Topic
Calibration curve
About: Calibration curve is a research topic. Over the lifetime, 6552 publications have been published within this topic receiving 95128 citations.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, the particle acidity of secondary organic aerosol (SOA) created from ozonolysis of α-pinene in the presence of acidic inorganic seed aerosols was investigated using an indoor Teflon film chamber.
Abstract: The particle acidity of secondary organic aerosol (SOA) created from ozonolysis of α-pinene in the presence of acidic inorganic seed aerosols was investigated using an indoor Teflon film chamber. Colorimetry integrated with a reflectance UV-Visible spectrometer was used for the first time to dynamically measure the aerosol acidity over time. An external calibration curve was produced based on the correlation between the proton mass (ng) collected on the filter, which was impregnated with metanil yellow, and the absorbance of the reflectance UV-Visible spectra for the protonated and the unprotonated metanil yellow on the filter. Using this calibration curve, the particle acidity of the submicron acidic sulfate aerosol coated with SOA was measured from the reflectance UV-Visible spectra of filter samples. The colorimetric analysis requires a short sampling time (less than 2 m) for SOA studies using the laboratory Teflon film chamber and eliminates extraction of the filter sample with water. Results show tha...
34 citations
TL;DR: In this paper, an easy applicable method for the simultaneous quantitation of over 80 forensically relevant compounds in 11 different postmortem matrices was developed and validated overcoming the challenges of high inter-matrix and intra-multimrix concentration variances.
Abstract: Postmortem redistribution (PMR) is one of numerous problems in postmortem toxicology making correct interpretation of measured drug concentrations difficult or even impossible. Time-dependent PMR in peripheral blood and especially in tissue samples is still under-explored. For further investigation, an easy applicable method for the simultaneous quantitation of over 80 forensically relevant compounds in 11 different postmortem matrices should be developed and validated overcoming the challenges of high inter-matrix and intra-matrix concentration variances. Biopsy samples (20 mg) or body fluids (20 μL) were spiked with an analyte mix and deuterated internal standards, extracted by liquid-liquid extraction, and analyzed by liquid chromatography tandem mass spectrometry (LC-MS/MS). For highest applicability, an easy solvent calibration was used. Furthermore, time-consuming dilution of high concentration samples showing detector saturation was circumvented by two overlapping calibration curves using 12C isotope monitoring for low concentrations and 13C isotopes for high concentration, respectively. The method was validated according to international guidelines with modifications. Matrix effects and extraction efficiency were strongly matrix and analyte dependent. In general, brain and adipose tissue produced the highest matrix effects, whereas cerebrospinal fluid showed the least matrix effects. Accuracy and precision results were rather matrix independent with some exceptions. Despite using an external solvent calibration, the accuracy requirements were fulfilled for 66 to 81 % of the 83 analytes. Depending on the matrix, 75–93 % of the analytes showed intra-day precisions at <20 %. 12C and 13C calibrations gave comparable results and proved to be a useful tool in expanding the dynamic range.
34 citations
TL;DR: In this article, two samples of cellulose (molecular weight 2.97 × 105 and 1.25 × 105) were transformed into carbanilates (CTC) which were then fractionated by the elution method at a constant composition of the acetone-water elution mixture with the column temperature gradually increasing from −30°C to 30°C, and by the GPC method in acetone and tetrahydrofuran.
Abstract: Two samples of cellulose (molecular weight 2.97 × 105 and 1.25 × 105) were transformed into carbanilates (CTC) which were then fractionated by the elution method at a constant composition of the acetone-water elution mixture with the column temperature gradually increasing from −30°C to 30°C, and by the GPC method in acetone and tetrahydrofuran. Tetrahydrofuran appeared to be a more suitable solvent. The molecular weights of fractions obtained by the elution fractionation were determined by the light-scattering method in tetrahydrofuran. The width of fractions was determined by the GPC method (average Mw/Mn = 1.37); the [η] values and the Mark-Houwink constants (K = 5.3 × 10-3, a = 0.84) for tetrahydrofuran at 25°C were determined. The calibration curve for the GP method was constructed by means of the fractions thus obtained; it was demonstrated that the universal calibration curve according to Benoit can also be used. It was demonstrated that the molecular weight distribution of cellulose can be conveniently determined by conversion into CTC followed either by the elution fractionation (for preparative purposes) or by fractionation by the GPC method (for analytical purposes).
34 citations
TL;DR: The analysis of two standard reference materials and a used oil sample produced results comparable to those found by inductively coupled plasma atomic emission spectrometry.
34 citations
TL;DR: A calibration equation that accounts for local and global space charge is shown to provide mass accuracy with external calibration that is nearly identical to that of internal calibration, without the drawbacks of experimental complexity or reduction of abundance dynamic range.
34 citations