Direct-sequence spread spectrum

About: Direct-sequence spread spectrum is a research topic. Over the lifetime, 5185 publications have been published within this topic receiving 69133 citations.

MMSE interference suppression for direct-sequence spread-spectrum CDMA

Abstract: We consider interference suppression for direct-sequence spread-spectrum code-division multiple-access (CDMA) systems using the minimum mean squared error (MMSE) performance criterion. The conventional matched filter receiver suffers from the near-far problem, and requires strict power control (typically involving feedback from receiver to transmitter) for acceptable performance. Multiuser detection schemes previously proposed mitigate the near-far problem, but are complex and require explicit knowledge or estimates of the interference parameters. In this paper, we present and analyze several new MMSE interference suppression schemes, which have the advantage of being near-far resistant (to varying degrees, depending on their complexity), and can be implemented adaptively when interference parameters are unknown and/or time-varying, Numerical results are provided that show that these schemes offer significant performance gains relative to the matched filter receiver. We conclude that MMSE detectors can alleviate the need for stringent power control. In CDMA systems, and may be a practical alternative to the matched filter receiver. >

Spread spectrum fiber-optic local area network using optical processing

Abstract: Spread spectrum code division multiple access (CDMA) allows asynchronous multiple access to a local area network (LAN) with no waiting. The additional bandwidth required by spread spectrum can be accommodated by using a fiber-optic channel and incoherent optical signal processing. New CDMA sequences are designed specifically for optical processing. It is shown that increasing the number of chips per bit, by using optical processing, allows an increase in capacity of a CDMA LAN. An experiment is performed demonstrating the performance of an optical CDMA LAN, operating at 100 Mbd with three users.

Diversity receiver in a cdma cellular telephone system

Abstract: A spread spectrum receiver subsystem for utilization in a CDMA cellular telephone having a searcher receiver (44) for scanning the time domain so as to use the PN processing gain and time discrimination properties of spread spectrum coding to determine the location in the time domain and the received signal strength of multiple receptions of a pilot signal traveling upon one or more physical propagation paths to reception The searcher receiver (44) provides a control signal indicative of the received pilot signals of greatest strength and corresponding time relationship A data receiver (40, 42) receives spread spectrum communication signals accompanying each received pilot signal and is responsive to the searcher control signal for acquiring and demodulating a spread spectrum communication signal, concomitant with the pilot signal of greatest signal strength, and thus providing a corresponding encoded output signal bearing information

Interference rejection techniques in spread spectrum communications

Abstract: It is argued that the ability of a spread-spectrum system to withstand interference, both intentional and unintentional, is probably its greatest asset. Any spread spectrum receiver can only suppress a given amount of interference; if the level of interference becomes too great, the system will not function properly. Even under these latter circumstances, however, other techniques, which enhance the performance of the system over and above the performance improvement that comes automatically to systems from using spread spectrum, are available for use. These techniques typically involve some type of additional signal processing and are examined here. Two general types of narrowband interference suppression schemes are discussed and an overview is presented for several other techniques. The two classes of rejection schemes emphasized are (1) those based on least-mean-square estimation techniques, and (2) those based on transform-domain processing structures. >

Spread spectrum for mobile communications

Abstract: The characteristics of spread spectrum that make it advantageous for mobile communications are described. The parameters that determine both the performance and the total capacity are introduced, and an analysis which yields (approximately) the number of users that can simultaneously communicate, while maintaining a specified level of performance, is presented. Spread spectrum overlay, wherein a code-division multiple-access (CDMA) network shares a frequency band with narrow-band users, is analyzed, and it is seen that excision of the narrowband signals from the CDMA receivers before despreading can improve both performance and capacity. >