Topic
Electrical discharge machining
About: Electrical discharge machining is a research topic. Over the lifetime, 13334 publications have been published within this topic receiving 147523 citations. The topic is also known as: electrodischarge machining.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, the machining characteristics of Ti-6A1-4V were investigated with kerosene and distilled water as the dielectrics, and the results showed that the material removal rate is greater and the relative electrode wear ratio is lower, when machining in distilled water rather than in keroene.
261 citations
TL;DR: In this article, the authors presented an effective approach for the optimization of the wire electric discharge machining (WEDM) process of Al2O3 particle-reinforced material (6061 alloy) with multiple performance characteristics based on the grey relational analysis.
259 citations
TL;DR: In this article, the application of the Taguchi method with fuzzy logic for optimizing the electrical discharge machining process with multiple performance characteristics has been reported, where a multi-response performance index is used to solve the Electrical Discharge Machining Process with Multiple Performance Attributes (EDMP) problem.
254 citations
TL;DR: In this paper, it was shown that the removal mechanisms for machining conductive ceramics differ from those involved in metal machining, and that the grain structure evinced by the ceramic must be as fine and homogeneous as possible.
254 citations
TL;DR: This study attempts to model and optimize the complex electrical discharge machining process using soft computing techniques, and a pareto-optimal set has been predicted in this work.
254 citations