Base station

About: Base station is a research topic. Over the lifetime, 85883 publications have been published within this topic receiving 1019303 citations. The topic is also known as: Mobile phone base stations & BS.

Area spectral efficiency of cellular mobile radio systems

Abstract: A general analytical framework quantifying the spectral efficiency of cellular systems with variable-rate transmission is introduced. This efficiency, the area spectral efficiency, defines the sum of the maximum average data rates per unit bandwidth per unit area supported by a cell's base station. Expressions for this efficiency as a function of the reuse distance for the worst and best case interference configurations are derived. Moreover, Monte Carlo simulations are developed to estimate the value of this efficiency for average interference conditions. Both fully loaded and partially loaded cellular systems are investigated. The effect of random user location is taken into account, and the impact of lognormal shadowing and Nakagami (1960) multipath fading is also studied.

Locating a mobile station using a plurality of wireless networks and applications therefor

Abstract: A location is disclosed for wireless telecommunication infrastructures. The systems output requested locations of hand sets or mobile stations (MS) based on, e.g., AMPS, NAMPS, CDMA or TDMA communication standards. The system determines both local MS locations, and more global MS location requests via, e.g., Internet communication. The system uses a plurality of mobile station locating technologies, including those based on, e.g., (1) two-way TOA and TDOA; (2) home base stations and (3) distributed antenna provisioning. The system is useful for 911 emergency calls, tracking, routing, people and animal location including applications for confinement to and exclusion from certain areas. The system is particularly useful for estimating a location of an MS using information received from a commercial mobile radio service provider (CMRS) for which the MS is not registered for subscriber services.

Handover and channel assignment in mobile cellular networks

Abstract: A taxonomy of channel assignment strategies is provided, and the complexity in each cellular component is discussed. Various handover scenarios and the roles of the base station and the mobile switching center are considered. Prioritization schemes are discussed, and the required intelligence distribution among the network components is defined. >

Fundamentals of wireless communications

Abstract: Radio Frequency (RF) communications are an important smart grid enabler for functions such as volt/VAR control, recloser control, and feeder restorations and isolation. This paper will give a basic tutorial on the types of radio frequency communications and the benefits and liabilities of each. Specific topics to be explored will be licensed verses unlicensed frequencies, distance between remote radios and base stations, and communications architectures. Radio technology is often referred in numerical ranges or frequencies. The decision on which frequency to employ in a network depends on a few key variables. Prior to deciding which frequency for a network, the application for the radio use will assist with dictation of which frequency range to utilize. Applications such as recloser control and volt/Var control may require a radio device that can provide a high bandwidth/fast speed solution. Other SCADA applications such as sensor monitoring may only require small bandwidth and for data delivery to be at a much slower speed. Another variable when deciding on a radio network is the distance from the main SCADA hosts to end remote devices such as RTUs or PLCs. Lower end frequencies (100 MHz-900 MHz) provide further coverage and greater distance from base stations/Access Points to remote end devices, whereas higher frequencies (2.4 GHz-5.8 GHz) provide shorter distance coverage, but higher bandwidth and relay data back to SCADA hosts much faster. Determining a network's architecture should focus on either the desire of a private, licensed network or the notion of an unlicensed, less expensive network. The lower licensed frequency ranges (100 MHz, 200 MHz, 400 MHz and upper 900 MHz bands) are often referred to as MAS (Multiple Address Systems) networks and require license acquisition from the FCC once geographical coverage is determined. These licenses are granted for the lower frequencies as mentioned previously but are considered the proprietary use of the owner. Anyone operating in these frequencies will be fined/cited by the FCC. The less expensive, unlicensed network is allowable for frequencies ranging from 902 MHz-928 MHz, which is defined as the ISM (Industrial, Scientific, and Medical) bands. Within the unlicensed frequency band, there exist registered bands (3.65 GHz) that employ WiMax (Wireless Microwave Access for Broadband) technology that provide shorter coverage for remote devices, however, the bandwidth and speed provided by these frequencies make them just as popular for networks. Further analysis and discussion of licensed versus unlicensed radio wireless communications is proposed in this paper.

QoS issues in ad hoc wireless networks

Abstract: Ad hoc wireless networks consist of mobile nodes interconnected by multihop communication paths. Unlike conventional wireless networks, ad hoc networks have no fixed network infrastructure or administrative support. The topology of the network changes dynamically as mobile nodes join or depart the network or radio links between nodes become unusable. This article addresses some of the quality of service issues for ad hoc networks which have started to receive increasing attention in the literature. The focus is on QoS routing. This is a complex and difficult issue because of the dynamic nature of the network topology and generally imprecise network state information. We present the basic concepts and discuss some of the results. The article concludes with some observations on the open areas for further investigation.