Bandwidth (signal processing)

About: Bandwidth (signal processing) is a research topic. Over the lifetime, 48550 publications have been published within this topic receiving 600741 citations. The topic is also known as: Bandwidth (signal processing) & bandwidth.

Dispersive properties of optical filters for WDM systems

Abstract: Wavelength division multiplexing (WDM) communication systems invariably require good optical filters meeting stringent requirements on their amplitude response, the ideal being a perfectly rectangular filter. To achieve high bandwidth utilization, the phase response of these filters is of equal importance, with the ideal filter having perfectly linear phase and therefore constant time delay and no dispersion. This aspect of optical filters for WDM systems has not received much attention until very recently. It is the objective of this paper to consider the phase response and resulting dispersion of optical filters in general and their impact on WDM system performance. To this end we use general concepts from linear systems, in particular, minimum and nonminimum phase response and the applicability of Hilbert transforms (also known as Kramers-Kronig relations). We analyze three different classes of optical filters, which are currently being used in WDM systems and compare their performance in terms of their phase response. Finally, we consider possible ways of linearizing the phase response without affecting the amplitude response, in an attempt to approximate the ideal filter and achieve the highest bandwidth utilization.

Bandwidth Improvement in Large Reflectarrays by Using True-Time Delay

Abstract: A significant improvement in the bandwidth of large reflectarrays is demonstrated using elements which allow true-time delay. Two identical, large reflectarrays have been designed using different phase distributions to generate a collimated beam. In the former, the phase distribution is truncated to 360deg as is usual in reflectarray antennas, while in the second, the true phase delay is maintained (three cycles of 360deg). The chosen phase-shifter elements are based on previously measured and validated patches aperture-coupled to delay lines. The radiation patterns for both reflectarrays have been computed at several frequencies and the gain is represented as a function of frequency for both cases. Bandwidth curves are presented as a function of the reflectarray size.

Interdigital, Band-Pass Filters

Abstract: The design of band-pass filters using interdigital arrays of resonator line elements between parallel ground planes is discussed. Two approximate design procedures are described, both of which permit design directly from lumped element, low-pass, prototype filters. Both design procedures will work for either narrow or wide-band filters, but one procedure gives more practical dimensions for filters having wide bandwidths (such as an octave), while the other gives more practical dimensions for filters having narrow or moderate bandwidth. The resulting filters are very compact, have relatively noncritical manufacturing tolerances, and strong stop bands with the second pass band centered at three times the center frequency of the first pass band. The dimensions and measured performance curves are presented for a 10 per cent bandwidth design and an octave bandwidth design.

A fast recursive algorithm for optimum sequential signal detection in a BLAST system

Abstract: Bell Laboratories layered space-time (BLAST) wireless systems are multiple-antenna communication schemes that can achieve very high spectral efficiencies in scattering environments with no increase in bandwidth or transmitted power. The most popular and, by far, the most practical architecture is the so-called vertical BLAST (V-BLAST). The signal detection algorithm of a V-BLAST system is computationally very intensive. If the number of transmitters is M and is equal to the number of receivers, this complexity is proportional to M/sup 4/ at each sample time. We propose a very simple and efficient algorithm that reduces the complexity by a factor of M.

Bandwidth, SAR, and efficiency of internal mobile phone antennas

Abstract: This paper presents a thorough investigation into the effects of several phone chassis-related parameters-length, width, thickness, and distance between the head and phone-on the bandwidth, efficiency, and specific absorption rate (SAR) characteristics of internal mobile phone antennas. The studied antenna-chassis combinations are located beside an anatomical head model in a position of actual handset use. The effect of the user's hand is also studied with two different hand models. The main part of the study is based on FDTD simulations, but also experimental results, which support the computationally obtained conclusions, are given. The presented analysis provides novel and useful information for future design of mobile handset antennas. The results show the general trends of bandwidth, SAR, and efficiency with different chassis parameters. The results also reveal a connection between these three performance parameters: an increase in SARs and a decrease in radiation efficiency occur compared to the general trend when the bandwidth reaches its maximum. This happens when the resonant frequency of the chassis equals that of the antenna.