Direct digital synthesizer

About: Direct digital synthesizer is a research topic. Over the lifetime, 4214 publications have been published within this topic receiving 45503 citations.

Optical frequency synthesizer for precision spectroscopy

Abstract: We have used the frequency comb generated by a femtosecond mode-locked laser and broadened to more than an optical octave in a photonic crystal fiber to realize a frequency chain that links a 10 MHz radio frequency reference phase-coherently in one step to the optical region. By comparison with a similar frequency chain we set an upper limit for the uncertainty of this new approach to 5. 1x10(-16). This opens the door for measurement and synthesis of virtually any optical frequency and is ready to revolutionize frequency metrology.

A 27-mW CMOS fractional-N synthesizer using digital compensation for 2.5-Mb/s GFSK modulation

Abstract: A digital compensation method and key circuits are presented that allow fractional-N synthesizers to be modulated at data rates greatly exceeding their bandwidth. Using this technique, a 1.8-GHz transmitter capable of digital frequency modulation at 2.5 Mb/s can be achieved with only two components: a frequency synthesizer and a digital transmit filter. A prototype transmitter was constructed to provide proof of concept of the method; its primary component is a custom fractional-N synthesizer fabricated in a 0.6-/spl mu/m CMOS process that consumes 27 mW. Key circuits on the custom IC are an on-chip loop filter that requires no tuning or external components, a digital MASH /spl Sigma/-/spl Delta/ modulator that achieves low power operation through pipelining, and an asynchronous, 64-modulus divider (prescaler). Measurements from the prototype indicate that it meets performance requirements of the digital enhanced cordless telecommunications (DECT) standard.

A Low-Noise Wide-BW 3.6-GHz Digital $\Delta\Sigma$ Fractional-N Frequency Synthesizer With a Noise-Shaping Time-to-Digital Converter and Quantization Noise Cancellation

Abstract: A 3.6-GHz digital fractional-N frequency synthesizer achieving low noise and 500-kHz bandwidth is presented. This architecture uses a gated-ring-oscillator time-to-digital converter (TDC) with 6-ps raw resolution and first-order shaping of its quantization noise along with digital quantization noise cancellation to achieve integrated phase noise of less than 300 fs (1 kHz to 40 MHz). The synthesizer includes two 10-bit 50-MHz passive digital-to-analog converters for digital control of the oscillator and an asynchronous frequency divider that avoids divide-value delay variation at its output. Implemented in a 0.13-mum CMOS process, the prototype occupies 0.95-mm2 active area and dissipates 39 mW for the core parts with another 8 mW for the oscillator output buffer. Measured phase noise at 3.67 GHz carrier frequency is -108 and -150 dBc/Hz at 400 kHz and 20 MHz offset, respectively.

Patient interactive neurostimulation system and method

Abstract: A fully automated computer controlled system is provided for adjustment of neurostimulation implants used in pain therapy and in treating neurological dysfunction which includes a patient interactive computer, and a universal transmitter interface integrally embedded in the patient interactive computer or built into the antenna which is capable of stimulating any type of implanted neurostimulation devices by imitating programming codes. The patient interacts with the system through the patient interactive computer. The universal transmitter interface includes a direct digital synthesizer, a transistor circuitry driving the antenna in ON-OFF fashion and a gating unit for driving the transistor circuitry under control of the processing means in the patient-interactive computer. Alternatively, the universal transmitting interface includes a balanced modulator for modulation of the carrier signal generated at the direct digital synthesizer.

Microwave synthesizer using an on-chip Brillouin oscillator

Abstract: Low-phase-noise microwave oscillators are important to a wide range of subjects, including communications, radar and metrology. Photonic-based microwave-wave sources now provide record, close-to-carrier phase-noise performance, and compact sources using microcavities are available commercially. Photonics-based solutions address a challenging scaling problem in electronics, increasing attenuation with frequency. A second scaling challenge, however, is to maintain low phase noise in reduced form factor and even integrated systems. On this second front, there has been remarkable progress in the area of microcavity devices with large storage time (high optical quality factor). Here we report generation of highly coherent microwaves using a chip-based device that derives stability from high optical quality factor. The device has a record low electronic white-phase-noise floor for a microcavity-based oscillator and is used as the optical, voltage-controlled oscillator in the first demonstration of a photonic-based, microwave frequency synthesizer. The synthesizer performance is comparable to mid-range commercial devices.