Utilization of sewage sludge in EU application of old and new methods—A review
TL;DR: In this article, the authors review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.
Abstract: The European Union has made progress in dealing with municipal wastewater in individual countries and as a corporate entity. However, it intends to make still further and substantial progress over the next 15 years. Currently, the most widely available options in the EU are the agriculture utilization, the waste disposal sites, the land reclamation and restoration, the incineration and other novel uses. The selection of an option on a local basis reflects local or national, cultural, historical, geographical, legal, political and economic circumstances. The degree of flexibility varies from country to country. In any case sludge treatment and disposal should always be considered as an integral part of treatment of wastewater. There is a wide range of other uses for sludge, which exploit its energy or chemical content, namely the thermal processes. The present paper sought to review past and future trends in sludge handling, focusing mainly at thermal processes (e.g. pyrolysis, wet oxidation, gasification) and the utilization of sewage sludge in cement manufacture as a co-fuel.
Citations
More filters
TL;DR: In this article, the microwave heating system was used for sludge pyrolysis and the raw sludge and KOH-immersed sludge were determined and their product characteristics were determined.
Abstract: The microwave heating system was used for sludge pyrolysis. The raw sludge and KOH-immersed sludge were pyrolyzed and their product characteristics were determined. The research results are advantageous to understand the influence of KOH activation on characteristics of pyrolysis products and the adsorption performance of metals in char. In the case of a high temperature and high KOH dose, most of the lost mass from sludge pyrolysis was converted into gaseous products instead of oil. The heat values of liquid oils were 40.86–41.39 MJ kg−1, which has the potential for use as fuels. The use of a higher KOH dose for sludge pyrolysis is beneficial to the porosity development and generates a mesopore structure. The results from adsorption tests indicate that precipitation could be the dominant adsorption mechanism due to the binding between alkaline anion and carbonate and metal ions with a strong chemical affinity. The high KOH dose sludge adsorbent has a remarkable adsorption performance and can be used as adsorbent for the removal of the studied metals.
1 citations
TL;DR: In this article , a review of existing research and case studies related to the use of biochar and the evaluation of the impact of the biochar on the characteristics of growing medium is presented.
1 citations
01 Jan 2016
1 citations
TL;DR: In this paper , fly ash and slag obtained in circulating fluidized bed combustion technology were used to analyze the adsorption processes of Cd(II) ions, and the physical and chemical properties of adsorbents were characterized.
Abstract: In a time of globalization, industrial and economic development, new technologies, and pollu - tion of the natural environment have become serious global problem. Due to the superior role of water in maintaining life on Earth, ensuring its purity seems to be a key issue. Heavy met - als seem to be one of the most harmful pollutants in the natural environment. For this reason, there are indications to look for new and cheap methods of removing metal ions from wastewater and the aquatic environment. In these research studies, fly ash and slag obtained in circulating fluidized bed combustion technology were used to analyze the adsorption processes of Cd(II) ions. The physical and chemical properties of adsorbents were characterized, such as granulation analysis, bulk density, particle size composition, scanning electron microscopy-energy-dispersive X-ray spectroscopy elemental analysis, thermogravimetry, Brunauer–Emmett–Teller adsorption and desorption, pore-volume, scanning electron microscopy and transmission electron micros - copy image analysis, Fourier-transform infrared spectroscopy. The results of the experiments showed high adsorption efficiency and adsorptive capacity of Cd(II) ions on the adsorbents tested. It can be concluded that the obtained results are a sufficient impulse to continue research in this area. Industrial waste in the form of fly ash and slag could be successfully used in adsorption processes to remove Cd(II) ions from wastewater.
1 citations
References
More filters
TL;DR: In this paper, an analytical procedure involving sequential chemicai extractions was developed for the partitioning of particulate trace metals (Cd, Co, Cu, Ni, Pb, Zn, Fe, and Mn) into five fractions: exchangeable, bound to carbonates, binding to Fe-Mn oxides and bound to organic matter.
Abstract: An analytical procedure involving sequential chemicai extractions has been developed for the partitioning of particulate trace metals (Cd, Co, Cu, Ni, Pb, Zn, Fe, and Mn) into five fractions: exchangeable, bound to carbonates, bound to Fe-Mn oxides, bound to organic matter, and residual. Experimental results obtained on replicate samples of fluvial bottom sediments demonstrate that the relative standard deviation of the sequential extraction procedure Is generally better than =10%. The accuracy, evaluated by comparing total trace metal concentrations with the sum of the five Individual fractions, proved to be satisfactory. Complementary measurements were performed on the Individual leachates, and on the residual sediments following each extraction, to evaluate the selectivity of the various reagents toward specific geochemical phases. An application of the proposed method to river sediments is described, and the resulting trace metal speciation is discussed.
10,518 citations
"Utilization of sewage sludge in EU ..." refers background in this paper
...Over the last decades, a great variety of extraction schemes, both simple and sequential have been developed and, although some methods have been widely used [12,13] none has been unreservedly accepted by the scientific community....
[...]
Book•
01 Jan 1972
TL;DR: Wastewater Engineering: An Overview of Wastewater Engineering, Methods and Implementation Considerations as mentioned in this paper is a good starting point for a discussion of the issues of wastewater engineering. But, it is not a complete survey of the entire literature.
Abstract: Wastewater Engineering: An Overview. Wastewater Flowrates. Wastewater Characteristics. Wastewater Treatment Objective, Methods, and Implementation Considerations. Introduction to Wastewater Treatment Plant Design. Physical Unit Operations. Chemical Unit Processes. Biological Unit Processes. Design of Facilities for Physical and Chemical Treatment of Wastewater. Design of Facilities for the Biological Treatment of Wastewater. Advanced Wastewater Treatment. Design of Facilities for the Treatment and Disposal of Sludge. Natural-Treatment Systems. Small Wastewater Treatment Systems. Management of Wastewater from Combined Sewers. Wastewater Reclamation and Reuse.
3,826 citations
TL;DR: In this article, a review of the current and future issues related to the combustion of sewage sludge is presented, and a number of technologies for thermal processing of sludge are discussed in three groups, i.e., mono-combustion, cocombustions and alternative processes.
1,026 citations
"Utilization of sewage sludge in EU ..." refers background in this paper
...Multiple hearth and fluidized bed furnaces are the most popular and the latter is becoming widely applied [24]....
[...]
...Analysis has shown that about 78–98% of Cd, Cr, Cu, Ni, Pb and Zn present in the sewage sludge are retained in the ash, whereas up to 98% of the Hg may be released into the atmosphere with the flue gas [24]....
[...]
...The whole process is occurring in two distinctive regimes [24]:...
[...]
TL;DR: In this article, the authors proposed a standardization with respect to grain size effects, commonly achieved by analyzing the sieve fraction <63μm, which is used to pin point major sources of metal pollution and to estimate the toxicity potential of dredged materials.
Abstract: Sediment analyses are used to pin‐point major sources of metal pollution and to estimate the toxicity potential of dredged materials on agricultural land. For source assessments (Part I of the present review) standardization is needed with respect to grain size effects, commonly achieved by analyzing the sieve fraction <63μm. Further aspects include sampling methods, evaluation of background data and extent of anthropogenic metal enrichment.
530 citations