Electron backscatter diffraction

About: Electron backscatter diffraction is a research topic. Over the lifetime, 15184 publications have been published within this topic receiving 317847 citations. The topic is also known as: EBSD.

Role of melt pool boundary condition in determining the mechanical properties of selective laser melting AlSi10Mg alloy

Abstract: We describe here a comprehensive study on the effect of cellular structure and melt pool boundary (MPB) condition on the mechanical properties, deformation and failure behavior of AlSi10Mg alloy processed by selective laser melting (SLM). The morphology of melt pool (MP) on the load bearing face of tensile samples was significantly different with build directions. It resulted in different mechanical properties of the samples with different build directions. Furthermore, the microstructure analysis revealed that the MP in the SLM AlSi10Mg alloy mainly consisted of columnar α-Al grains which were made of ultra-fine elongated cellular structure. Electron back-scatter diffraction (EBSD) analysis revealed that the long axis of cellular structure and columnar grains were parallel to , which resulted in fiber texture in SLM AlSi10Mg alloy. However, Schmid factor calculation demonstrated that the anisotropy of mechanical properties of the SLM AlSi10Mg alloy built with different direction was mainly dependent on the distribution of MPB on the load bearing face, and not texture. The defects including pores, residual stress and heat affected zone (HAZ) located at MPB made it the weakest part in the SLM AlSi10Mg. The sample built along horizontal direction exhibited good combination of strength and plasticity and is attributed to the lowest fraction of MPBs that withstand load during tensile. MPB had strong influence on the mechanical properties and failure behavior of SLM AlSi10Mg built with different directions.

Electron Microscope and Diffraction Study of Metal Crystal Textures by Means of Thin Sections

Abstract: Bethe's dynamical theory of electron diffraction in crystals is developed using the approximation of nearly free electrons and Brillouin zones.The use of Brillouin zones in describing electron diffraction phenomena proves to be illuminating since the energy discontinuity at a zone boundary is a fundamental quantity determining the existence of a Bragg reflection. The perturbation of the energy levels at a corner of a Brillouin zone is briefly discussed and the manner in which forbidden reflections may arise at a corner pointed out. It is concluded that the kinematic theory is inadequate for interpreting electron images of crystalline films.An electrolytic method for preparing thin metal sections for electron microscopy and diffraction is introduced and its application to the structure of cold‐worked aluminum and an aluminum‐copper alloy demonstrated. It is concluded that cold‐worked aluminum initially consists of small, inhomogeneously strained and disoriented blocks about 200A in size. These blocks are n...