Topic
Alloy
About: Alloy is a research topic. Over the lifetime, 171884 publications have been published within this topic receiving 1719420 citations. The topic is also known as: alloys.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, the Al0.5CoCrCuFeNi alloys with multiprincipal elements (x=the aluminum content in molar ratio, from 0 to 3.0) were synthesized using a well-developed arc-melting and casting method.
Abstract: The AlxCoCrCuFeNi alloys with multiprincipal elements (x=the aluminum content in molar ratio, from 0 to 3.0) were synthesized using a well-developed arc-melting and casting method, and their mechanical properties were investigated. These alloys exhibited promising mechanical properties, including excellent elevated-temperature strength and good wear resistance. With the addition of aluminum from x=0 to 3.0, the hardness of the alloys increased from HV 133 to 655, mainly attributed to the increased portion of strong bcc phase to ductile fcc phase, both of which were strengthened by the solid solution of aluminum atoms and the precipitation of nanophases. The alloys exhibited superior high-temperature strengths up to 800 °C, among which the Al0.5CoCrCuFeNi alloy, especially, had enhanced plasticity and a large strain-hardening capacity. Moreover, the wear resistance of these alloys was similar to that of ferrous alloys at the same hardness level, while the alloys with lower hardness exhibited relatively higher resistance because of their large strain-hardening capacity.
685 citations
TL;DR: A considerable part of the available literature on scandium in aluminium alloys is reviewed in this article, with emphasis on the aluminium rich part of diagrams, including a wide range of ternary Al-Sc-X phase diagrams and a few higher order phase diagrams.
Abstract: A considerable part of the available literature on scandium in aluminium alloys is reviewed. Experimental data and assessments of the binary Al–Sc phase diagram, a wide range of ternary Al–Sc–X phase diagrams and a few higher order phase diagrams are accounted for, with emphasis on the aluminium rich part of the diagrams. The phase which is in equilibrium with Al, Al3Sc, can form by several different mechanisms, all of which are described. The precipitation kinetics of Al3Sc in binary Al–Sc alloys are discussed, and an overview of the reported influences of ternary alloying elements on the precipitation of Al3Sc is given. The Al3Sc phase particles can serve as a grain refiner in the Al melt, a dispersoid for controlling the grain structure of the alloy and a strengthening precipitate. Several examples of these three effects are mentioned, both in binary Al–Sc alloys, and in more complex alloys. The reported effects of Sc on the precipitation behaviour in Al–Cu, Al–Mg–Si, Al–Zn–Mg and Al–Li alloys ...
680 citations
TL;DR: In this paper, the authors compare the mechanical properties of cast and wrought Ni3Al-based alloys, Fe3Al based alloys and FeAl alloys with several commercially available superalloys such as Haynes 214 (NiCrAlY), MA-956 (yttriadispersed FeCrAly), and a FeNiCr alloy (HU steel) used in carburizing applications.
663 citations
TL;DR: In this article, the authors investigated various binary, ternary and quaternary alloys made from the equiatomic high-entropy alloy FeNiCoCrMn.
659 citations
TL;DR: In this article, the authors evaluated the phase stability of CrMnFeCoNi and showed that it is a single-phase solid solution after homogenization for 2 days at 1200°C and remains in this state after a subsequent anneal at 900°C for 500 days.
615 citations