple model based on the Poisson-Boltzmann equation. The negatively charged Pyrex surface of the nanometer characteristic apertures can be inversed with chemical surface pretreatments, resulting in an exclusion of cations and an enrichment of anions. When a pressure gradient is applied across the nanochannels, charged molecules are electrostatically rejected at the entrance of the nanometer-sized apertures, which can be used for separation processes. Proteomic applications are presented such as the separation and preconcentration of proteins. The diffusion of Lectin proteins with different isoelectric points and very similar compositions were controlled by regulating the pH value of the buffer. When the proteins are neutral at their pI value, the diffusion coefficient is maximal because the biomolecules does not interact electrostatically with the charged surfaces of the nanochannel. This led to a fast separation of three Lectin proteins across the nanochannel. The pI values measured in this experiment are slightly shifted compared to the values obtained with isoelectric focusing because of reversible adsorption of proteins on the walls which affects the pH value in the nanochannel. An important application in the proteomic field is the preconcentration of biomolecules. By applying an electric field across the nanochannel, anionic and cationic analytes were preconcentrated on the cathodic side of the nanometer-sized aperture whereas on the anodic side depletion of ions was observed. This is due to concentration polarization, a complex of effects related to the formation of ionic concentration gradients in the electrolyte solution adjacent to an ion-selective interface. It was measured that the preconcentration factor increased with the net charge of the molecule, leading to a preconcentration factor of > 600 for rGFP proteins in 9 minutes. Such preconcentrations are important in micro total analysis systems to achieve increased detection signals of analytes contained in dilute solutions. Compared to cylindrical pores, our fabrication process allows the realization of nanochannels on a chip in which the exclusion-enrichment effect and a big flux across the nanometer-sized aperture can be achieved, showing the interest for possible micro total analysis system applications. The described exclusion-enrichment effect as well as concentration polarization play an important role in transport phenomena in nanofluidics. The appendix includes preliminary investigations in DNA molecule separation and fluorescence correlation spectroscopy measurements, which allows investigating the behavior of molecules in the nanochannel itself.
1,636 citations
TL;DR: In this article, the most common traditional traditional techniques, such as cyclic voltammetry, chronoamperometry, chronopotentiometry, impedance spectroscopy, and various field-effect transistor based methods are presented along with selected promising novel approaches, including nanowire or magnetic nanoparticle-based biosensing.
Abstract: Quantification of biological or biochemical processes are of utmost importance for medical, biological and biotechnological applications. However, converting the biological information to an easily processed electronic signal is challenging due to the complexity of connecting an electronic device directly to a biological environment. Electrochemical biosensors provide an attractive means to analyze the content of a biological sample due to the direct conversion of a biological event to an electronic signal. Over the past decades several sensing concepts and related devices have been developed. In this review, the most common traditional techniques, such as cyclic voltammetry, chronoamperometry, chronopotentiometry, impedance spectroscopy, and various field-effect transistor based methods are presented along with selected promising novel approaches, such as nanowire or magnetic nanoparticle-based biosensing. Additional measurement techniques, which have been shown useful in combination with electrochemical detection, are also summarized, such as the electrochemical versions of surface plasmon resonance, optical waveguide lightmode spectroscopy, ellipsometry, quartz crystal microbalance, and scanning probe microscopy. The signal transduction and the general performance of electrochemical sensors are often determined by the surface architectures that connect the sensing element to the biological sample at the nanometer scale. The most common surface modification techniques, the various electrochemical transduction mechanisms, and the choice of the recognition receptor molecules all influence the ultimate sensitivity of the sensor. New nanotechnology-based approaches, such as the use of engineered ion-channels in lipid bilayers, the encapsulation of enzymes into vesicles, polymersomes, or polyelectrolyte capsules provide additional possibilities for signal amplification. In particular, this review highlights the importance of the precise control over the delicate interplay between surface nano-architectures, surface functionalization and the chosen sensor transducer principle, as well as the usefulness of complementary characterization tools to interpret and to optimize the sensor response.
1,550 citations
References
More filters
TL;DR: In this paper, the fabrication of a three-terminal switching device at the level of a single molecule represents an important step towards molecular electronics and has attracted much interest, particularly because it could lead to new miniaturization strategies in the electronics and computer industry.
Abstract: The use of individual molecules as functional electronic devices was first proposed in the 1970s (ref 1) Since then, molecular electronics2,3 has attracted much interest, particularly because it could lead to conceptually new miniaturization strategies in the electronics and computer industry The realization of single-molecule devices has remained challenging, largely owing to difficulties in achieving electrical contact to individual molecules Recent advances in nanotechnology, however, have resulted in electrical measurements on single molecules4,5,6,7 Here we report the fabrication of a field-effect transistor—a three-terminal switching device—that consists of one semiconducting8,9,10 single-wall carbon nanotube11,12 connected to two metal electrodes By applying a voltage to a gate electrode, the nanotube can be switched from a conducting to an insulating state We have previously reported5 similar behaviour for a metallic single-wall carbon nanotube operated at extremely low temperatures The present device, in contrast, operates at room temperature, thereby meeting an important requirement for potential practical applications Electrical measurements on the nanotube transistor indicate that its operation characteristics can be qualitatively described by the semiclassical band-bending models currently used for traditional semiconductor devices The fabrication of the three-terminal switching device at the level of a single molecule represents an important step towards molecular electronics
5,258 citations
TL;DR: The assembly of functional nanoscale devices from indium phosphide nanowires, the electrical properties of which are controlled by selective doping are reported, and electric-field-directed assembly can be used to create highly integrated device arrays from nanowire building blocks.
Abstract: Nanowires and nanotubes carry charge and excitons efficiently, and are therefore potentially ideal building blocks for nanoscale electronics and optoelectronics. Carbon nanotubes have already been exploited in devices such as field-effect and single-electron transistors, but the practical utility of nanotube components for building electronic circuits is limited, as it is not yet possible to selectively grow semiconducting or metallic nanotubes. Here we report the assembly of functional nanoscale devices from indium phosphide nanowires, the electrical properties of which are controlled by selective doping. Gate-voltage-dependent transport measurements demonstrate that the nanowires can be predictably synthesized as either n- or p-type. These doped nanowires function as nanoscale field-effect transistors, and can be assembled into crossed-wire p-n junctions that exhibit rectifying behaviour. Significantly, the p-n junctions emit light strongly and are perhaps the smallest light-emitting diodes that have yet been made. Finally, we show that electric-field-directed assembly can be used to create highly integrated device arrays from nanowire building blocks.
3,280 citations
TL;DR: In this article, the authors fabricated field effect transistors based on individual single and multi-wall carbon nanotubes and analyzed their performance, showing that structural deformations can make them operate as field-effect transistors.
Abstract: We fabricated field-effect transistors based on individual single- and multi-wall carbon nanotubes and analyzed their performance. Transport through the nanotubes is dominated by holes and, at room temperature, it appears to be diffusive rather than ballistic. By varying the gate voltage, we successfully modulated the conductance of a single-wall device by more than 5 orders of magnitude. Multi-wall nanotubes show typically no gate effect, but structural deformations—in our case a collapsed tube—can make them operate as field-effect transistors.
2,771 citations