Arcjet rocket

About: Arcjet rocket is a research topic. Over the lifetime, 1121 publications have been published within this topic receiving 9687 citations. The topic is also known as: Arcjet.

Development of a hybrid (MPD plus thermal) arcjet engine with an applied magnetic field

Abstract: Work carried out by the JPL on several applied field MPD (magnetoplasmasynamic) or hybrid engines, both radiation cooled and liquid cooled, is described. A radiation cooled device was successfully life tested for 554 hrs with ammonia as the propellant. While the electrode erosion was moderate, the boron nitride insulator was badly eroded. Hydrogen and lithium were the other propellants used in these devices. In the case of lithium, a radiation cooled engine had an efficiency of 70 percent at about 5500 sec.

Determination of Parameters in Arcjet Plume by Tomographic Reconstruction

Abstract: The spatial temperature and atomic number density of the plume generated by a 3-kW-class arcjet thruster are determined with a small number of absorption measurements across the plume based on diode-laser absorption computerized tomography. The maximum temperature and atom number density increase with the massflow rate and discharge current. The increase trend is not always found with the specific input power, although there exists an increasing trend with it at a fixed massflow rate. The development of the plume is studied with the measurements of the plume at different locations. The technique should also be applicable to arcjet or other hypersonic flow systems without much modification.

Low-thrust chemical propulsion system propellant expulsion and thermal conditioning study

Abstract: Thermal conditioning systems for satisfying engine net positive suction pressure (NPSP) requirements, and propellant expulsion systems for achieving propellant dump during a return-to-launch site (RTLS) abort were studied for LH2/LO2 and LCH4/LO2 upper stage propellant combinations. A state-of-the-art thermal conditioning system employing helium injection beneath the liquid surface shows the lowest weight penalty for LO2 and LCH4. A technology system incorporating a thermal subcooler (heat exchanger) for engine NPSP results in the lowest weight penalty for the LH2 tank. A preliminary design of two state-of-the-art and two new technology systems indicates a weight penalty difference too small to warrant development of a LH2 thermal subcooler. Analysis results showed that the LH2/LO2 propellant expulsion system is optimized for maximum dump line diameters, whereas the LCH4/LO2 system is optimized for minimum dump line diameter (LCH4) and maximum dump line diameter (LO2). The primary uncertainty is the accurate determination of two-phase flow rates through the dump system; experimentation is not recommended because this uncertainty is not considered significant.