In wire electrical discharge machining (wire-EDM) material is removed by the thermal energy of an electric spark that has been initiated between two electrodes (the wire and the workpiece), submerged in demineralised water. The use of high frequency current pulses for sparking leads to excellent machining performance, in terms of the work piece roughness, the material integrity of the cut and the material removal rate. To reach the highest frequencies, the wire-EDM generator mostly consists of a voltage source with an as low as possible internal inductance. The working current delivered to the spark and, hence, the material removal rate of the process depends on the total impedance of the electrical circuit. In this article the importance of the wire’s impedance will be shown. Due to the skin-effect, this impedance depends on the frequency of the current signal, especially for ferromagnetic wires, such as steel wire. Coatings will prove to be primordial to prevent the machining speed from dropping significantly.

/pdf/the-skin-effect-in-ferromagnetic-electrodes-for-wire-edm-4059wd3fmq.pdf

Increasing precision of wire electrical discharge machining by using coated steel electrodes

Citations

The skin-effect in ferromagnetic electrodes for wire-EDM

Related Papers (5)

Electrical Discharge Machining by Structural-Steel Electrodes

Design of a coating for a high tensile strength steel electrode for wire electrical discharge machining

Wire electrode for wire electrical discharge machining

Wire electrical discharge machining electrode wire

Wire electrode for electrical discharge machining device