Electron backscatter diffraction

About: Electron backscatter diffraction is a research topic. Over the lifetime, 15184 publications have been published within this topic receiving 317847 citations. The topic is also known as: EBSD.

Comparison of Maraging Steel Micro- and Nanostructure Produced Conventionally and by Laser Additive Manufacturing.

Abstract: Maraging steels are used to produce tools by Additive Manufacturing (AM) methods such as Laser Metal Deposition (LMD) and Selective Laser Melting (SLM). Although it is well established that dense parts can be produced by AM, the influence of the AM process on the microstructure—in particular the content of retained and reversed austenite as well as the nanostructure, especially the precipitate density and chemistry, are not yet explored. Here, we study these features using microhardness measurements, Optical Microscopy, Electron Backscatter Diffraction (EBSD), Energy Dispersive Spectroscopy (EDS), and Atom Probe Tomography (APT) in the as-produced state and during ageing heat treatment. We find that due to microsegregation, retained austenite exists in the as-LMD- and as-SLM-produced states but not in the conventionally-produced material. The hardness in the as-LMD-produced state is higher than in the conventionally and SLM-produced materials, however, not in the uppermost layers. By APT, it is confirmed that this is due to early stages of precipitation induced by the cyclic re-heating upon further deposition—i.e., the intrinsic heat treatment associated with LMD. In the peak-aged state, which is reached after a similar time in all materials, the hardness of SLM- and LMD-produced material is slightly lower than in conventionally-produced material due to the presence of retained austenite and reversed austenite formed during ageing.

Convergent Beam Electron Diffraction

Abstract: Convergent beam electron diffraction (CBD) is a technique with a long history of gradual development which has recently become widely available through the development of commercial TEM/STEM electron microscopes. The technique was discovered by KOSSELL and MOLLENSTEDT (1939) who obtained some quite remarkably good results when one realizes that the size of focussed probe they were working with was comparatively large. Most specimens are so irregular that there would be considerably thickness variation within such areas producing a thickness average of the information. Further, few specimens are so flat that some important angular average will not occur over such areas. Thickness and orientation are two crucial parameters of electron diffraction and it is essential to eliminate their variation within the illuminated volume if meaningful results are to be obtained.

Fracture toughness of polycrystalline tungsten alloys

Abstract: Tungsten and tungsten alloys show the typical change in fracture behavior from brittle at low temperatures to ductile at high temperatures. In order to improve the understanding of the effect of microstructure the fracture toughness of pure tungsten, potassium doped tungsten, tungsten with 1 wt.% La 2 O 3 and tungsten rhenium alloys were investigated by means of 3-point bending, double cantilever beam and compact tension specimens. All these materials show the expected increase in fracture toughness with increasing temperature. The experiments demonstrate that grain size, texture, chemical composition, grain boundary segregation and dislocation density seem to have a large effect on fracture toughness below the DBTT. These influences can be seen in the fracture behavior and morphology, where two kinds of fracture occur: on the one hand transgranular and on the other hand intergranular fracture. Therefore, techniques like electron backscatter diffraction (EBSD), Auger electron spectroscopy (AES) and X-ray line profile analysis were used to improve the understanding of the parameters influencing fracture toughness.