Communication channel

About: Communication channel is a research topic. Over the lifetime, 137411 publications have been published within this topic receiving 1715077 citations. The topic is also known as: communication channel & communications channel.

Subspace methods for the blind identification of multichannel FIR filters

Abstract: This paper addresses a problem arising in a context of digital communications. A digital source is transmitted through a continuous channel (the propagation medium), and several measurements are performed at the receiver, either by means of several sensors, or by oversampling the received signal compared to the emission rate. Given only these observations, the baseband equivalents of the corresponding channels have to be recovered. An orthogonality property between "signal" and "noise" subspaces is exploited to build some quadratic form whose minimization yields the desired estimates up to a scale factor. This is in the same spirit as recent works by Tong et al. (see Proc. 25th Asilomar Conf., p.856-860, 1991) but requires fewer computations. Numerical simulations demonstrate the performance of the proposed methods in a channel identification context. >

Channel estimation techniques based on pilot arrangement in OFDM systems

Abstract: Channel estimation techniques for OFDM systems based on a pilot arrangement are investigated. Channel estimation based on a comb type pilot arrangement is studied through different algorithms for both estimating the channel at pilot frequencies and interpolating the channel. Channel estimation at pilot frequencies is based on LS and LMS methods while channel interpolation is done using linear interpolation, second order interpolation, low-pass interpolation, spline cubic interpolation, and time domain interpolation. Time-domain interpolation is obtained by passing to the time domain by means of IDFT (inverse discrete Fourier transform), zero padding and going back to the frequency domain by DFT (discrete Fourier transform). In addition, channel estimation based on a block type pilot arrangement is performed by sending pilots in every sub-channel and using this estimation for a specific number of following symbols. We have also implemented a decision feedback equalizer for all sub-channels followed by periodic block-type pilots. We have compared the performances of all schemes by measuring bit error rates with 16QAM, QPSK, DQPSK and BPSK as modulation schemes, and multipath Rayleigh fading and AR based fading channels as channel models.

Secure Transmission With Multiple Antennas—Part II: The MIMOME Wiretap Channel

Abstract: The capacity of the Gaussian wiretap channel model is analyzed when there are multiple antennas at the sender, intended receiver and eavesdropper. The associated channel matrices are fixed and known to all the terminals. A computable characterization of the secrecy capacity is established as the saddle point solution to a minimax problem. The converse is based on a Sato-type argument used in other broadcast settings, and the coding theorem is based on Gaussian wiretap codebooks. At high signal-to-noise ratio (SNR), the secrecy capacity is shown to be attained by simultaneously diagonalizing the channel matrices via the generalized singular value decomposition, and independently coding across the resulting parallel channels. The associated capacity is expressed in terms of the corresponding generalized singular values. It is shown that a semi-blind "masked" multi-input multi-output (MIMO) transmission strategy that sends information along directions in which there is gain to the intended receiver, and synthetic noise along directions in which there is not, can be arbitrarily far from capacity in this regime. Necessary and sufficient conditions for the secrecy capacity to be zero are provided, which simplify in the limit of many antennas when the entries of the channel matrices are independent and identically distributed. The resulting scaling laws establish that to prevent secure communication, the eavesdropper needs three times as many antennas as the sender and intended receiver have jointly, and that the optimum division of antennas between sender and intended receiver is in the ratio of 2:1.

Communication Strategies in Marketing Channels: A Theoretical Perspective:

Abstract: Though the marketing literature acknowledges that communication plays a vital role in channel functioning, it provides no integrated theory for channel communication. The authors build a theoretica...

Underwater acoustic communication channels: Propagation models and statistical characterization

Abstract: Acoustic propagation is characterized by three major factors: attenuation that increases with signal frequency, time-varying multipath propagation, and low speed of sound (1500 m/s). The background noise, although often characterized as Gaussian, is not white, but has a decaying power spectral density. The channel capacity depends on the distance, and may be extremely limited. Because acoustic propagation is best supported at low frequencies, although the total available bandwidth may be low, an acoustic communication system is inherently wideband in the sense that the bandwidth is not negligible with respect to its center frequency. The channel can have a sparse impulse response, where each physical path acts as a time-varying low-pass filter, and motion introduces additional Doppler spreading and shifting. Surface waves, internal turbulence, fluctuations in the sound speed, and other small-scale phenomena contribute to random signal variations. At this time, there are no standardized models for the acoustic channel fading, and experimental measurements are often made to assess the statistical properties of the channel in particular deployment sites.