Topic
Built up edge
About: Built up edge is a research topic. Over the lifetime, 238 publications have been published within this topic receiving 3837 citations.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this article, the machinability of silicon carbide particulate aluminium metal matrix composite during turning using fixed rhombic tools was investigated during the fabrication of Al/SiC-MMC and the influence of machining parameters, e.g. cutting speed, feed rate and depth of cut on the tools wear and built-up edges (BUEs) were analyzed.
293 citations
TL;DR: In this paper, laser surface texturing was applied to texture the rake face of the cutting tool with different textures (dimples and channels) to allow for changing the adhesion tendency of built-up edge (BUE) structures.
210 citations
TL;DR: In this paper, two techniques are used to avoid this problem: emulsion of oil in water, and spray of oil micro-drops in air, and the influence of the position of the injection nozzle in relation to the feed direction is experimentally studied.
199 citations
TL;DR: In this article, three components of the cutting forces developed during face milling were measured using a strain gauge-based dynamometer, depending on the chip cross-section and the cutting speed.
140 citations
TL;DR: In this paper, a study of the BUL and BUE formation mechanisms, their evolution and their influence on the dry turned aeronautical workpieces surface quality has been achieved.
136 citations