Cobalt

About: Cobalt is a research topic. Over the lifetime, 69899 publications have been published within this topic receiving 1242058 citations. The topic is also known as: Co & Element 27.

A Janus Nickel Cobalt Phosphide Catalyst for High-Efficiency Neutral-pH Water Splitting.

Abstract: Transition-metal phosphides have stimulated great interest as catalysts to drive the hydrogen evolution reaction (HER), but their use as bifunctional catalytic electrodes that enable efficient neutral-pH water splitting has rarely been achieved. Herein, we report the synthesis of ternary Ni0.1 Co0.9 P porous nanosheets onto conductive carbon fiber paper that can efficiently and robustly catalyze both the HER and water oxidation in 1 m phosphate buffer (PBS; pH 7) electrolyte under ambient conditions. A water electrolysis cell comprising the Ni0.1 Co0.9 P electrodes demonstrates remarkable activity and stability for the electrochemical splitting of neutral-pH water. We attribute this performance to the new ternary Ni0.1 Co0.9 P structure with porous surfaces and favorable electronic states resulting from the synergistic interplay between nickel and cobalt. Ternary metal phosphides hold promise as efficient and low-cost catalysts for neutral-pH water splitting devices.

Heterogeneous activation of peroxymonosulfate by supported cobalt catalysts for the degradation of 2,4-dichlorophenol in water: The effect of support, cobalt precursor, and UV radiation

Abstract: In order to generate sulfate radicals (SRs) as oxidizing species for the degradation of 2,4-dichlorophenol (2,4-DCP) in water, we explored heterogeneous activation of peroxymonosulfate (PMS) by supported cobalt catalysts. More attention was given to the effect of support materials (Al2O3, SiO2, TiO2) and cobalt precursors (Co(NO3)2, CoCl2, CoSO4) on cobalt–support interaction, cobalt leaching, and reactivity of the catalysts. Especially, the feasibility of simultaneous generation of SRs and hydroxyl radicals (HRs) in PMS-Co/TiO2 systems was first studied under ultraviolet (UV) radiation. Much lower cobalt leaching was observed in Co/Al2O3 and Co/TiO2 systems than that of Co/SiO2 most probably due to their relatively strong cobalt-support interaction. Co/TiO2 catalyst prepared with Co(NO3)2, compared to CoCl2 or CoSO4 (where Cl− and SO42−, respectively, were not completely removed upon heat treatment at 500 °C), showed strong cobalt–support interaction, and thereby exhibited negligible cobalt leaching. Under UV radiation, Co/TiO2 at Co/Ti molar ratio of 0.001 showed significant improvement in the degradation of 2,4-DCP due to HRs. The effective generation of HRs in the system can be explained with Co(III)-mediated charge transfer from the photoinduced electrons to PMS, inducing facilitation of photoinduced electron-hole separation. However, high cobalt loading (i.e., Co/Ti molar ratio of 0.1) on TiO2 surface exhibited negligible enhancement of 2,4-DCP transformation under UV radiation since the penetration of UV light to TiO2 was prohibited by the cobalt.

Engineering electrocatalytic activity in nanosized perovskite cobaltite through surface spin-state transition.

Abstract: The activity of electrocatalysts exhibits a strongly dependence on their electronic structures. Specifically, for perovskite oxides, Shao-Horn and co-workers have reported a correlation between the oxygen evolution reaction activity and the eg orbital occupation of transition-metal ions, which provides guidelines for the design of highly active catalysts. Here we demonstrate a facile method to engineer the eg filling of perovskite cobaltite LaCoO3 for improving the oxygen evolution reaction activity. By reducing the particle size to ∼80 nm, the eg filling of cobalt ions is successfully increased from unity to near the optimal configuration of 1.2 expected by Shao-Horn’s principle. Consequently, the activity is significantly enhanced, comparable to those of recently reported cobalt oxides with eg∼1.2 configurations. This enhancement is ascribed to the emergence of spin-state transition from low-spin to high-spin states for cobalt ions at the surface of the nanoparticles, leading to more active sites with increased reactivity. The activity of electrocatalysts exhibits a strong dependence on their electronic structures. Here, the authors manipulate the eg filling of perovskite cobaltite LaCoO3nanoparticles by changing particle size and show improved oxygen evolution activity with increased numbers of surface high-spin cobalt ions.