Large Piezoelectric Effect in Pb-Free Ceramics
TL;DR: It is predicted that the single-crystal form of the MPB composition of the present system may reach a giant d(33) = 1500-2000 pC/N, which may provide a new recipe for designing highly piezoelectric materials (both Pb-free and P b-containing) by searching MPBs starting from a TCP.
Abstract: We report a non-Pb piezoelectric ceramic system Ba(Ti(0.8)Zr(0.2))O(3)-(Ba(0.7)Ca(0.3))TiO(3) which shows a surprisingly high piezoelectric coefficient of d(33) approximately 620 pC/N at optimal composition. Its phase diagram shows a morphotropic phase boundary (MPB) starting from a tricritical triple point of a cubic paraelectric phase (C), ferroelectric rhombohedral (R), and tetragonal (T) phases. The high piezoelectricity of the MPB compositions stems from the composition proximity of the MPB to the tricritical triple point, which leads to a nearly vanishing polarization anisotropy and thus facilitates polarization rotation between 001T and 111R states. We predict that the single-crystal form of the MPB composition of the present system may reach a giant d(33) = 1500-2000 pC/N. Our work may provide a new recipe for designing highly piezoelectric materials (both Pb-free and Pb-containing) by searching MPBs starting from a TCP.
Citations
More filters
1,175 citations
TL;DR: In this article, a figure of merit analysis for key devices is presented and used to contrast lead-containing and lead-free piezoceramics for demanding applications with high reliability, displacements and frequency as well as a wide temperature range.
Abstract: After twenty years of partly quiet and ten years of partly enthusiastic research into lead-free piezoceramics there are now clear prospects for transfer into applications in some areas. This mimics prior research into eliminating lead from other technologies that resulted in restricted lead use in batteries and dwindling use in other applications. A figure of merit analysis for key devices is presented and used to contrast lead-containing and lead-free piezoceramics. A number of existing applications emerge, where the usage of lead-free piezoceramics may be envisaged in the near future. A sufficient transition period to ensure reliability, however, is required. The use of lead-free piezoceramics for demanding applications with high reliability, displacements and frequency as well as a wide temperature range appears to remain in the distant future. New devices are outlined, where the figure of merit suggests skipping lead-containing piezoceramics altogether. Suggestions for the next pertinent research requirements are provided.
966 citations
TL;DR: In this paper, the status and perspectives of this new class of actuator ceramics are presented, aiming at covering a wide spectrum of topics, i.e., from fundamentals to practice, and a recent discovery has greatly extended our tool box for material design by furnishing (Bi 1/2Na1/2)TiO3-based (PZT) with a reversible phase transition between an ergodic relaxor state and a ferroelectric with the application of electric field.
Abstract: In response to the current environmental regulations against the use of lead in daily electronic devices, a number of investigations have been performed worldwide in search for alternative piezoelectric ceramics that can replace the market-dominating lead-based ones, representatively Pb(Zr
x
Ti1-x
)O3 (PZT)-based solid solutions. Selected systems of potential importance such as chemically modified and/or crystallographically textured (K, Na)NbO3 and (Bi1/2Na1/2)TiO3-based solid solutions have been developed. Nevertheless, only few achievements have so far been introduced to the marketplace. A recent discovery has greatly extended our tool box for material design by furnishing (Bi1/2Na1/2)TiO3-based ceramics with a reversible phase transition between an ergodic relaxor state and a ferroelectric with the application of electric field. This paired the piezoelectric effect with a strain-generating phase transition and extended opportunities for actuator applications in a completely new manner. In this contribution, we will present the status and perspectives of this new class of actuator ceramics, aiming at covering a wide spectrum of topics, i.e., from fundamentals to practice.
778 citations
TL;DR: This research provides a new paradigm for designing material properties through engineering local structural heterogeneity, expected to benefit a wide range of functional materials.
Abstract: Piezoelectric materials, which respond mechanically to applied electric field and vice versa, are essential for electromechanical transducers. Previous theoretical analyses have shown that high piezoelectricity in perovskite oxides is associated with a flat thermodynamic energy landscape connecting two or more ferroelectric phases. Here, guided by phenomenological theories and phase-field simulations, we propose an alternative design strategy to commonly used morphotropic phase boundaries to further flatten the energy landscape, by judiciously introducing local structural heterogeneity to manipulate interfacial energies (that is, extra interaction energies, such as electrostatic and elastic energies associated with the interfaces). To validate this, we synthesize rare-earth-doped Pb(Mg1/3Nb2/3)O3-PbTiO3 (PMN-PT), as rare-earth dopants tend to change the local structure of Pb-based perovskite ferroelectrics. We achieve ultrahigh piezoelectric coefficients d33 of up to 1,500 pC N-1 and dielectric permittivity e33/e0 above 13,000 in a Sm-doped PMN-PT ceramic with a Curie temperature of 89 °C. Our research provides a new paradigm for designing material properties through engineering local structural heterogeneity, expected to benefit a wide range of functional materials.
756 citations
References
More filters
TL;DR: A lead-free piezoelectric ceramic with an electric-field-induced strain comparable to typical actuator-grade PZT is reported, achieved through the combination of the discovery of a morphotropic phase boundary in an alkaline niobate-based perovskite solid solution, and the development of a processing route leading to highly textured polycrystals.
Abstract: Lead has recently been expelled from many commercial applications and materials (for example, from solder, glass and pottery glaze) owing to concerns regarding its toxicity. Lead zirconium titanate (PZT) ceramics are high-performance piezoelectric materials, which are widely used in sensors, actuators and other electronic devices; they contain more than 60 weight per cent lead. Although there has been a concerted effort to develop lead-free piezoelectric ceramics, no effective alternative to PZT has yet been found. Here we report a lead-free piezoelectric ceramic with an electric-field-induced strain comparable to typical actuator-grade PZT. We achieved this through the combination of the discovery of a morphotropic phase boundary in an alkaline niobate-based perovskite solid solution, and the development of a processing route leading to highly textured polycrystals. The ceramic exhibits a piezoelectric constant d33 (the induced charge per unit force applied in the same direction) of above 300 picocoulombs per newton (pC N(-1)), and texturing the material leads to a peak d33 of 416 pC N(-1). The textured material also exhibits temperature-independent field-induced strain characteristics.
4,689 citations
TL;DR: In this article, the piezoelectric properties of relaxor based ferroelectric single crystals, such as Pb(Zn1/3Nb2/3)O3 and PbTiO3, were investigated for electromechanical actuators.
Abstract: The piezoelectric properties of relaxor based ferroelectric single crystals, such as Pb(Zn1/3Nb2/3)O3–PbTiO3 and Pb(Mg1/3Nb2/3)O3–PbTiO3 were investigated for electromechanical actuators. In contrast to polycrystalline materials such as Pb(Zr,Ti)O3, morphotropic phase boundary compositions were not essential for high piezoelectric strain. Piezoelectric coefficients (d33’s)>2500 pC/N and subsequent strain levels up to >0.6% with minimal hysteresis were observed. Crystallographically, high strains are achieved for 〈001〉 oriented rhombohedral crystals, although 〈111〉 is the polar direction. Ultrahigh strain levels up to 1.7%, an order of magnitude larger than those available from conventional piezoelectric and electrostrictive ceramics, could be achieved being related to an E-field induced phase transformation. High electromechanical coupling (k33)>90% and low dielectric loss <1%, along with large strain make these crystals promising candidates for high performance solid state actuators.
3,766 citations
TL;DR: It is shown that a large piezoelectric response can be driven by polarization rotation induced by an external electric field, and the computations suggest how to design materials with better performance, and may stimulate further interest in the fundamental theory of dielectric systems in finite electric fields.
Abstract: Piezoelectric materials, which convert mechanical to electrical energy (and vice versa), are crucial in medical imaging, telecommunication and ultrasonic devices. A new generation of single-crystal materials, such as Pb(Zn1/3Nb2/3)O3-PbTiO3 (PZN-PT) and Pb(Mg1/3Nb2/3)O3-PbTiO3 (PMN-PT), exhibit a piezoelectric effect that is ten times larger than conventional ceramics, and may revolutionize these applications. However, the mechanism underlying the ultrahigh performance of these new materials-and consequently the possibilities for further improvements-are not at present clear. Here we report a first-principles study of the ferroelectric perovskite, BaTiO3, which is similar to single-crystal PZN-PT but is a simpler system to analyse. We show that a large piezoelectric response can be driven by polarization rotation induced by an external electric field. Our computations suggest how to design materials with better performance, and may stimulate further interest in the fundamental theory of dielectric systems in finite electric fields.
1,789 citations
TL;DR: In this paper, the intrinsic nature of the dielectric and piezoelectric properties of Pb(Zr,Ti)O3 is compared with the various families of soft and hard PZTs.
Abstract: Investigations in the development of lead-free piezoelectric ceramics have recently claimed comparable properties to the lead-based ferroelectric perovskites, represented by Pb(Zr,Ti)O3, or PZT In this work, the scientific and technical impact of these materials is contrasted with the various families of “soft” and “hard” PZTs On the scientific front, the intrinsic nature of the dielectric and piezoelectric properties are presented in relation to their respective Curie temperatures (T
C) and the existence of a morphotropic phase boundary (MPB) Analogous to PZT, enhanced properties are noted for MPB compositions in the (Na,Bi)TiO3-BaTiO3 and ternary system with (K,Bi)TiO3, but offer properties significantly lower The consequences of a ferroelectric to antiferroelectric transition well below T
C further limits their usefulness Though comparable with respect to T
C, the high levels of piezoelectricity reported in the (K,Na)NbO3 family are the result of enhanced polarizability associated with the orthorhombic-tetragonal polymorphic phase transition being compositionally shifted downward As expected, the properties are strongly temperature dependent, while degradation occurs through the thermal cycling between the two distinct ferroelectric domain states Extrinsic contributions arising from domains and domain wall mobility were determined using high field strain and polarization measurements The concept of “soft” and “hard” lead-free piezoelectrics were discussed in relation to donor and acceptor modified PZTs, respectively Technologically, the lead-free materials are discussed in relation to general applications, including sensors, actuators and ultrasound transducers
1,525 citations
TL;DR: It is shown that with a different mechanism, an aged BaTiO3 single crystal can generate a large recoverable nonlinear strain of 0.75% at a low field of 200 V mm−1.
Abstract: Large electric-field-induced strain in ferroelectric crystals by point-defect-mediated reversible domain switching
953 citations