Topic
Bilayer
About: Bilayer is a research topic. Over the lifetime, 25255 publications have been published within this topic receiving 822069 citations.
Papers published on a yearly basis
Papers
More filters
TL;DR: The transparency, conductivity, and ambipolar transfer characteristics of the films suggest their potential as another materials candidate for electronics and opto-electronic applications.
Abstract: In this work we present a low cost and scalable technique, via ambient pressure chemical vapor deposition (CVD) on polycrystalline Ni films, to fabricate large area (∼cm2) films of single- to few-layer graphene and to transfer the films to nonspecific substrates. These films consist of regions of 1 to ∼12 graphene layers. Single- or bilayer regions can be up to 20 μm in lateral size. The films are continuous over the entire area and can be patterned lithographically or by prepatterning the underlying Ni film. The transparency, conductivity, and ambipolar transfer characteristics of the films suggest their potential as another materials candidate for electronics and opto-electronic applications.
5,663 citations
TL;DR: An improved and extended version of the coarse grained lipid model is presented, coined the MARTINI force field, based on the reproduction of partitioning free energies between polar and apolar phases of a large number of chemical compounds to reproduce the free energies of these chemical building blocks.
Abstract: We present an improved and extended version of our coarse grained lipid model. The new version, coined the MARTINI force field, is parametrized in a systematic way, based on the reproduction of partitioning free energies between polar and apolar phases of a large number of chemical compounds. To reproduce the free energies of these chemical building blocks, the number of possible interaction levels of the coarse-grained sites has increased compared to those of the previous model. Application of the new model to lipid bilayers shows an improved behavior in terms of the stress profile across the bilayer and the tendency to form pores. An extension of the force field now also allows the simulation of planar (ring) compounds, including sterols. Application to a bilayer/cholesterol system at various concentrations shows the typical cholesterol condensation effect similar to that observed in all atom representations.
4,580 citations
TL;DR: Measurements show that mobilities higher than 200 000 cm2/V s are achievable, if extrinsic disorder is eliminated and a sharp (thresholdlike) increase in resistivity observed above approximately 200 K is unexpected but can qualitatively be understood within a model of a rippled graphene sheet in which scattering occurs on intraripple flexural phonons.
Abstract: We have studied temperature dependences of electron transport in graphene and its bilayer and found extremely low electron-phonon scattering rates that set the fundamental limit on possible charge carrier mobilities at room temperature. Our measurements show that mobilities higher than 200 000 cm2/V s are achievable, if extrinsic disorder is eliminated. A sharp (thresholdlike) increase in resistivity observed above approximately 200 K is unexpected but can qualitatively be understood within a model of a rippled graphene sheet in which scattering occurs on intraripple flexural phonons.
3,100 citations
TL;DR: In this paper, the authors describe the synthesis of bilayer graphene thin films deposited on insulating silicon carbide and report the characterization of their electronic band structure using angle-resolved photoemission.
Abstract: We describe the synthesis of bilayer graphene thin films deposited on insulating silicon carbide and report the characterization of their electronic band structure using angle-resolved photoemission. By selectively adjusting the carrier concentration in each layer, changes in the Coulomb potential led to control of the gap between valence and conduction bands. This control over the band structure suggests the potential application of bilayer graphene to switching functions in atomic-scale electronic devices.
2,988 citations
TL;DR: In this article, a coarse-grained (CG) model for lipid and surfactant systems is presented, where only a small number of coarse grained atom types interact using a few discrete levels of interaction.
Abstract: This paper describes the parametrization of a new coarse grained (CG) model for lipid and surfactant systems. Reduction of the number of degrees of freedom together with the use of short range potentials makes it computationally very efficient. Compared to atomistic models a gain of 3-4 orders of magnitude can be achieved. Micrometer length scales or millisecond time scales are therefore within reach. To encourage applications, the model is kept very simple. Only a small number of coarse grained atom types are defined, which interact using a few discrete levels of interaction. Despite the computational speed and the simplistic nature of the model, it proves to be both versatile in its applications and accurate in its predictions. We show that densities of liquid alkanes from decane up to eicosane can be reproduced to within 5%, and the mutual solubilities of alkanes in water and water in alkanes can be reproduced within 0.5 kT of the experimental values. The CG model for dipalmitoylphosphatidylcholine (DPPC) is shown to aggregate spontaneously into a bilayer. Structural properties such as the area per headgroup and the phosphate-phosphate distance match the experimentally measured quantities closely. The same is true for elastic properties such as the bending modulus and the area compressibility, and dynamic properties such as the lipid lateral diffusion coefficient and the water permeation rate. The distribution of the individual lipid components along the bilayer normal is very similar to distributions obtained from atomistic simulations. Phospholipids with different headgroup (ethanolamine) or different tail lengths (lauroyl, stearoyl) or unsaturated tails (oleoyl) can also be modeled with the CG force field. The experimental area per headgroup can be reproduced for most lipids within 0.02 nm(2). Finally, the CG model is applied to nonbilayer phases. Dodecylphosphocholine (DPC) aggregates into small micelles that are structurally very similar to ones modeled atomistically, and DOPE forms an inverted hexagonal phase with structural parameters in agreement with experimental data.
2,062 citations