Topic
Antimony
About: Antimony is a research topic. Over the lifetime, 11450 publications have been published within this topic receiving 155660 citations. The topic is also known as: Sb & element 51.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, the authors employed X-ray absorption and photoelectron spectroscopy to show that Sb(V) is reduced to Sb (III) by magnetite and mackinawite, two ubiquitous Fe(II)-containing minerals.
Abstract: The speciation of antimony is strongly influenced by its oxidation state (V, III, 0, –III). Redox processes under anaerobic groundwater conditions may therefore greatly alter the environmental behaviour of Sb. Employing X-ray absorption and photoelectron spectroscopy, we show here that Sb(V) is reduced to Sb(III) by magnetite and mackinawite, two ubiquitous Fe(II)-containing minerals, while Sb(III) is not reduced further. At the surface of magnetite, Sb(III) forms a highly symmetrical sorption complex at the position otherwise occupied by tetrahedral Fe(III). The Sb(V) reduction increases with pH, and at pH values >6.5 Sb(V) is completely reduced to Sb(III) within 30 days. In contrast, at the mackinawite surface, Sb(V) is completely reduced across a wide pH range and within 1 h. The Sb(V) reduction proceeds solely by oxidation of surface Fe(II), while the oxidation state of sulphide is conserved. Independent of whether Sb(V) or Sb(III) was added, an amorphous or nano-particulate SbS3-like solid formed.
69 citations
TL;DR: In this article, the effect of antimony, bismuth and calcium addition on the corrosion and electrochemical behaviour of AZ91 magnesium alloy in 3.5% NaCl solution was investigated.
69 citations
69 citations
TL;DR: In this article, the rates and total amounts of the arsenic for antimony exchange on both the Sb-terminated and Ga (or In)-terminated GaSb (001) surfaces using in situ real-time line-of-sight mass spectrometry (LOS-MS) during molecular beam epitaxy were quantified.
Abstract: We quantify the rates and total amounts of the arsenic for antimony exchange on both the Sb-terminated and Ga (or In)-terminated GaSb (001) surfaces using in situ real time line-of-sight mass spectrometry (LOS-MS) during molecular beam epitaxy. On the Sb-terminated GaSb (001) surface, an As for Sb exchange is observed to occur at all values of incident As2 flux considered. At high substrate temperature, three-dimensional (3D) nanometer-sized clusters from as a consequence of As/Sb exchange and lattice mismatch strain between GaAs and GaSb. The 3D clusters are found to have lateral dimensions of ∼10–30 nm and heights of 1–3 nm by atomic force microscopy (AFM). By contrast, at lower substrate temperatures a two-dimensional surface morphology is maintained, and AFM reveals an array of atomically flat terraces. On the surface terminated by one monolayer (ML) of Ga or In, there exists a critical As2 flux below which the As/Sb exchange is greatly diminished. The net amounts of Sb leaving the surface during one ...
69 citations
TL;DR: An antimony film electrode (SbFE) was prepared in situ on a glassy carbon support and in a new supporting electrolyte, a saturated solution of hydrogen potassium tartrate in which Sb(III) ions were complexed using tartrate as discussed by the authors.
Abstract: An antimony film electrode (SbFE) was prepared in situ on a glassy carbon support and in a new supporting electrolyte, a saturated solution of hydrogen potassium tartrate in which Sb(III) ions were complexed using tartrate. Its performance in anodic stripping voltammetric (ASV) determination of Cd(II), Pb(II), Zn(II), Tl(I), In(III) and Cu(II) traces was examined. It was found that 1.2 mg/L of Sb(III) yields the finest quality SbFE for analytical purposes. The procedure with in situ SbFE ensures well-defined anodic stripping voltammetric curves of the investigated elements, low detection limits (0.5–3.8 µg/L), good reproducibility (1–5 %) and satisfactory sensitivity (32–184 nA/(µg/L)).
69 citations