Axial compressor

About: Axial compressor is a research topic. Over the lifetime, 12035 publications have been published within this topic receiving 127766 citations.

Case treatment for compressor blades

Abstract: The outer shroud of an axial flow compressor is treated to remove the low momentum flow adjacent the tips of the compressor blades in a judiciously located and sized passageway that removes the low momentum flow relative to the rotor blades at a location downstream of the blades' leading edge and returned at a location upstream of the point of removal. It being critical that no more than 12% of the total flow in the compressor rotor is removed for treatment. Anti-swirl vanes in the passageway serve to remove or reverse the swirl component from the removed low momentum flow. The intake is so designed that it selectively removes only the weak low momentum flow relative to the rotor and encourages the strong mainstream flow to remain in the main gas stream.

Revised FORTRAN program for calculating velocities and streamlines on the hub-shroud midchannel stream surface of an axial-, radial-, or mixed-flow turbomachine or annular duct. 2: Programmer's manual

Abstract: A FORTRAN IV computer program has been developed that obtains a detailed subsonic or shock free transonic flow solution on the hub-shroud midchannel stream surface of a turbomachine. The blade row may be fixed or rotating, and the blades may be twisted and leaned. Flow may be axial, mixed, or radial. Upstream and downstream flow variables may vary from hub to shroud, and provisions are made to correct for loss of stagnation pressure. The results include velocities, streamlines, and flow angles on the stream surface and approximate blade surface velocities.

The Effect of Reynolds Number and Laminar Separation on Axial Cascade Performance

Abstract: Testing over a range of Reynolds numbers was done for three NACA 65 Profiles in cascade. The testing was carried out in the VKI C-1 Low Speed Cascade Wind Tunnel; blade chord Reynolds number was varied from 250,000 to 40,000. A semiempirical theory is developed which will predict the behavior of the shear layer across a laminar separation bubble. The method is proposed for two-dimensional incompressible flow and is applicable down to short bubble bursting. The method can be used to predict the length of the laminar bubble, the bursting Reynolds number, and the development of the shear layer through the separated region. As such it is a practical method for calculating the profile losses of axial compressor and turbine cascades in the presence of laminar separation bubbles. It can also be used to predict the abrupt leading edge stall associated with thin airfoil sections. The predictions made by the method are compared with the available experimental data. The agreement could be considered good. The method was also used to predict regions of laminar separation in converging flows through axial compressor cascades (exterior to the corner vortices) with good results. For Reynolds numbers below bursting the semiempirical theory no longer applies. For this situation the performance of an axial compressor cascade can be computed using an empirical correlation proposed by the author. Comparison of performance prediction with experiment shows satisfactory agreement. Finally, a tentative correlation, based on the NACA Diffusion Factor, is presented that allows a rapid estimation of the bursting Reynolds number of an axial compressor cascade.

Modeling and identification of an axial flow blood pump

Abstract: This paper presents a model for identification of an axial pump. It aims to provide flow and pressure difference estimates of the axial pump as well as the parameters of the pump characteristics without using flow and pressure sensors.