Topic
Fabrication
About: Fabrication is a research topic. Over the lifetime, 20475 publications have been published within this topic receiving 235676 citations.
Papers published on a yearly basis
Papers
More filters
81 citations
TL;DR: In this paper, the authors report on the fabrication and characterization of a highly sensitive temperature sensor by selectively filling the nematic liquid crystal (NLC) 6CHBT into a single void within the photonic crystal fiber (PCF) structure.
Abstract: We report on the fabrication and characterization of a highly sensitive temperature sensor by selectively filling the nematic liquid crystal (NLC) 6CHBT into a single void within the photonic crystal fiber (PCF) structure. The temperature response of the device is experimentally characterized, showing good linearity, repeatability, and sensitivity at around -3.90 nm/°C within the temperature range from 44°C to 53°C. The mode properties of the device are theoretically investigated, confirming the mode coupling principle and the temperature sensitivity of the device.
81 citations
TL;DR: In this paper, commercial desktop inkjet printers were used to deposit the active catalyst electrode layer directly from print cartridges onto Nafion ® polymer membranes in the hydrogen form and the layers were well-adhered and withstood simple tape peel, bending and abrasion tests.
80 citations
TL;DR: In this article , the authors used the dry etching process of tantalum (Ta) film to obtain transmon qubits with the best lifetime (T1) for multi-qubit fabrication.
Abstract: By using the dry etching process of tantalum (Ta) film, we had obtained transmon qubit with the best lifetime (T1) 503 us, suggesting that the dry etching process can be adopted in the following multi-qubit fabrication with Ta film. We also compared the relaxation and coherence times of transmons made with different materials (Ta, Nb and Al) with the same design and fabrication processes of Josephson junction, we found that samples prepared with Ta film had the best performance, followed by those with Al film and Nb film. We inferred that the reason for this difference was due to the different loss of oxide materials located at the metal-air interface.
80 citations
TL;DR: In this article, a mesoscale particle dynamics simulation is developed to relate the manufacturing process of a cathode containing Toda NCM-523 active material to physical and structural properties of the dried film.
80 citations