Isothermal multiplicity on catalytic surfaces
TL;DR: The necessary condition for the existence of multiplicity has been obtained for the case of a first-order surface reaction as discussed by the authors, on the assumption that the multiplicity of the first order surface reaction is constant.
About: This article is published in Chemical Engineering Science.The article was published on 1981-01-01. It has received 1 citations till now. The article focuses on the topics: Multiplicity (chemistry).
Citations
More filters
TL;DR: In this article, an interpretation of "splashes" is given, sharp long-living variations in reaction parameters, registered in a number of kinetic experiments, and the model of the simplest catalytic mechanism providing relaxation self-oscillations is used.
Abstract: An interpretation is given of “splashes” — sharp long-living variations in reaction parameters, registered in a number of kinetic experiments. The model of the simplest catalytic mechanism providing relaxation self-oscillations is used.
References
More filters
TL;DR: In this paper, the turnover number for ammonia synthesis was found to be smaller on very small iron particles than on larger ones, but it could be enhanced by a pretreatment which seemed to bring about a surface reconstruction induced by nitrogen.
169 citations
TL;DR: In this article, it is shown that a broad variety of slow chemisorption steps can serve as buffer with the restriction that the buffer step should not, or at least only slightly, contribute to the surface reaction.
89 citations
TL;DR: In this article, surface heterogeneity can induce sustained kinetic oscillations, when a simple, isothermal reaction occurs on a catalytic surface, and the proposed model demonstrates that these oscillations may occur for realistic values of surface heterogeneity.
73 citations
TL;DR: In this article, the kinetics of ethylene and propylene oxidation over Rh and Ru supported on low area α-alumina were studied and found similar to those reported earlier for the same metals supported on high area silica.
32 citations
TL;DR: The surface area of dispersed platinum on different supports has been measured by means of a "titration" technique involving the interaction between chemisorbed oxygen and carbon monoxide as mentioned in this paper.
22 citations