Helicopter rotor

About: Helicopter rotor is a research topic. Over the lifetime, 7201 publications have been published within this topic receiving 77045 citations. The topic is also known as: rotor blades & Rotor.

Review of morphing concepts and materials for wind turbine blade applications

Abstract: With increasing size of wind turbines, new approaches to load control are required to reduce the stresses in blades. Experimental and numerical studies in the fields of helicopter and wind turbine blade research have shown the potential of shape morphing in reducing blade loads. However, because of the large size of modern wind turbine blades, more similarities can be found with wing morphing research than with helicopter blades. Morphing technologies are currently receiving significant interest from the wind turbine community because of their potential high aerodynamic efficiency, simple construction and low weight. However, for actuator forces to be kept low, a compliant structure is needed. This is in apparent contradiction to the requirement for the blade to be load carrying and stiff. This highlights the key challenge for morphing structures in replacing the stiff and strong design of current blades with more compliant structures. Although not comprehensive, this review gives a concise list of the most relevant concepts for morphing structures and materials that achieve compliant shape adaptation for wind turbine blades.

Theory of self-excited mechanical oscillations of helicopter rotors with hinged blades

Abstract: Vibrations of rotary-wing aircraft may derive their energy from the rotation of the rotor rather than from the air forces. A theoretical analysis of these vibrations is described and methods for its application are explained in Chapter one. Chapter two reports the results of an investigation of the mechanical stability of a rotor having two vertically hinged blades mounted upon symmetrical supports, that is, of equal stiffness and mass in all horizontal directions. Chapter three presents the theory of ground vibrations of a two-blade helicopter rotor on anisotropic flexible supports.

A framework for CFD analysis of helicopter rotors in hover and forward flight

Abstract: A framework is described and demonstrated for CFD analysis of helicopter rotors in hover and forward flight. Starting from the Navier–Stokes equations, the paper describes the periodic rotor blade motions required to trim the rotor in forward flight (blade flapping, blade lead-lag and blade pitching) as well as the required mesh deformation. Throughout, the rotor blades are assumed to be rigid and the rotor to be fully articulated with separate hinges for each blade. The employed method allows for rotors with different numbers of blades and with various rotor hub layouts to be analysed. This method is then combined with a novel grid deformation strategy which preserves the quality of multi-block structured, body-fitted grids around the blades. The coupling of the CFD method with a rotor trimming approach is also described and implemented. The complete framework is validated for hovering and forward flying rotors and comparisons are made against available experimental data. Finally, suggestions for further development are put forward. For all cases, results were in good agreement with experiments and rapid convergence has been obtained. Comparisons between the present grid deformation method and transfinite interpolation were made highlighting the advantages of the current approach. Copyright © 2006 John Wiley & Sons, Ltd.