Topic
Friction stir processing
About: Friction stir processing is a research topic. Over the lifetime, 2977 publications have been published within this topic receiving 62158 citations.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, an analytical method of predicting the ballistic behavior of surface composites was developed based on energy balance, i.e., the initial energy of impact is same as that of energy absorbed by multi layers.
35 citations
TL;DR: In this article, the texture evolution in the near surface layer during friction stir processing of AZ31 magnesium alloy was studied, and it was shown that texture evolution influenced the grain structure development.
Abstract: Microstructure and texture evolution in the near-surface layer during friction stir processing (FSP) of AZ31 magnesium alloy was studied. Material flow was found to be a very complex process consisting of several stages. The material in front of the friction stir tool was first deformed by the rotating shoulder. Then, approaching the tool, it experienced a secondary deformation caused by the rotating pin, and finally, behind the tool, it again underwent a tertiary deformation induced by the shoulder. The texture evolution was shown to dictate the grain structure development.
35 citations
TL;DR: In this paper, a re-investigation has been done on the effect of the powder metallurgy process parameters on the physical and mechanical properties of Aluminium matrix composites.
35 citations
TL;DR: In this paper, the solid state structural modification technique friction-stir-processing (FSP) was applied on the surface of a laser-powder-bed-fusion fabricated AlSi10Mg alloy to locally modify the microstructure and enhance the corrosion properties of the alloy.
35 citations
TL;DR: In this paper, the effects of friction stir processing (FSP) and addition of 0.25% (mass ratio) Sc on the microstructure, mechanical properties, and damping capacity of AA 7055 alloy were investigated.
35 citations