Equal-cost multi-path routing

About: Equal-cost multi-path routing is a research topic. Over the lifetime, 10472 publications have been published within this topic receiving 249362 citations.

Increasing the network performance using multi-path routing mechanism with load balance

Abstract: Research on multi-path routing protocols to provide improved throughput and route resilience as compared with single-path routing has been explored in details in the context of wired networks. However, multi-path routing mechanisms have not been explored thoroughly in the domain of ad hoc networks. In this paper, we propose a new routing protocol which increases the network throughput. The protocol is a multi-path routing protocol with a load balance policy. The simulations show a significant improvement in terms of connection throughput and end-to-end delay, when compared to single-path routing. The second significant contribution of this paper is a theoretical analysis allowing to compare reactive single-path and multi-path routing with load balance mechanisms in ad hoc networks, in terms of overheads, traffic distribution and connection throughput. The results reveal that multi-path routing (using a load balance policy) provides better performance than reactive single-path routing in terms of congestion and connection throughput, provided that the average route length is smaller than certain upper bounds which are derived and depend on parameters specific to the network. These upper bounds are very crucial because they can be taken into account as constraints in the route discovery mechanism so that the multi-path routing protocol is guaranteed to lead to an increase performance than a simple single-path one. Also, our analysis provide some insight into choosing the right trade-off between increased overheads and better performance. We show in particular that for certain networks, a multi-path routing strategy is not worth considering.

Constraint-based routing between ingress-egress points in a packet network

Abstract: A packet network of interconnected nodes employs a constraint-based routing method to determine a path through the network for a requested label-switched path (LSP). Each of the nodes includes one or more routers that forward packets based on a forwarding table constructed from paths determined in accordance with the constraint-based routing method. The constraint-based method determines the path of the requested LSP based on the effect that routing those packets of the requested LSP may have on current and/or future demands on the capacity of network nodes for currently provisioned LSPs. Such constraint-based routing method may not necessarily route packets of a requested LSP along the shortest path, or minimum number of hops, through the network. Given the packet network and LSP request, a linear programming system is defined by a set of linear programming equations. The linear programming system is based on the network topology, the values of the ingress-egress point pair o and t and demand bd of the LSP request, and the total maxflow values of the existing ingress-egress point pair for currently provisioned LSPs. The solution is estimated for a linear programming system of either split demand, non-split demand, or batch demand implementations for routing packets of the LSP. The constraint-based routing method may solve the linear programming system using common linear programming techniques.

Deadlock-free routing and component placement for irregular mesh-based networks-on-chip

Abstract: Routing is one of the most crucial key factors which decides over the success of NoC architecture based systems or their failure. This paper uses well known principles from parallel computer architecture to develop a deadlock free highly adaptive routing algorithm for a 2D-mesh based network-on-chip (NoC) architecture including oversized IP cores. The paper consists of a short introduction into related routing theories and then gives a detailed description of the developed routing scheme. The last part is dedicated to a new floorplanning method, which allows to generate high density layouts suitable for the presented routing algorithm.

A theory of wormhole routing in parallel computers

Abstract: Virtually all theoretical work on message routing in parallel computers has dwelt on packet routing: messages are conveyed as packets, an entire packet can reside at a node of the network, and a packet is sent from the queue of one node to the queue of another node until its reaches its destination. The current trend in multicomputer architecture, however, is to use wormhole routing. In wormhole routing a message is transmitted as a contiguous stream of bits, physically occupying a sequence of nodes/edges in the network. Thus, a message resembles a worm burrowing through the network. The authors give theoretical analyses of simple wormhole routing algorithms, showing them to be nearly optimal for butterfly and mesh connected networks. The analysis requires initial random delays in injecting messages to the network. They report simulation results suggesting that the idea of random initial delays is not only useful for theoretical analysis but may actually improve the performance of wormhole routing algorithms. >

An analysis of 'hot-potato' routing in a fiber optic packet switched hypercube

Abstract: Two implementations of a fiber-optic packet-switched hypercube are proposed. In the first, each directed link is implemented with a fixed wavelength laser and photodetector, and all optical transmissions are wavelength multiplexed onto one or more fibers. In the second, the electronic crosspoint matrices within the nodes are eliminated by allowing each laser to be tunable over a range of log N wavelengths. Assume that a hot potato, or deflection, routing algorithm is used; as soon as a packet is received at a node, a routing decision is made and the packet is sent out. The node attempts to send the packet towards its destination. The analysis indicates that a hypercube, hot-potato routing offers essentially optimal performance for random traffic, regardless of how large the hypercube grows, and it significantly outperforms traditional shortest-path routing with buffering and flow control. A few variations, including an algorithm which gives priority to packets closer to their destinations and one which gives priority to various classes of traffic, are also proposed and analyzed. >