scispace - formally typeset
Journal ArticleDOI

Utilization of sewage sludge in EU application of old and new methods—A review

Reads0
Chats0
TLDR
In this article, the authors review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.
Abstract
The European Union has made progress in dealing with municipal wastewater in individual countries and as a corporate entity. However, it intends to make still further and substantial progress over the next 15 years. Currently, the most widely available options in the EU are the agriculture utilization, the waste disposal sites, the land reclamation and restoration, the incineration and other novel uses. The selection of an option on a local basis reflects local or national, cultural, historical, geographical, legal, political and economic circumstances. The degree of flexibility varies from country to country. In any case sludge treatment and disposal should always be considered as an integral part of treatment of wastewater. There is a wide range of other uses for sludge, which exploit its energy or chemical content, namely the thermal processes. The present paper sought to review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.

read more

Citations
More filters
Journal ArticleDOI

Soil fertilization with wastewater biosolids - monitoring changes in the 'soil-fertilizer-plant' system and phosphorus recovery options

TL;DR: The results show that the use of sewage biosolids as a soil improver in accordance with local legislation does not pose any serious environmental risks but can maintain and improve soil fertility and crop yield.
Journal ArticleDOI

Identification of phosphorus species and bioavailability in primary, secondary and digested sludge

TL;DR: Results showed that inorganic P (IP) was the primary P fraction in the secondary sludge and digested sludge, in which non-apatite IP (NAIP) amounted to 91.6% and 69.3% of total IP, respectively.
Journal ArticleDOI

Combustion characteristics of paper and sewage sludge in a pilot-scale fluidized bed.

TL;DR: The highest temperature during combustion within the system was found at the surface of the fluidized bed, and carbon monoxide (CO) emissions decreased as oxygen content increased in the flue gas, and nitrogen oxide (NOx) emissions were also tied with oxygen content.
Journal ArticleDOI

Application of Thermally Treated Sewage Sludge in Blended Cements

TL;DR: In this paper, a potential use of sewage sludge in blended cements is investigated on the basis of the measurement of mechanical and basic physical properties of pastes containing the sludge, in an amount of up to 60% of the mass of cement.
References
More filters
Journal ArticleDOI

Sequential extraction procedure for the speciation of particulate trace metals

TL;DR: In this paper, an analytical procedure involving sequential chemicai extractions was developed for the partitioning of particulate trace metals (Cd, Co, Cu, Ni, Pb, Zn, Fe, and Mn) into five fractions: exchangeable, bound to carbonates, binding to Fe-Mn oxides and bound to organic matter.
Book

Wastewater Engineering Treatment Disposal Reuse

TL;DR: Wastewater Engineering: An Overview of Wastewater Engineering, Methods and Implementation Considerations as mentioned in this paper is a good starting point for a discussion of the issues of wastewater engineering. But, it is not a complete survey of the entire literature.
Journal ArticleDOI

Sewage sludge combustion

TL;DR: In this article, a review of the current and future issues related to the combustion of sewage sludge is presented, and a number of technologies for thermal processing of sludge are discussed in three groups, i.e., mono-combustion, cocombustions and alternative processes.
Journal ArticleDOI

Trace metal analysis on polluted sediments

TL;DR: In this article, the authors proposed a standardization with respect to grain size effects, commonly achieved by analyzing the sieve fraction <63μm, which is used to pin point major sources of metal pollution and to estimate the toxicity potential of dredged materials.
Related Papers (5)