Topic
Brillouin scattering
About: Brillouin scattering is a research topic. Over the lifetime, 11426 publications have been published within this topic receiving 178306 citations.
Papers published on a yearly basis
Papers
More filters
TL;DR: A review of the work performed on Brillouin scattering under high pressure in diamond anvil cells, emphasizing the most recent results, can be found in this paper, where the authors present a detailed analysis of the results.
Abstract: Brillouin scattering allows the determination of acoustic velocities and adiabatic elastic moduli in matter. These data are crucial in many areas of science, such as fundamental physics, geosciences and technology, especially when measured as a function of the density (pressure). In this paper, we present a review of the work performed on Brillouin scattering under high pressure in diamond anvil cells, emphasizing the most recent results. Copyright © 2003 John Wiley & Sons, Ltd.
56 citations
TL;DR: The melting curve and fluid equation of state of carbon dioxide have been determined under high pressure in a resistively heated diamond anvil cell and the results show that the fluid above 500 K is less compressible than predicted from various phenomenological models.
Abstract: The melting curve and fluid equation of state of carbon dioxide have been determined under high pressure in a resistively-heated diamond anvil cell. The melting line was determined from room temperature up to $11.1\pm0.1$ GPa and $800\pm5$ K by visual observation of the solid-fluid equilibrium and in-situ measurements of pressure and temperature. Raman spectroscopy was used to identify the solid phase in equilibrium with the melt, showing that solid I is the stable phase along the melting curve in the probed range. Interferometric and Brillouin scattering experiments were conducted to determine the refractive index and sound velocity of the fluid phase. A dispersion of the sound velocity between ultrasonic and Brillouin frequencies is evidenced and could be reproduced by postulating the presence of a thermal relaxation process. The Brillouin sound velocities were then transformed to thermodynamic values in order to calculate the equation of state of fluid CO$\_2$. An analytic formulation of the density with respect to pressure and temperature is proposed, suitable in the $P-T$ range 0.1-8 GPa and 300-700 K and accurate within 2%. Our results show that the fluid above 500 K is less compressible than predicted from various phenomenological models.
56 citations
TL;DR: A wideband tunable optoelectronic oscillator (OEO) based on the deamplification of stimulated Brillouin scattering (SBS) is proposed and experimentally demonstrated and the experimental results agree well with the theoretical models.
Abstract: A wideband tunable optoelectronic oscillator (OEO) based on the deamplification of stimulated Brillouin scattering (SBS) is proposed and experimentally demonstrated. A tunable single passband microwave photonic filter (MPF) utilizing phase modulation and SBS deamplification is used to realize the tunability of the OEO. Theoretical analysis of the MPF and phase noise performance of the OEO are presented. The frequency response of the MPF is determined by the + 1st sideband attenuation due to SBS deamplification and phase shift difference between the two sidebands due to chromatic dispersion and SBS. The close-in (< 1 MHz) phase noise of the proposed OEO is shown to be dominated by the laser frequency noise via phase shift of SBS. The conversion of the laser frequency noise to the close-in phase noise of the proposed OEO is effectively reduced compared with the OEO based on amplification by SBS. Tunable 7 to 40 GHz signals are experimentally obtained. The single-sideband (SSB) phase noise at 10 kHz offset is −128 dBc/Hz for 10.30 GHz signal. Compared with the OEO based on SBS amplification, the proposed OEO can achieve a phase noise performance improvement beyond 20 dB at 10 kHz offset. The maximum frequency and power drifts at 10.69 GHz are within 1 ppm and 1.4 dB during 1000 seconds, respectively. To achieve better close-in phase noise performance, lower frequency noise laser and higher pump power are preferred. The experimental results agree well with the theoretical models.
56 citations
TL;DR: In this article, the authors used optical fiber embedded throughout the concrete pavement continuously reinforced with FRP bars in Highway 40 East, Montreal, Quebec to detect impact waves caused by cars and trucks passing on these pavements at a sampling rate of 10 kHz.
Abstract: For the first time to our knowledge, distributed impact waves due to the highway traffic on concrete slabs reinforced with FRP bars are monitored in real time using stimulated Brillouin scattering. The impact wave is caused by the traffic passing on the highway pavement at high speed (>100 km h−1), which induced pressure on the concrete slabs, and in turn created a local birefringence change, leading to variation of the local state of polarization change (SOP). The pump and probe waves of the stimulated Brillouin scattering 'see' the SOP change and react with a decrease of the Brillouin gain or loss signal, when the pump and probe waves have the same input polarization state. The frequency difference between the pump and probe waves are locked at the static-strain-related Brillouin frequency. Optical fiber was embedded throughout the concrete pavement continuously reinforced with FRP bars in Highway 40 East, Montreal, Quebec to detect impact waves caused by cars and trucks passing on these pavements at a sampling rate of 10 kHz. A spatial resolution of 2 m was used over a sensing length of 300 m.
56 citations
TL;DR: In this paper, a narrow-band cw dye laser through the A-exciton transition at helium temperatures was tuned for resonance enhancement, and the authors observed a pronounced asymmetry of the Stokes and anti-Stokes shift and a dramatic increase of the Brillouin shifts as a function of laser frequency.
56 citations