Raman spectrum of graphene and graphene layers.
TL;DR: This work shows that graphene's electronic structure is captured in its Raman spectrum that clearly evolves with the number of layers, and allows unambiguous, high-throughput, nondestructive identification of graphene layers, which is critically lacking in this emerging research area.
Abstract: Graphene is the two-dimensional building block for carbon allotropes of every other dimensionality We show that its electronic structure is captured in its Raman spectrum that clearly evolves with the number of layers The D peak second order changes in shape, width, and position for an increasing number of layers, reflecting the change in the electron bands via a double resonant Raman process The G peak slightly down-shifts This allows unambiguous, high-throughput, nondestructive identification of graphene layers, which is critically lacking in this emerging research area
Citations
More filters
TL;DR: In this paper, local laser excitation and temperature readout from the intensity ratio of Stokes to anti-Stokes Raman scattering signals are employed to study the thermal properties of a large graphene membrane.
Abstract: Local laser excitation and temperature readout from the intensity ratio of Stokes to anti-Stokes Raman scattering signals are employed to study the thermal properties of a large graphene membrane. The concluded value of the heat conductivity coefficient κ ≈ 600 W/(m·K) is smaller than previously reported but still validates the conclusion that graphene is a very good thermal conductor.
363 citations
TL;DR: The results show that the graphene films on Cu and Ge can surprisingly inhibit the growth of both bacteria, especially the former, and a plausible mechanism is proposed here to explain this phenomenon.
Abstract: Graphene has attracted increasing attention for potential applications in biotechnology due to its excellent electronic property and biocompatibility. Here we use both Gram-positive Staphylococcus aureus (S. aureus) and Gram-negative Escherichia coli (E. coli) to investigate the antibacterial actions of large-area monolayer graphene film on conductor Cu, semiconductor Ge and insulator SiO2. The results show that the graphene films on Cu and Ge can surprisingly inhibit the growth of both bacteria, especially the former. However, the proliferation of both bacteria cannot be significantly restricted by the graphene film on SiO2. The morphology of S. aureus and E. coli on graphene films further confirms that the direct contact of both bacteria with graphene on Cu and Ge can cause membrane damage and destroy membrane integrity, while no evident membrane destruction is induced by graphene on SiO2. From the viewpoint of charge transfer, a plausible mechanism is proposed here to explain this phenomenon. This study may provide new insights for the better understanding of antibacterial actions of graphene film and for the better designing of graphene-based antibiotics or other biomedical applications.
362 citations
TL;DR: In this article, a comparative study and Raman characterization of the formation of graphene on single crystal Ni (111) and polycrystalline Ni substrates using chemical vapor deposition (CVD) was performed.
Abstract: We report a comparative study and Raman characterization of the formation of graphene on single crystal Ni (111) and polycrystalline Ni substrates using chemical vapor deposition (CVD). Preferential formation of monolayer/bilayer graphene on the single crystal surface is attributed to its atomically smooth surface and the absence of grain boundaries. In contrast, CVD graphene formed on polycrystalline Ni leads to a higher percentage of multilayer graphene (≥3 layers), which is attributed to the presence of grain boundaries in Ni that can serve as nucleation sites for multilayer growth. Micro-Raman surface mapping reveals that the area percentages of monolayer/bilayer graphene are 91.4% for the Ni (111) substrate and 72.8% for the polycrystalline Ni substrate under comparable CVD conditions. The use of single crystal substrates for graphene growth may open ways for uniform high-quality graphene over large areas.
361 citations
TL;DR: This facile, inexpensive, solid-state method for generating, patterning, and electronic tuning of graphene-based materials shows exceptional electrochemical activity that surpasses other carbon-based electrodes in electron charge transfer rate as demonstrated using a ferro-/ferricyanide redox couple.
Abstract: Engineering a low-cost graphene-based electronic device has proven difficult to accomplish via a single-step fabrication process. Here we introduce a facile, inexpensive, solid-state method for generating, patterning, and electronic tuning of graphene-based materials. Laser scribed graphene (LSG) is shown to be successfully produced and selectively patterned from the direct laser irradiation of graphite oxide films under ambient conditions. Circuits and complex designs are directly patterned onto various flexible substrates without masks, templates, post-processing, transferring techniques, or metal catalysts. In addition, by varying the laser intensity and laser irradiation treatments, the electrical properties of LSG can be precisely tuned over 5 orders of magnitude of conductivity, a feature that has proven difficult with other methods. This inexpensive method for generating LSG on thin flexible substrates provides a mode for fabricating a low-cost graphene-based NO2 gas sensor and enables its use as a...
361 citations
TL;DR: G/Cu exhibits the highest surface energy immediately after synthesis, and the surface energy decreases after airborne contamination occurs, suggesting the root cause of intrinsically mild polarity of G/Cu surface is discussed.
Abstract: Because of the atomic thinness of graphene, its integration into a device will always involve its interaction with at least one supporting substrate, making the surface energy of graphene critical to its real-life applications. In the current paper, the contact angle of graphene synthesized by chemical vapor deposition (CVD) was monitored temporally after synthesis using water, diiodomethane, ethylene glycol, and glycerol. The surface energy was then calculated based on the contact angle data by the Fowkes, Owens–Wendt (extended Fowkes), and Neumann models. The surface energy of fresh CVD graphene grown on a copper substrate (G/Cu) immediately after synthesis was determined to be 62.2 ± 3.1 mJ/m2 (Fowkes), 53.0 ± 4.3 mJ/m2 (Owens–Wendt) and 63.8 ± 2.0 mJ/m2 (Neumann), which decreased to 45.6 ± 3.9, 37.5 ± 2.3, and 57.4 ± 2.1 mJ/m2, respectively, after 24 h of air exposure. The ellipsometry characterization indicates that the surface energy of G/Cu is affected by airborne hydrocarbon contamination. G/Cu ex...
360 citations
References
More filters
28 Jul 2005
TL;DR: PfPMP1）与感染红细胞、树突状组胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作�ly.
Abstract: 抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。
18,940 citations