Journal Article•
Muscle and tendon: properties, models, scaling, and application to biomechanics and motor control
01 Jan 1989-Critical Reviews in Biomedical Engineering (Crit Rev Biomed Eng)-Vol. 17, Iss: 4, pp 359-411
TL;DR: Their integrated ability to generate force statically and dynamically is studied by formulating a generic model of the "musculotendon actuator", which has only one parameter, the ratio of tendon length at rest to muscle fiberlength at rest.
Abstract: Skeletal muscles transform neural control signals into forces that act upon the body segments to effect a coordinated motor task. This transformation is complex, not only because the properties of muscles are complex, but because the tendon affects the transmission of muscle force to the skeleton. This review focuses on how to synthesize basic properties of muscle and tendon to construct models applicable to studies of coordination. After a review of the properties of muscle and tendon, their integrated ability to generate force statically and dynamically is studied by formulating a generic model of the "musculotendon actuator", which has only one parameter, the ratio of tendon length at rest to muscle fiber length at rest. To illustrate the utility of the model, it is analyzed to show how this one parameter specifies whether excitation-contraction or musculotendon contraction is the rate-limiting process of force generation, whether elastic energy is stored in tendon or muscle, and whether hip- and knee-extensor actuators function as springs or dashpots during walking.
Citations
More filters
TL;DR: Evidence for "central" fatigue and the neural mechanisms underlying it are reviewed, together with its terminology and the methods used to reveal it.
Abstract: Muscle fatigue is an exercise-induced reduction in maximal voluntary muscle force. It may arise not only because of peripheral changes at the level of the muscle, but also because the central nervous system fails to drive the motoneurons adequately. Evidence for “central” fatigue and the neural mechanisms underlying it are reviewed, together with its terminology and the methods used to reveal it. Much data suggest that voluntary activation of human motoneurons and muscle fibers is suboptimal and thus maximal voluntary force is commonly less than true maximal force. Hence, maximal voluntary strength can often be below true maximal muscle force. The technique of twitch interpolation has helped to reveal the changes in drive to motoneurons during fatigue. Voluntary activation usually diminishes during maximal voluntary isometric tasks, that is central fatigue develops, and motor unit firing rates decline. Transcranial magnetic stimulation over the motor cortex during fatiguing exercise has revealed focal cha...
3,200 citations
TL;DR: Overall results show that the simple act of standing quietly depends on a remarkably complex sensorimotor control system.
Abstract: It is generally accepted that human bipedal upright stance is achieved by feedback mechanisms that generate an appropriate corrective torque based on body-sway motion detected primarily by visual, vestibular, and proprioceptive sensory systems. Because orientation information from the various senses is not always available (eyes closed) or accurate (compliant support surface), the postural control system must somehow adjust to maintain stance in a wide variety of environmental conditions. This is the sensorimotor integration problem that we investigated by evoking anterior-posterior (AP) body sway using pseudorandom rotation of the visual surround and/or support surface (amplitudes 0.5-8 degrees ) in both normal subjects and subjects with severe bilateral vestibular loss (VL). AP rotation of body center-of-mass (COM) was measured in response to six conditions offering different combinations of available sensory information. Stimulus-response data were analyzed using spectral analysis to compute transfer functions and coherence functions over a frequency range from 0.017 to 2.23 Hz. Stimulus-response data were quite linear for any given condition and amplitude. However, overall behavior in normal subjects was nonlinear because gain decreased and phase functions sometimes changed with increasing stimulus amplitude. "Sensory channel reweighting" could account for this nonlinear behavior with subjects showing increasing reliance on vestibular cues as stimulus amplitudes increased. VL subjects could not perform this reweighting, and their stimulus-response behavior remained quite linear. Transfer function curve fits based on a simple feedback control model provided estimates of postural stiffness, damping, and feedback time delay. There were only small changes in these parameters with increasing visual stimulus amplitude. However, stiffness increased as much as 60% with increasing support surface amplitude. To maintain postural stability and avoid resonant behavior, an increase in stiffness should be accompanied by a corresponding increase in damping. Increased damping was achieved primarily by decreasing the apparent time delay of feedback control rather than by changing the damping coefficient (i.e., corrective torque related to body-sway velocity). In normal subjects, stiffness and damping were highly correlated with body mass and moment of inertia, with stiffness always about 1/3 larger than necessary to resist the destabilizing torque due to gravity. The stiffness parameter in some VL subjects was larger compared with normal subjects, suggesting that they may use increased stiffness to help compensate for their loss. Overall results show that the simple act of standing quietly depends on a remarkably complex sensorimotor control system.
1,872 citations
Cites background or methods from "Muscle and tendon: properties, mode..."
...This work was supported by National Aeronautics and Space Administration Grant NAG5-7869 and National Institute on Aging Grant R01 AG-17960....
[...]
...These factors might include low-pass dynamics in the sensory channels and muscle mechanics that have low-pass characteristics (Zajac 1989)....
[...]
TL;DR: This work presents three robots based on passive-dynamics, with small active power sources substituted for gravity, which can walk on level ground and use less control and less energy than other powered robots, yet walk more naturally, further suggesting the importance of passive-Dynamics in human locomotion.
Abstract: Passive-dynamic walkers are simple mechanical devices, composed of solid parts connected by joints, that walk stably down a slope. They have no motors or controllers, yet can have remarkably humanlike motions. This suggests that these machines are useful models of human locomotion; however, they cannot walk on level ground. Here we present three robots based on passive-dynamics, with small active power sources substituted for gravity, which can walk on level ground. These robots use less control and less energy than other powered robots, yet walk more naturally, further suggesting the importance of passive-dynamics in human locomotion.
1,850 citations
Book•
09 Oct 1998
TL;DR: This poster presents a probabilistic procedure for estimating the mechanical properties of bone based on known mechanisms, including compressive forces, compressive strength, and the compressive properties of Bone.
Abstract: Forces in Joints, Skeletal Biology, Analysis of Bone Remodeling, Mechanical Properties of Bone, Fatigue and Fracture Resistance of Bone, Mechanical Adaptation of the Skeleton, Synovial Joint Mechanics, Mechanical Properties of Ligament and Tendon
1,246 citations
TL;DR: The simulation results suggest that minimum metabolic energy per unit distance traveled is a valid measure of walking performance.
Abstract: A three-dimensional, neuromusculoskeletal model of the body was combined with dynamic optimization theory to simulate normal walking on level ground. The body was modeled as a 23 degree-of-freedom mechanical linkage, actuated by 54 muscles. The dynamic optimization problem was to calculate the muscle excitation histories, muscle forces, and limb motions subject to minimum metabolic energy expenditure per unit distance traveled. Muscle metabolic energy was calculated by slimming five terms: the basal or resting heat, activation heat, maintenance heat, shortening heat, and the mechanical work done by all the muscles in the model. The gait cycle was assumed to be symmetric; that is, the muscle excitations for the right and left legs and the initial and terminal states in the model were assumed to be equal. Importantly, a tracking problem was not solved. Rather only a set of terminal constraints was placed on the states of the model to enforce repeatability of the gait cycle. Quantitative comparisons of the model predictions with patterns of body-segmental displacements, ground-reaction forces, and muscle activations obtained from experiment show that the simulation reproduces the salient features of normal gait. The simulation results suggest that minimum metabolic energy per unit distance traveled is a valid measure of walking performance.
1,128 citations