scispace - formally typeset
Search or ask a question
Topic

Harmonic

About: Harmonic is a research topic. Over the lifetime, 44833 publications have been published within this topic receiving 495922 citations. The topic is also known as: overtone & partial.


Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, the authors considered a class of functions composed of waveforms that repeat nearly periodically, and for which the instantaneous frequency can be given a rigorous meaning, and they showed that Synchrosqueezing can be used to determine instantaneous frequency of functions in this class, even if the waveform is not harmonic, thus generalizing earlier results for cosine wave functions.

106 citations

Journal ArticleDOI
TL;DR: It is shown that SVM provides a number of degrees of freedom, which make it suitable for optimization, subject to desired constraints, and a genetic algorithm optimizer is used to solve the optimization problem.
Abstract: This paper proposes a method for optimization of the harmonic performance of converters under space vector modulation (SVM) control. It is shown that SVM provides a number of degrees of freedom, which make it suitable for optimization, subject to desired constraints. An objective function is defined, which seeks to minimize the most significant harmonic components of the generated waveform while keeping other harmonic components within the acceptable range outlined in the available standards. Since the formulation of the problem involves both real and integer variables, specialized optimization methods capable of handling mixed-integer variables need to be employed, and hence, a genetic algorithm optimizer is used to solve the optimization problem. Optimized SVM sequences obtained for various operating points under different sampling frequencies are shown to result in significant reduction of dominant harmonics while maintaining the waveform quality within prescribed limits.

106 citations

Journal ArticleDOI
TL;DR: In this article, the scaling laws for the main physical quantities of high harmonic generation were discussed and the limiting effects of dephasing, absorption and plasma defocusing were analyzed, and it was shown that phase-matched and absorption-limited high-order harmonics can be achieved even for very small focal spot sizes using a target gas provided with an adequately high density.
Abstract: High harmonic generation (HHG) at a high repetition rate requires tight focusing of the moderate peak power driving pulses. So far the conversion efficiencies that have been achieved in this regime are orders of magnitude behind the values that have been demonstrated with loose focusing of high energy (high peak power) lasers. In this contribution, we discuss the scaling laws for the main physical quantities of HHG and in particular analyze the limiting effects: dephasing, absorption and plasma defocusing. It turns out that phase-matched and absorption-limited HHG can be achieved even for very small focal spot sizes using a target gas provided with an adequately high density. Experimentally, we investigate HHG in a gas jet of argon, krypton and xenon. By analyzing the pressure dependence we are able to disentangle the dephasing and absorption effects and prove that the generated high order harmonics are phase-matched and absorption-limited. The obtained conversion efficiency is as high as 8 × 10−6 for the 17th harmonic generated in xenon and 1.4 × 10−6 for the 27th harmonic generated in argon. Our findings pave the way for highly efficient harmonic generation at megahertz repetition rates.

106 citations

Journal ArticleDOI
TL;DR: With minimal modifications, the logic developed for the HIF detection can be applied to low impedance fault detection and the need of installing separate devices for HIF and LIF Detection can be eliminated.
Abstract: An integrated high impedance fault (HIF) and low impedance fault (LIF) detection method is proposed in his paper. For a HIF detection, the proposed technique is based on a number of characteristics of the HIF current. These characteristics are: fault current magnitude; magnitude of the 3rd harmonic current; magnitude of the 5th harmonic current; the angle of the third harmonic current; the angle difference between the third harmonics current and the fundamental voltage; and the negative sequence current of HIF. These characteristics are identified by modeling the distribution feeders in EMTP. Apart from these characteristics, the above ambient (average) negative sequence current is also considered. An adjustable block out region around the average load current is provided. The average load current is calculated at every 18000 cycles (5 minutes) interval. This adaptive feature will not only make the proposed scheme more sensitive to low fault current, but it will also prevent the relay from tripping during the normal load current. In this paper, the logic circuit required for implementing the proposed HIF detection method is also included. With minimal modifications, the logic developed for the HIF detection can be applied to low impedance fault detection. A complete logic circuit which detects both the HIF and LIF is proposed. Using this combined logic, the need of installing separate devices for HIF and LIF detection can be eliminated. >

106 citations

Journal ArticleDOI
TL;DR: Numerical simulations in comparison with experimental data using the Harmonic Drive Test Apparatus verify the accuracy of the proposed model to represent the complex hysteresis dynamics of harmonic drives.
Abstract: In this paper, we propose a new dynamic model to describe the hysteresis phenomenon in harmonic drives. The experimental observation of the dynamic torque-displacement relationship for a harmonic drive shows a hysteresis characteristic indicating the simultaneous presence of energy storage and energy dissipation mechanisms. To completely characterize these mechanisms and yet have a simple representation for control, we develop a new hysteresis model using the heredity concept of dynamic systems. This model represents the hysteresis phenomenon by a combination of a nonlinear stiffness component and a nonlinear damping component leading to a mathematically well-posed nonlinear differential equation. The parameters of the model are identified using optimization techniques. We present some important mathematical properties of the model that give insight into model behavior and thus establish a mathematical basis for control. Numerical simulations in comparison with experimental data using our Harmonic Drive Test Apparatus verify the accuracy of the proposed model to represent the complex hysteresis dynamics of harmonic drives.

106 citations


Network Information
Related Topics (5)
Nonlinear system
208.1K papers, 4M citations
86% related
Voltage
296.3K papers, 1.7M citations
85% related
Boundary value problem
145.3K papers, 2.7M citations
81% related
Matrix (mathematics)
105.5K papers, 1.9M citations
79% related
Magnetic field
167.5K papers, 2.3M citations
79% related
Performance
Metrics
No. of papers in the topic in previous years
YearPapers
20231,223
20222,724
20211,878
20202,330
20192,612
20182,495